Search

Energy harvesting technologies are attracting attention because they remove power supply lines and charging. However, energy harvesting has many problems such as small power generation and instability, and low output voltage. As a step toward putting this attractive technology to practical use, I have developed a CMOS temperature sensor with on‐chip photovoltaic cells. The photovoltaic cells achieved an open circuit voltage of 0.97 V, a short‐circuit current of 8.0 μA, and a maximum power generation of 6.5 μW in an area of 800 μm square. Experiments have shown that the prototype CMOS temperature sensor can operate without external power supply. © 2022 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

A simple and fast diagnostic method for multiple open‐circuit faults in voltage‐source inverters based on the current vector phase is proposed. The characteristics of the current vector phase in both healthy and faulty conditions are analyzed in detail, and simple fault symptom variables are defined to extract the features for fault isolation. The proposed method can diagnose 21 types of open‐circuit faults only by using current vector phase information, and it is fast, robust and easy to implement in existing systems without additional sensors. Several experimental results verify that the diagnostic algorithm has no false alarms under speed and load transient conditions, and the fault can be isolated within 15% of the current fundamental cycle in the case of the fastest diagnostic process and no more than 80% of the current cycle in the worst cases. © 2021 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

Monascus pigments (MPs) as natural food pigments which have been extensively used in food industries, specifically in China, Japan, and other countries of southeastern Asian. The optoelectronic properties of the MPs with polycyclic aromatic hydrocarbons (PAHs) units have been investigated by using density functional theory (DFT) and time-dependent (TDDFT) at B3LYP and the 6-31G(d) basis set. These properties include total energies, Fermi energy, work function, orbital distributions (HOMO, LUMO), the HOMO-LUMO gap, the maximum open circuit voltage, maximum wavelength absorption, electronic transition energies, and the oscillator strengths. These methods and calculation procedures not only encourage a profound understanding of the association between the optoelectronic properties and chemical structures of the molecules but also can be utilized to design new molecule structures. We investigated the influence of the PAHs into the MPs and studied the optoelectronic properties on all molecules. The results showed that the maximum absorption wavelengths for MPs-PAHs are within the visible light region. Therefore, these molecules provide good performance for the photovoltaic devices and solar cells applications. Our results showed that the total energy increase after addition of PAHs for MPs, this illustration that the molecules converted to more stability. The addition of PAHs can enhance HOMO, LUMO level which can upsurge reduce bandgap energy and also the faculty of electron injection. Where the bandgap energy lies in the range (2.242–3.012) eV. The λmax takes the values from 378.84 nm to 681.03 nm, where the lowest value for Ms. (S3) and highest for the Ms. (S1), where Ms. (S1) represents firsa t singlet excited state that is at about 681.03 nm but with a feeble absorption. We observed that the sturdy absorption peaks (Ms (S2), Ms-fluorene (S3), Ms-naphthalene (S3), and Ms-anthracene (S3)) are within the visible light region. These results of the dyes confirmation that these dyes are possible to be a perfect photosensitizer in solar cells. Unlabelled Image • The studying electronic and optical properties of Monascus pigments (MPs) as dye sensitive for using in solar cells and photovoltaic device. • Studying of the effective the addition of PAHs for Monascus pigments. • The addition of PAHs gives better performance. • Maximum wavelength lies in visible light region. [ABSTRACT FROM AUTHOR]