• The topic of waste heat was mentioned in this report, as it represents an important learning. Waste heat issue and audit finding will be addressed in a subsequent publication. To provide clarity to the reader with regards to what data/information was used to write this manuscript, the title of manuscript was revised to "Quest Carbon Capture and Storage Offset Project: findings and learnings from 1 st reporting period". • Replaced "Shell is submitting the serialization packages for Quest to the Offset Registry without a claim for waste heat at this time." with "Shell submitted the serialization packages for Quest to the Offset Registry without a claim for waste heat until the waste heat calculation methodology is approved.". • Within Section 4.2.1 , an example of findings from an audit, namely injection gas compositional data, is discussed. Significant revisions to Section 4.2.1 to address these questions. • The quantification methodology of the emission reduction associated with the Quest project is based on the difference between the mass of CO 2 stored and the sum of CO 2 emissions attributed to project activities (e.g. emissions due to construction and well drilling). The following equations are used to quantify the emission reductions resulting from the Quest carbon capture and storage activities by comparing baseline and project conditions. • Added following footnote to Table 1 : ^ Note that the pipeline design was a 12-inch CO2 pipeline as per CSA Z662 transporting the dehydrated, compressed, and dense-phase CO2 from the capture facility to the injection wells. This should minimize the risk of failure in the transportation of CO2. • Replaced conformance with 'conformance *' and added following footnote: * Ensure Conformance refers to indicating the long-term effectiveness of CO 2 storage by demonstrating actual storage performance is consistent with expectations about injectivity, capacity, and CO 2 behaviour inside the storage complex. • Added following text "Invoices of materials supplied were used to determine the nature and quantity of each material used in the capture process. This information was then used to estimate CO2 emissions per year based on an emissions factor for a specific material". • Added following sentence after "...flow meters and on-line analyzers.": "The project has an online gas analyzer to determine the CO 2 concentration in the injection gas stream. The analyzer is located in a building just before the CO 2 enters the ˜65 km underground pipeline which transports the CO 2 from the capture facility to the injection well pads". • "The key regulatory mandate is the materiality threshold for the absolute value of all errors found by auditors must be less than 2% of the total GHG Assertion for an Offset Project for a specified reporting period. As a result, the onsite lab and third-party lab provide supporting evidence that the ambient pressure compensated CO2 concentration data from the online analyzer are accurate". Quest is a fully integrated Carbon Capture and Storage (CCS) project that started CO 2 injection in August of 2015. The Quest CCS Project is located near Fort Saskatchewan, Alberta, Canada. It includes a capture facility which uses a Shell amine technology, a pipeline of about 65 km length, and three injection well pads. Each injection well pad has an injection well, a deep monitoring well, and shallow groundwater wells. The storage complex is geologically defined by the injection reservoir, a deep saline aquifer called the Basal Cambrian Sand (BCS) (about 45 m thick) and several seals, including the Middle Cambrian Shale (about 50 m thick) and Lotsberg Salts (about 120 m thick). As of August 2018, over three million tonnes of CO 2 have been safely injected and permanently stored in the BCS. The Alberta Carbon Competitiveness Incentive Regulation (CCIR) requires the use of standard methods of quantification for reporting greenhouse gas (GHG) emissions for facilities with over 100,000 tonnes of carbon dioxide equivalent (CO 2 e) per year. An emission offset project is required to comply with CCIR, associated standards and protocols, to demonstrate a reduction in the specified gas emissions and, in the case of Quest, geological sequestration. Quest is the first CCS project to implement an offset project in the context of commercial scale on-shore CO 2 geological sequestration within a saline aquifer. Quest uses the Quantification Protocol for CO 2 Capture and Permanent Storage in Deep Saline Aquifers, from Alberta Environment and Parks. An offset project must develop an offset project plan (OPP) which demonstrates how the project meets the requirement of the protocol, describes how GHG emissions reductions are achieved, identifies risks associated with the quantification of emission reduction benefits, and describes methodologies used to quantify sources and sinks. Subsequent to completing the OPP, an offset project will put together offset project reports (OPR) to report on the net reductions of GHG emissions for a specific period. The intent of this paper is a) to provide an overview of the OPP and OPR for the Quest CCS project, and b) to discuss learnings from the initial compilation and submission of offset project reports. The key learning at this time is associated to the equipment improvements to the injection gas online analyzer. [ABSTRACT FROM AUTHOR]