Search

Methane is the second most important anthropogenic greenhouse gas in the Earth's atmosphere. To effectively reduce these emissions, a good knowledge of source locations and strengths is required. Airborne remote sensing instruments such as the Airborne Visible InfraRed Imaging Spectrometer – Next Generation (AVIRIS-NG) with meter-scale imaging capabilities are able to yield information about the locations and magnitudes of methane sources. In this study, we successfully applied the weighting function modified differential optical absorption spectroscopy (WFM-DOAS) algorithm to AVIRIS-NG data measured in Canada and the Four Corners region. The WFM-DOAS retrieval is conceptually located between the statistical matched filter (MF) and the optimal-estimation-based iterative maximum a posteriori DOAS (IMAP-DOAS) retrieval algorithm, both of which were already applied successfully to AVIRIS-NG data. The WFM-DOAS algorithm is based on a first order Taylor series approximation of the Lambert–Beer law using only one precalculated radiative transfer calculation per scene. This yields the fast quantitative processing of large data sets. We detected several methane plumes in the AVIRIS-NG images recorded during the Arctic-Boreal Vulnerability Experiment (ABoVE) Airborne Campaign and successfully retrieved a coal mine ventilation shaft plume observed during the Four Corners measurement campaign. The comparison between IMAP-DOAS, MF, and WFM-DOAS showed good agreement for the coal mine ventilation shaft plume. An additional comparison between MF and WFM-DOAS for a subset of plumes showed good agreement for one plume and some differences for the others. For five plumes, the emissions were estimated using a simple cross-sectional flux method. The retrieved fluxes originated from well pads, cold vents, and a coal mine ventilation shaft and ranged between (155 ± 71) kg (CH 4) h -1 and (1220 ± 450) kg (CH 4) h -1. The wind velocity was a significant source of uncertainty in all plumes, followed by the single pixel retrieval noise and the uncertainty due to atmospheric variability. The noise of the retrieved CH 4 imagery over bright surfaces (>1 µ W cm -2 nm -1 sr -1 at 2140 nm) was typically ±2.3 % of the background total column of CH 4 when fitting strong absorption lines around 2300 nm but could reach over ±5 % for darker surfaces (< 0.3 µ W cm -2 nm -1 sr -1 at 2140 nm). Additionally, a worst case large-scale bias due to the assumptions made in the WFM-DOAS retrieval was estimated to be ±5.4 %. Radiance and fit quality filters were implemented to exclude the most uncertain results from further analysis mostly due to either dark surfaces or surfaces where the surface spectral reflection structures are similar to CH 4 absorption features at the spectral resolution of the AVIRIS-NG instrument. [ABSTRACT FROM AUTHOR]

Methane is the second most important anthropogenic greenhouse gas in the Earth's atmosphere. Reducing methane emissions is consequently an important element in limiting the global temperature increase below 2°C compared to preindustrial times. Therefore, a good knowledge of source strengths and source locations is required. Anthropogenic methane emissions often originate from point sources or small areal sources, such as fugitive emissions at oil and gas production sites or landfills. Airborne remote sensing instruments such as the Airborne Visible InfraRed Imaging Spectrometer - Next Generation (AVIRIS-NG) with meter scale imaging capabilities are able to yield information about the locations and magnitudes of methane sources, especially in areas with many potential emission sources. To extract methane column enhancement information from spectra recorded with the AVIRIS-NG instrument, different retrieval algorithms have been used, e.g. the matched filter (MF) or the Iterative Maximum A Posteriori DOAS (IMAP-DOAS) retrieval. The WFM-DOAS algorithm, successfully applied to AVIRIS-NG data in this study, fills a gap between those retrieval approaches by being a fast, non-iterative algorithm based on a first order approximation of the Lambert-Beer law, which calculates the change in gas concentrations from deviations from one background radiative transfer calculation using precalculated weighting functions specific to the state of the atmosphere during the overflight. This allows the fast quantitative processing of large data sets. Although developed for high spectral resolution measurements from satellite instruments such as SCIAMACHY, TROPOMI and the MAMAP airborne sensor, the algorithm can be applied well to lower spectral resolution AVIRIS-NG measurements. The data set examined here was recorded in Canada over different gas and coal extraction sites as part of the larger Arctic Boreal Vulnerability Experiment (ABoVE) Airborne Campaign in 2017. The noise of the retrieved CH4 imagery over bright surfaces (1μWcm-2nm-1sr-1 at 2140nm) was typically ±2.3% of the background total column of CH4 when fitting strong absorption lines around 2300nm, but could reach over ±5% for darker surfaces (<0.3μWcm-2nm-1sr -1 at 2140nm). Additionally, a worst case large scale bias due to the assumptions made in the WFM-DOAS retrieval was estimated to be ±5.4%. Radiance and fit quality filters were implemented to exclude the most uncertain results from further analysis, mostly due to either dark surfaces or surfaces, where the surface spectral reflection structures are similar to CH4 absorption features at the spectral resolution of the AVIRIS-NG instrument. We detected several methane plumes in the AVIRIS-NG images recorded during the ABoVE Airborne Campaign. For four of those plumes, the emissions were estimated using a simple cross sectional flux method. The retrieved fluxes originated from well pads and cold vents and ranged between (89±46)kg (CH4)h-1 and (141±87)kg (CH4) h-1. The wind uncertainty was a significant source of uncertainty for all plumes, followed by the single pixel retrieval noise and the uncertainty due to atmospheric variability. For one plume the wind was too low to estimate a trustworthy emission rate, although a plume was visible. [ABSTRACT FROM AUTHOR]