Search

The Virgo gravitational wave detector is an interferometer (ITF) with 3 km arms located in Pisa, Italy. From July to October 2010, Virgo performed its third science run (VSR3) in coincidence with the LIGO detectors. Despite several techniques adopted to isolate the ITF from the environment, seismic noise remains an important issue for Virgo. Vibrations produced by the detector infrastructure (such as air conditioning units, water chillers/heaters, pumps) are found to affect Virgo's sensitivity, with the main coupling mechanisms being through beam jitter and scattered light processes. The Advanced Virgo design seeks to reduce ITF couplings to environmental noise by having most vibrationsensitive components suspended and in vacuum, as well as muffle and relocate loud machines. During the months of June and July in 2010, a Güralp-3TD seismometer was stationed at various locations around the Virgo site hosting major infrastructure machines. Seismic data were examined using spectral and coherence analysis with seismic probes close to the detector. The primary aim of this study was to identify noisy machines which seismically affect the ITF environment and thus require mitigation attention. Analyzed machines are located at various distances from the experimental halls, ranging from 10 to 100 m. An attempt is made to measure the attenuation of emitted noise at the ITF and correlate it with the distance from the source and with seismic attenuation models in soil. [ABSTRACT FROM AUTHOR]

The Virgo experiment, located near Pisa, Italy, is a large laser Michelson interferometer aiming at the first direct detection of gravitational waves. The interferometer monitors the relative distance of its mirrors placed at the ends of two 3 km-long perpendicular arms. The goal is to measure spectral differential variations of the arm lengths of 10-18 m/Hz1/2 in the frequency range from 10 Hz to 10 kHz. Avoiding spurious motions of the optical components is therefore essential to detect gravitational waves. Since the ground motion is 9 orders of magnitude larger than the arm length variations induced by gravitational waves, the seismic noise is the dominant low frequency noise source for terrestrial gravitational wave interferometers. The seismic isolation is obtained suspending the mirrors by an 8-meter tall chain of cascaded mechanical filters, called "Superattenuator" (SA). The Superattenuator is a passive device acting as a low pass filter in all six degrees of freedom, capable of attenuating the ground motion by more than 10 orders of magnitude, starting from a few Hz. To further reduce the seismic disturbances, the filter chain is suspended from an actively stabilized platform that compensates for low frequency and large amplitude oscillations caused by the mechanical resonances of the chain. In this article we describe the Superattenuator together with its control system, and we report about its performance. [ABSTRACT FROM AUTHOR]