Search

• Mineralogy and geophysics used to describe depositional sequences of Guadiana Basin. • Illite, smectite + palygorskite and kaolinite enrichment image 3 depositional sequences. • Depositional sequences exhibit distinct electric resistivity imaging. • Data integration unravels Guadiana Basin formation and the role of Alpine tectonics. In the Iberian Peninsula, Alpine tectonics built several Cenozoic basins that were mainly filled with continental deposits. The Guadiana Basin is located halfway between two of the most important Cenozoic basins of the SW of Spain, the Tajo and the Guadalquivir basins. In this paper, both geophysical and mineralogical studies have been carried out in order to establish the lithostratigraphy of the Guadiana basin. A combination of electric resistivity properties and variations in clay mineral assemblage content of the basin infill was used to identify several depositional sequences within the Cenozoic deposits of the basin. Three depositional sequences, DS1, DS2 and DS3 characterized by differentiated clay content and mineral assemblages were distinguished. The lower depositional sequence, DS1, consists of reddish siltstones and clays that scarcely crop out in the basin. Clay content of the <2 μm fraction is dominated by illite averaging 60% of the total clay content, with kaolinite and a few amount of smectite. DS2 deposits lie unconformably over DS1 and the Variscan basement and consist of a siliciclastic succession where carbonate units occur at bottom and at the top of the depositional sequence. Smectite dominates throughout the entire succession except in the basal carbonate unit where up to 70% of palygorskite is found. In the younger sequence DS3, kaolinite is the dominant clay mineral. Electrical resistivity imaging helped in the physical characterization and horizontal and vertical distribution of each unit and provided good insight on the structure of the Guadiana Basin, allowing to infer the basin structure due to high resistivity contrast between the basement and the sedimentary rocks. In addition, in areas where the lower sedimentary units do not crop out, and borehole information is not available, the geophysical response of the resistivity units imaged can be used to infer the corresponding depositional sequence. The joint interpretation of the clay mineral assemblages and geophysical properties of the sedimentary units showed to be a useful tool to gather a reliable identification of depositional sequences in basins characterized by scarcity of good outcrops, lack of borehole information and similarity of sedimentary rocks. This is very important to properly correlate the different sedimentary units mapped as well as to infer the basin structure and its evolution through time. [ABSTRACT FROM AUTHOR]

The low frequency of large destructive earthquakes in the Eastern Betics (SE Iberian Peninsula), not recorded in the instrumental seismic catalog, complicate the estimation of the maximum ground motion that could be reached. Knowing the characteristics and behavior of these large seismic ruptures is crucial for the study of seismic hazard. In this work, we have used a physics-based earthquake simulator to generate a 100 kyr catalog of seismic ruptures associated with seismogenic faults bordering the quaternary Guadalentin and Bajo Segura basins. From these ruptures, we have selected maximum earthquake scenarios, and those associated with certain probabilities of exceeding a severe magnitude from the synthetic catalog. The estimation of maximum peak accelerations (PGA) by means of ground motion prediction equations include a possible site amplification that we have calculated from a detailed geotechnical classification of soils. According to the simulations, the modeled faults have the capacity to generate maximum earthquakes with magnitudes ranging M W 6.7–7.4. Densely populated urban areas located along the Guadalentin valley, such as Lorca, could be subject to site-dependent PGA values close to 0.6 g on the Alhama de Murcia fault trace. Similar ground motion would affect the coastline of SE Alicante province when evaluating the maximum simulated event in the Bajo Segura offshore fault. But already from magnitudes around M W ∼ 6, PGA estimations exceed critical values of 0.5 g at the south side of the Bajo Segura basin and the city of Murcia, highly dependent of ground-motion amplification induced by thick deposits of very soft and saturated soils. Our scenarios reflect that other factors such as fault geometry, kinematics and the capability observed in the simulations to generate multi-fault ruptures also affect the spatial distribution of maximum ground motion in this region. We expect that this evaluation could contribute as an improvement guideline for future strong motion prediction studies prior to the settlement of new urban infrastructures in the Eastern Betics. • Physics-based simulations for a long-term catalog of large complex seismic ruptures. • Deterministic analysis of ground motion scenarios at the Eastern Betics. • Geotechnical classification of soils to include site amplification in hazard analysis. • Big earthquakes and soft soils may rise seismic threat in populated zones of SE Spain. [ABSTRACT FROM AUTHOR]