Search

The application of vanadium redox flow batteries (VRFBs) has encountered challenges because the most commonly used commercial membrane (perfluorinated sulfonic acid, PFSA) has severe vanadium ion permeation, which yields poor stability of the battery. Herein, a PFSA‐based hybrid membrane with a sandwich structure created using a reinforced polytetrafluoroethylene thin layer with hydrophilic nanohybrid fillers is developed. The tungsten trioxide (WO3) nanoparticles are in situ grown on the surface of graphene oxide (GO) nanosheets to overcome the electrostatic effect, and to enhance the hydrophilicity and dispersibility of GO nanosheets, which is embedded in the PFSA matrix to act as a "barrier" to reduce vanadium ions permeation. In addition, these hydrophilic WO3 nanoparticles on GO nanosheets surface serve as proton active sites to facilitate proton transportation. As a result, at 120 cm−2, the cell of the hybrid membrane displays high Coulombic efficiency (over 98.1%) and high energy efficiency (up to 88.9%), better than the commercial Nafion 212 membrane at the same condition. These performances indicate the proposed hybrid membrane is applicable for VRFB application. Also, this design method of the membrane can be extended to other fields including water treatments and fuel cells. [ABSTRACT FROM AUTHOR]

The vanadium redox flow battery (VRFB) is a large‐scale energy storage technique and has been regarded as a promising candidate to integrate intermittent renewable energy with the grid. Its long‐term stability has so far been limited by the core component, an ion exchange membrane with low ion selectivity. Here a hybrid membrane with superhydrophilic TiO2 nanotubes dispersed in a Nafion matrix is reported. The VRFB single cell with the hybrid membrane exhibits an impressive performance with high coulombic efficiency (CE, ≈98.3%) and outstanding energy efficiency (EE, ≈84.4%) at 120 mA cm−2, which is higher than that of the commercial Nafion 212 membrane (CE, ≈94.5%; EE, ≈79.2%). More importantly, the cell maintains a discharge capacity of ≈55.7% after 1400 cycles (over 518 h), in obvious contrast to that of ≈20% after only 410 cycles for the one using commercial Nafion 212. This is attributed to the high ion selectivity of the hybrid membrane, because of, 1) the blocked and elongated ion diffusion pathway induced by the dispersed nanotubes and 2) binding and alignment of the sulfonic acid groups on nanotube surface. The high‐performance membranes may also find important applications in other fields, such as fuel cells, dialytic batteries, and water treatment. [ABSTRACT FROM AUTHOR]