Search

The Poseidon-3 altimeter on board Jason-2 includes a significant new capability with respect to its predecessors, an open-loop [Détermination Immédiate d'Orbite par Doris Embarqué (DIODE)/digital elevation model (DEM)] tracker mode. This innovative mode is capable of successfully tracking the backscatter signal over rapidly varying terrains, and thus it overcomes one of the limitations of the closed-loop Poseidon-2 tracker on board Jason-1. DIODE/DEM achieves this improvement thanks to a predetermined DEM on board that, when combined with DIODE orbit ephemeris, provides improved acquisition timing and reduced data loss in the coastal zone. As a further enhancement, Jason-3 and the Sentinel-3 programs will be capable of autonomously switching to this innovative mode in selected regions. To help recommend how these missions should utilize DIODE/DEM, the authors studied the impact of the tracker mode on the accuracy and precision of wave heights and wind speed, the continuity of the sea level climate data record, and the coverage in coastal regions. The results show close agreement between the open- and closed-loop tracker modes over the open ocean with the exception of some differences at high-tidal variability areas, the coastal zone, and sea ice regions. The DIODE/DEM tracker shows better performance than the closed-loop tracker mode at the coast and in the presence of sea ice. Jason-2, when operating in open-loop mode, allows for an approximately 5% increase of successful acquisitions at the ocean-to-land transition. However, open-loop tracking exhibits more variability in regions of high tides than closed-loop. [ABSTRACT FROM AUTHOR]

In this study, we present an extension to existing numerical retrackers of synthetic-aperture radar (SAR) altimetry signals. To our knowledge at the time of writing this manuscript, it offers the most consistent retrieval of geophysical parameters compared to low-resolution mode (LRM) retracking results. We achieve this by additionally estimating the standard deviation of vertical wave-particle velocities σ v and a new parameter u x , linked to a residual Doppler in the returned radar echoes, which can be related to wind speed and direction. Including this new parameter into the SAR stack retracker mitigates sea surface height estimation errors by up to two centimeters for Sentinel-6MF SAR mode results. Additionally, we found a closed-form equation to describe u x as a function of eastward and northward wind variables, which allows mitigating the effects of this parameter on a SAR stack within level 1B processing and generating a lookup table to correct sea surface height estimates in SAR mode. This additionally opens up the door to estimating the wind speed and direction from SAR altimetry stacks. Additionally, we discuss how this new retracker performs with respect to different planned future baseline processor changes of Sentinel-6MF, namely F09 and F10, by attempting to imitate their level 2 processing. This is achieved by processing cycles 017 to 051 (nearly a full year) of Sentinel-6MF level 1A data on a global scale. We observe that the new retracking method is, on average, more accurate with respect to LRM. However, there is a slight increase in measurement noise due to the introduction of an additional parameter. To ensure that the results of the new retracker are not biased, we retrack using both the new method and the SINCS-OV ZSK retracker on Sentinel-6MF stack data produced in a Monte Carlo simulation. We analyze the simulation results with respect to accuracy, precision, and correlations between estimated parameters. We show that the accuracy of the new retracker is better than SINCS-OV ZSK but less precise, which could be related to higher correlation coefficients—especially with respect to the new parameter u x —between estimated parameters. [ABSTRACT FROM AUTHOR]