Search

Continental collision zones are structurally one of the most heterogeneous areas intermixing various different units within a relatively small space. A good example of this is the Dinarides, a mountain chain situated in the central Mediterranean, where thick carbonates cover older crystalline basement units and remnants of subducted oceanic crust. This is further complicated by the highly variable crustal thickness ranging from 20 to almost 50 km. In terms of spatial extension, this area is relatively small but covers tectonically differentiated domains making, any seismic or geological analysis complex, with significant challenges in areas that lack seismic information on crustal structure. Presently there is no comprehensive 3D crustal model of the Dinarides (and surrounding areas). Using the compilations of previous studies and employing kriging interpolation, we created a vertically and laterally varying crustal model defined on a regular grid for the wider area of the Dinarides, also covering parts of Adriatic Sea and the SW part of the Pannonian Basin. The model is divided by three interfaces, Neogene deposit bottom, carbonate rock complex bottom and Moho discontinuity, with seismic velocities (P and S waves) and density defined at each grid point. To validate the newly derived model, we calculated travel times for an earthquake recorded on several seismic stations in the Dinarides area. The calculated travel times show significant improvement when compared to the simple 1D model used for routine earthquake location in Croatia. The model derived in this work represents the first step towards improving our knowledge of the crustal structure in the complex area of the Dinarides. We hope that the newly assembled model will be useful for all forthcoming studies (e.g., as a starting model for seismic tomography, as a model for earthquake simulations) which require knowledge of the crustal structure. [ABSTRACT FROM AUTHOR]

In this work, we assess ground shaking in the wider Zagreb area by computing simulated seismograms at regional distances. For the purposes of the simulations, we assemble the 3D velocity and density model and test its performance. First, we compare the low-frequency simulations obtained using deterministic method for both new 3D model and a simple 1D model. We then continue the performance test by computing the full broadband seismograms. To do that, we apply the hybrid technique in which the low frequency (f < 1 Hz) and high frequency (f = 1–10 Hz) seismograms are obtained separately using deterministic and stochastic method, respectively, and then reconciled into a single time series. We apply this method to the MW = 5.3 event and four smaller (3.0 < MW < 5.0) events that occurred in the studied region. We compare simulated data with the recorded seismograms and validate our results by calculating the goodness of fit score for peak ground velocity and shaking duration. Next, to improve the understanding of the strong ground motion in this area, we simulate seismic shaking scenarios for the 1880, MW = 6.2 earthquake. From computed low-frequency waveforms, we generate shakemaps and compare the ground-motion features of the two possible sources of this event, Kašina fault and North Medvednica fault. We conduct a preliminary study to determine which fault is a more probable source of the 1880 historic event by comparing the peak ground velocities and Arias intensity with the observed intensities. [ABSTRACT FROM AUTHOR]

Broad-band seismograms of teleseismic events recorded at the Croatian Seismological Network were used to compute radial receiver functions (RFs) for eight locations in the External Dinarides. Waveform modelling was performed by a multistep matching of the theoretical RFs computed for horizontally layered 1-D isotropic models with the averaged observed RFs. Constraints from existing deep seismic sounding profiles, traveltime curves of regional crustal seismic phases and intuitive inferences gained from interactive forward modelling were used to construct initial 1-D models of the Earth. A non-linear inversion was performed in two steps-a grid search followed by the Monte Carlo search for the model parameters. Concurrently, RFs from different azimuths were stacked to obtain trade-off estimates of crustal thickness versus V/ V ratios. The Moho depths were found in the range from around 40 km for Northern Adriatic stations to over 55 km for stations in the central part of the External Dinarides. Comparing our results with recent maps of the Moho topography inferred from seismic and gravimetric data, we find that for some stations the agreement between our results and the existing Moho maps is very good. For the others, we find the Mohorovičić discontinuity to be considerably deeper, indicating some of the thickest crust in Europe. Although it is plausible that such a deep Moho could be a consequence of a complex tectonic setting of the region (e.g. overlapping of two large tectonic units-the Adriatic microplate and the Dinarides), this result will have to be verified in the future studies using various other geophysical techniques. [ABSTRACT FROM AUTHOR]

During the ten-year period from 2006 to 2015 a total of 36 733 earthquakes were located in Croatia and its surrounding areas, with 37 main events registering magnitudes from 4.0 to 4.9. Seismically the most active was the coastal part of Croatia confined to two seismically distinguished areas. The NW domain was seismically less active, with almost 10 000 located events (seven were of magnitude ML ≥ 4.0), among which were the three strongest events that occurred in Croatia during the observed period. Two of them occurred in the Senj epicentral area, the first one on 5 February 2007 at 8:30 UTC (ML = 4.9, Imax = VII °MSK) and the second one on 30 July 2013 at 12:58 UTC, (ML = 4.8, Imax = VI °MSK). The third event occurred near Kornati Islands on 18 July 2007 at 10:54 UTC (ML = 4.8). The SE domain experienced the highest number of earthquakes (over 19 000 located events, with 24 events of magnitude ML ≥ 4.0, among which the strongest one was of magnitude ML = 4.9 with the epicentre in Bosnia and Herzegovina near the Croatian border). The seismicity in the continental part of Croatia was weak-to-moderate, with earthquakes of magnitudes ML ≤ 4.1. Focal mechanisms were obtained for 31 earthquakes with magnitudes ML ≥ 4.0, and individual earthquakes have also been macroseismically analysed. Low current moment release rates for both regions (continental and coastal) as compared to long-term averages, indicate the regions are currently in the strain accumulation phase. [ABSTRACT FROM AUTHOR]