Search

Two commonly encountered saprolitic soils in Hong Kong, weathered volcanic tuff (WT) and weathered granite (WG), were studied using high-quality intact samples. The intact samples exhibited quasi-preconsolidation pressure or yield stress under isotropic compression due to their bonded structures, but the yield was progressive and not abrupt. As the stress increased, significant volumetric changes were measured. These changes resembled clay-type behavior. The soils also exhibited anisotropic deformation under isotropic loading and unloading, which was associated with the features of their parent rocks. During the drained tests, shearing at the in situ stress-state produced peak strength and volumetric dilation. Undrained shearing showed complicated stress paths and dilatancy behavior in these soils. Phase transformation states and dilative shear failure were readily seen, which resembles typical sand-type behavior. Distinct shear band(s) appeared in the WT specimens during shearing, whereas a bulging type of failure appeared in the WG specimens. The soils ultimately approached the corresponding state guided by a unique critical state line, regardless of their complex initial states in relation to the bonded structure and drainage conditions. [ABSTRACT FROM AUTHOR]

This article presents results from a series of K o -consolidated compression and extension triaxial tests on specimens from undisturbed samples of Hong Kong Marine Deposits (HKMD). To investigate the strain-rate effects, a total of seven K o -consolidated triaxial tests were conducted including four compression tests and three extension tests. After K o -consolidation, the triaxial test specimens were sheared at step-changed axial strain rates under three different confining pressures of 50 kPa, 150 kPa, and 400 kPa, respectively. The step-changed strain rates were applied in the following order: +2%/h, +0.2%/h, +20%/h, -2%/h (unloading) and +2%/h (reloading) for the four compression tests and -2%/h, -0.2%/h, -20%/h, +2%/h (unloading) and -2%/h (reloading) for the three extension tests. The results are reported and analyzed in the paper. The results show that the strain rate effects, the stress-strain characteristics, and the effective stress paths of the specimens for tests in a compression state are different from those for tests in an extension stage. One order of magnitude increase in axial strain rate causes an average 8.6% increase in undrained shear strength for compression tests and a 12.1% increase for extension tests. It is also found that the failure mode of the specimens in compression is different from that in extension. The stress-strain behavior of specimens shows strain-softening and a clear shear band in compression tests, but strain-hardening without any clear shear band in extension tests for the same absolute value of axial strain. [ABSTRACT FROM AUTHOR]