Search

Wastewater reclamation and reuse has become one of the most important environmental issues nowadays. Thus, municipal wastewater treatment plants are being upgraded converting conventional activated sludge processes into membrane bioreactors in order to improve the quality of the treated wastewater. However, operational costs increase because of higher energy consumption and membrane fouling. Wastewater composition is one of the factors affecting membrane fouling, though its influence is difficult to describe. In this work, a study about wastewater pretreatment and filterability has been carried out in view of achieving valuable information for a further implementation of a membrane bioreactor. Experiments were performed with samples of four municipal wastewater treatment plants taken from the plant influent, the biological process influent and the plant effluent. Filterability was evaluated by membrane filtration resistances using the resistance in series model. Resistances were measured with ultrafiltration tests performed with flat membranes. Results showed that suspended solids concentration was the most influential parameter on the total membrane resistance when pretreated wastewater is filtered. No statistical correlation between the membrane resistances of biological process influent and plant effluent was found. [ABSTRACT FROM AUTHOR]

Management of wastewater is a major challenge nowadays, due to increasing water demand, growing population and more stringent regulations on water quality. Wastewaters from food conservation are especially difficult to treat, since they have high salinity and high organic matter concentration. The aim of this work is the treatment of the effluent from a table olive fermentation process (FTOP) with the aim of reusing it once the organic matter is separated. The process proposed in this work consists of the following membrane-based technologies: Ultrafiltration (UF) (UP005, Microdyn Nadir), Forward Osmosis (FO) (Osmen2521, Hydration Technology Innovation) and Nanofiltration (NF) (NF245, Dow). The FO process was implemented to reduce the salinity entering the NF process, using the FTOP as draw solution and, at the same time, to concentrate the centrate produced in the sludge treatment of a municipal wastewater treatment plant with the aim of obtaining a stream enriched in nutrients. The UF step achieved the elimination of 50% of the chemical oxygen demand of the FTOP. The UF permeate was pumped to the FO system reducing the volume of the anaerobically digested sludge centrate (ADSC) by a factor of 3 in 6.5 h. Finally, the ultrafiltrated FTOP diluted by FO was subjected to NF. The transmembrane pressure needed in the NF stage was 40% lower than that required if the ultrafiltration permeate was directly nanofiltered. By means of the integrated process, the concentration of organic matter and phenolic compounds in the FTOP decreased by 97%. Therefore, the proposed process was able to obtain a treated brine that could be reused in other processes and simultaneously to concentrate a stream, such as the ADSC. [ABSTRACT FROM AUTHOR]

Abstract: The use of large quantities of sulfuric acid and other sulfur-containing chemicals causes high sulfate concentrations in the wastewater of a tannery. The aim of this work was reducing the sulfate concentration in the final wastewater from a tannery. For that, firstly a study about the main sulfate sources in a tannery was carried out and the total sulfates load in the tannery wastewater was evaluated. Two measures for sulfates reduction were studied: the recycling of unhairing wastewater to the soaking drums and the reuse of the chromium sulfate from the tanning washing wastewater after its separation by nanofiltration (NF). The first measure proposed was studied experimentally in laboratory drums of 5L of volume. Two series of experiments with different volumes of unhairing wastewater in the soaking bath were carried out. The quality of the final leather was evaluated by means of mechanical tests. NF experiments were carried out in a laboratory pilot plant with a spiral wounded membrane element. Concerning the results, the combination of 50% unhairing wastewater and 50% of fresh water was appropriate in order to obtain leather with an acceptable quality. Besides, it drove to a diminution of approximately 10% in the addition of sulfide in the unhairing. Related to the NF experiments, 97% of the sulfates were rejected by the membrane. The separated ions could be recycled to the tanning drums. The application of the two measures (firstly the recycling of the unhairing wastewater and secondly the NF of the tanning washing wastewater) drove to a reduction of 14.82kgSO4 −2 t−1 of raw hide. [ABSTRACT FROM AUTHOR]