Search

The increase in efficiency achieved by UV LED devices has led to a compelling increase in research reports on UV LED water treatment for consumption in the past few years. This paper presents an in-depth review based on recent studies on the suitability and performance of UV LED-driven processes for water disinfection. The effect of different UV wavelengths and their combinations was analysed for the inactivation of various microorganisms and the inhibition of repair mechanisms. Whereas 265 nm UVC LED present a higher DNA damaging potential, 280 nm radiation is reported to repress photoreactivation and dark repair. No synergistic effects have been proved to exist when coupling UVB + UVC whereas sequential UVA-UVC radiation seemed to enhance inactivation. Benefits of pulsed over continuous radiation in terms of germicidal effects and energy consumption were also analysed, but with inconclusive results. However, pulsed radiation may be promising for improving thermal management. As a challenge, the use of UV LED sources introduces significant inhomogeneities in the light distribution, pushing for the development of adequate simulation methods to ensure that the minimum target dose required for the target microbes is achieved. Concerning energy consumption, selecting the optimal wavelength of the UV LED needs a compromise between the quantum efficiency of the process and the electricity-to-photon conversion. The expected development of the UV LED industry in the next few years points to UVC LED as a promising technology for water disinfection at a large scale that could be competitive in the market in the near future., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2023 The Authors. Published by Elsevier B.V. All rights reserved.)

It is accepted that Microplastic (MP) biofilms accumulates antibiotic-resistant bacteria (ARB) and antibiotic-resistant genes (ARGs) in water. ARB/ARGs and MPs are emerging pollutants of concern due to various associated health risks. The objective of this study was to 1) investigate the ARB community in a pilot-scale wastewater treatment plant (WWTP) effluent, 2) to study and visualize the ARB/ARGs in MP biofilm grown in WWTP effluent and tap water, and 3) to analyze microplastic adherent ARB/ARGs in the biofilm and planktonic ARB/ARGs in the filtrate under controlled conditions. Results indicated the dominance of Pseudomonas, Aeromonas, and Bacillus among isolated ARB in WWTP effluent. Representative resistance strains were incubated in 300 mL water containing commercial polystyrene beads of 300550 μm diameter (MP) in a series of batch experiments. Microbiological, molecular, and microscopic analyses were performed by enumeration, 16srRNA, real-time polymerase chain reaction (qPCR), and Field Emission-Scanning Electron Microscopy (FEG-SEM) techniques. The analyzed viable ARB indicated an increasing trend in MP biofilms between days 3 and 5. It further decreased on days 7 and 9. The prevalence of ARB in the filtrate and MP biofilm varied as a function of time and TOC level, while no significant impacts were observed for minor temperature variation, low antibiotic pressure, and increased MP mass with few exceptions. Relative abundance of ARGs (vanA, sul1) and integron integrase gene (intl1) in MP biofilm were significantly different across different TOC levels, time, and antibiotic pressure. ARGs and intl1 were detected in the MP biofilm in tap water and WWTP effluent on day 30., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2022 The Authors. Published by Elsevier B.V. All rights reserved.)

This review aims to assess different technologies for the on-site treatment of hospital wastewater (HWW) to remove pharmaceutical compounds (PhCs) as sustances of emerging concern at a bench, pilot, and full scales from 2014 to 2020. Moreover, a rough characterisation of hospital effluents is presented. The main detected PhCs are antibiotics and psychiatric drugs, with concentrations up to 1.1 mg/L. On the one hand, regarding the presented technologies, membrane bioreactors (MBRs) are a good alternative for treating HWW with PhCs removal values higher than 80% in removing analgesics, anti-inflammatories, cardiovascular drugs, and some antibiotics. Moreover, this system has been scaled up to the pilot plant scale. However, some target compounds are still present in the treated effluent, such as psychiatric and contrast media drugs and recalcitrant antibiotics (erythromycin and sulfamethoxazole). On the other hand, ozonation effectively removes antibiotics found in the HWW (>93%), and some studies are carried out at the pilot plant scale. Even though, some families, such as the X-ray contrast media, are recalcitrant to ozone. Other advanced oxidation processes (AOPs), such as Fenton-like or UV treatments, seem very effective for removing pharmaceuticals, Antibiotic Resistance Bacteria (ARBs) and Antibiotic Resistance Genes (ARGs). However, they are not implanted at pilot plant or full scale as they usually consider extra reactants such as ozone, iron, or UV-light, making the scale-up of the processes a challenging task to treat high-loading wastewater. Thus, several examples of biological wastewater treatment methods combined with AOPs have been proposed as the better strategy to treat HWW with high removal of PhCs (generally over 98%) and ARGs/ARBs (below the detection limit) and lower spending on reactants. However, it still requires further development and optimisation of the integrated processes., (Copyright © 2022 The Author(s). Published by Elsevier Ltd.. All rights reserved.)

This research reports for the first time the full-scale application of different homogeneous Advanced Oxidation Processes (AOPs) (H 2 O 2 /UV-C, PMS/UV-C and PMS/Fe(II)/UV-C) for the removal of antibiotics (ABs) and antibiotic resistance genes (ARGs) from wastewater effluent at Estiviel wastewater treatment plant (WWTP) (Toledo, Spain). AOPs based on the photolytic decomposition of H 2 O 2 and peroxymonosulfate tested at low dosages (0.05-0.5 mM) and with very low UV-C contact time (4-18 s) demonstrated to be more efficient than UV-C radiation alone on the removal of the analyzed ABs. PMS (0.5 mM) combined with UV-C (7 s contact time) was the most efficient treatment in terms of AB removal: 7 out of 10 ABs detected in the wastewater were removed more efficiently than using the other oxidants. In terms of ARGs removal efficiency, UV-C alone seemed the most efficient treatment, although H 2 O 2 /UV-C, PMS/UV-C and PMS/Fe(II)/UV-C were supposed to generate higher concentrations of free radicals. The results show that treatments with the highest removal of ABs and ARGs did not coincide, which could be attributed to the competition between DNA and oxidants in the absorption of UV photons, reducing the direct photolysis of the DNA. Whereas the photolytic ABs removal is improved by the generation of hydroxyl and sulfate radicals, the opposite behavior occurs in the case of ARGs. These results suggest that a compromise between ABs and ARGs removal must be achieved in order to optimize wastewater treatment processes., (Copyright © 2018 Elsevier B.V. All rights reserved.)

This work reports the application of photocatalytic disinfection to the inactivation of Acanthamoeba trophozoites, a free-living pathogenic amoeba. Two types of photocatalytic reactors configurations have been used: i) a slurry reactor using suspended titanium dioxide (TiO 2 ); and, ii) a fixed-bed reactor using immobilized TiO 2 onto glass Raschig rings. The effect of the chemical composition of water has been analysed, comparing the efficiency of the process in deionized water (DW) and synthetic wastewater treatment plant effluent (SWTPE). The inactivation of Acanthamoeba spp. has been compared to that of Escherichia coli bacteria, being also analysed the concomitant inactivation of both microorganisms. Our results show that 99% of inactivation of E. coli and Acanthamoeba spp. can be achieved using photocatalysis in both reactor configurations, but interestingly, the kinetics of inactivation of both microorganisms together differs from that found with them separately. Particularly, E. coli seems to be more resistant to the inactivation in the presence of Acanthamoeba spp. which has been justified by the screen effect caused by the bigger size of Acanthamoeba spp. This observation is more pronounced in DW as the composition of the SWTPE prevent the microorganisms from suffering osmotic and/or mechanical stress and protect cellular structures to the attack of reactive oxygen species (ROS). On the other hand, the difference between the inactivation rate of E. coli and Acanthamoeba, points out the importance of the different inactivation mechanisms, suggesting that the entry of small TiO 2 particles into the cytoplasm of the Acanthamoeba cells provokes the attack of inner structures and as a consequence a faster inactivation. This mechanism is not possible when the catalyst is immobilized leading to a higher cell resistance to inactivation and consequently lower efficiency of the disinfection process., (Copyright © 2018 Elsevier Ltd. All rights reserved.)

Different TiO2 photoelectrodes have been characterized and tested for the photoelectrocatalytic oxidation of methanol. Particulate electrodes (TiO2/Ti and TiO2/ITO) have been shown to notably favour charge-carrier transfer at the electrolyte interface while a thermal electrode (Ti) has been shown to favour charge-carrier separation when applying an electric potential bias according to cyclic voltammetry technique, as a consequence of differences in TiO2 surface between particulate and thermal electrodes. Particulate electrodes lead to a higher photoelectrocatalytic activity for methanol oxidation compared to that of the thermal electrode, probably due to the pure-rutile TiO2 phase composition of the latter and its lower surface area. TiO2/Ti electrode has been shown to be the most effective photoelectrode tested for methanol oxidation since its activity was improved by the combination of the particulate TiO2 layer and the high electrical conductivity of the support. Generally, photocurrent density measured in the photoelectrochemical cell seems to correlate with activity, whereas this correlation is not observed when using a larger photoelectrocatalytic reactor. In contrast, the activity obtained for the scaled-up electrode is found to be similar in terms of surface kinetic constant to that obtained at laboratory scale.

Biofilms formed by different bacterial species are likely to play key roles in photocatalytic resistance. This study aims to evaluate the efficacy of a photocatalytic immobilized nanotube system (TiO 2 -NT) (IS) and suspended nanoparticles (TiO 2 -NP) (SS) against mono- and dual-species biofilms developed by Gram-negative and Gram-positive strains. Two main factors were corroborated to significantly affect the biofilm resistance during photocatalytic inactivation, i.e., the biofilm-growth conditions and biofilm-forming surfaces. Gram-positive bacteria showed great photosensitivity when forming dual-species biofilms in comparison with the Gram-positive bacteria in single communities. When grown onto TiO 2 -NT (IS) surfaces for immobilized photocatalytic systems, mono- and dual-species biofilms did not exhibit differences in photocatalytic inactivation according to kinetic constant values (p > 0.05) but led to a reduction of ca. 3–4 log 10. However, TiO 2 -NT (IS) surfaces did affect biofilm colonization as the growth of mono-species biofilms of Gram-negative and Gram-positive bacteria is significantly (p ≤ 0.05) favored compared to co-culturing; although, the photocatalytic inactivation rate did not show initial bacterial concentration dependence. The biofilm growth surface (which depends on the photocatalytic configuration) also favored resistance of mono-species biofilms of Gram-positive bacteria compared to that of Gram-negative in immobilized photocatalytic systems, but opposite behavior was confirmed with suspended TiO 2 (p ≤ 0.05). Successful efficacy of immobilized TiO 2 for inactivation of mono- and dual-species biofilms was accomplished, making it feasible to transfer this technology into real scenarios in water treatment and food processing. [Display omitted] • Effective inactivation of biofilms (BFs) by immobilized TiO 2 (ca. 99–99.99%) at lab scale reactor. • Successful long-term control and prevention of biofilms accumulation in water treatment and food industry. • Photocatalytic (PC) process shows efficiency against mono- and dual-species BFs. • Gram-positive bacteria shows photosensitivity when forming dual-species BFs. • Gram-positive mono-specie BFs show higher resistance to inactivation than equivalent Gram-negative BFs. [ABSTRACT FROM AUTHOR]