Search

Kenaf cellulose fiber was extracted from kenaf locally grown in Thailand as a potential local renewable resource for the cellulose fiber. In this study, the biodegradable polymer composites, poly(butylene succinate) (PBS)/cellulose fiber composites with different types of cellulose were prepared. The kenaf fiber treated with hydrochloric acid (KTH), extracted cellulose fiber (EC), and commercial cellulose fiber (CC) were selected as alternative renewable fillers in the PBS (the biodegradable polymer). Regarding the fiber characteristics, the aspect ratio of the EC (11.5) was found to be higher than that of the CC (6.1). In a similar manner, the EC contained 65.9% crystallinity, which was higher than that of the CC (37.0%) and the KTH (58.9%). Moreover, the EC exhibited higher thermal stability (Td[Max] = 362.9°C) than the CC (Td[Max] = 302.0°C) and the KTH (Td[Max] = 353.8°C). For PBS/cellulose fiber composites, the rheological, tensile, and thermal properties were studied. The rheology results revealed that the addition of the fiber changed the PBS microstructure. The EC fiber dispersion in the PBS seemed to be better than the others; however, the KTH fiber dispersion was poor. The addition of the fiber raised the elastic moduli of the composites by 5‐26%; however, it reduced the tensile strengths (by 14‐53%) and the decomposition temperatures (by 1‐2%). Furthermore, the addition of the fiber slightly affected the crystallization temperatures and melting temperatures of the composites. The yellowness and whiteness of the composites were marginally reduced. The composite with the EC fiber showed a significant improvement in the elastic modulus as compared to the composite with the CC fiber, while the tensile strength and the strain at maximum stress were comparable. Thus, according to the rheological, thermal, and tensile properties of the composites, the EC fiber showed a possibility of using as an alternative reinforcement material from a local renewable resource. [ABSTRACT FROM AUTHOR]

Developing an optimum pretreatment condition to enhance glucose recovery assessed the potential of Chloris barbata, which is a common invasive weed in Thailand, as a feedstock for bioethanol production. Chloris barbata was exposed to autoclave-assisted alkaline pretreatment by using different sodium hydroxide (NaOH) concentrations (1% to 4%) and heat intensities (110 °C to 130 °C) that were dissipated from autoclaving. The optimum condition for pretreatment was determined to be 2% NaOH at 110 °C for 60 min. At this condition, maximum hydrolysis efficiency (90.0%) and glucose recovery (30.7%), as compared to those of raw C. barbata (15.15% and 6.20%, respectively), were observed. Evaluation of glucose production from 1000 g of C. barbata based on material balance analysis revealed an estimated yield of 304 g after pretreatment at the optimum condition when compared to that of raw C. barbata (61 g), an increase of five-fold. Structural analysis by the scanning electron microscopy (SEM) and X-ray diffraction (XRD) revealed the disruption of the intact structure of C. barbata and an increase in the cellulose crystallinity index (CrI), respectively. The results from this study demonstrate the efficiency of using C. barbata as a potential feedstock for bioethanol production. [ABSTRACT FROM AUTHOR]

The grasses in Thailand were analyzed for the potentiality as the alternative energy crops for cellulosic ethanol production by biological process. The average percentage composition of cellulose, hemicellulose, and lignin in the samples of 18 types of grasses from various provinces was determined as 31.85-38.51, 31.13-42.61, and 3.10-5.64, respectively. The samples were initially pretreated with alkaline peroxide followed by enzymatic hydrolysis to investigate the enzymatic saccharification. The total reducing sugars in most grasses ranging from 500-600 mg/g grasses (70-80% yield) were obtained. Subsequently, 11 types of grasses were selected as feedstocks for the ethanol production by simultaneous saccharification and cofermentation (SSCF). The enzymes, cellulase and xylanase, were utilized for hydrolysis and the yeasts, Saccharomyces cerevisiae and Pichia stipitis, were applied for cofermentation at 35 °C for 7 days. From the results, the highest yield of ethanol, 1.14 g/L or 0.14 g/g substrate equivalent to 32.72% of the theoretical values was obtained from Sri Lanka ecotype vetiver grass. When the yields of dry matter were included in the calculations, Sri Lanka ecotype vetiver grass gave the yield of ethanol at 1,091.84 L/ha/year, whereas the leaves of dwarf napier grass showed the maximum yield of 2,720.55 L/ha/year (0.98 g/L or 0.12 g/g substrate equivalent to 30.60% of the theoretical values).