Search

In this paper, the structural stability and compressive capacity of pin-ended cold-formed stainless steel angle columns with different slenderness were experimentally investigated. The experimental programme was performed on press-braked lean duplex stainless steel equal-leg angle sections with nominal dimensions of 80 × 80 × 4 mm, and involved material testing, initial imperfection measurements and 11 column tests. The test setup and procedure, together with the key experimental results, axial load vs. lateral deflections, axial load vs. torsional rotations and characterised failure modes, were fully reported and analysed. The experimental observations reveal that the failure mode type, including local/torsional, flexural-torsional and flexural effects, is highly dependent on the column's slenderness and initial imperfections. The measured compressive strengths were compared with the resistance predictions determined according to European and Australia/New Zealand codified design procedures. It was found that experimentally obtained ultimate capacities are significantly higher than those calculated according to the specifications. However, the database of test results is still quite limited, and a further research is needed to amplify the data needed to enable a more precise assessment of the codified procedures. • Eleven pin-ended cold-formed stainless steel equal-leg angle columns were tested. • Different buckling failure modes were systematically investigated. • Failure loads conservatively predicted by European and Australian design procedures. [ABSTRACT FROM AUTHOR]