Search

The neutral beam injector of steady state superconducting tokamak (SST1-NBI) at IPR is designed for injecting upto 1.7 MW of neutral beam (Ho, 30-55 keV) power to the tokamak plasma for heating and current drive. Operations of the positive ion source (PINI or Plug-In-Neutral-Injector) of SST1-NBI were carried out on the NBI test stand. The PINI was operated at reduced gas feed rate of 2-3 Torr l/s, without using the high speed cryo pumps. Experiments were conducted to achieve a stable beam extraction by optimizing operational parameters namely, the arc current (120-300 A), acceleration voltage (16-40 kV), and a suitable control sequence. The beam divergence, power density profiles, and species fractions (H+:H2+:H3+) were measured by using the diagnostics such as thermal calorimetry, infrared thermography, and Doppler shift spectroscopy. The maximum extracted beam current was about 18 A. A further increase of beam current was found to be limited by the amount of gas feed rate to the ion source. [ABSTRACT FROM AUTHOR]

Regulated high-voltage power supplies (RHVPSs) are important power sources in high-power heating and current drive systems for a tokamak. Along with high power at output, these power supplies meet the requirements of fast dynamics (on the order of few microseconds), low ripple factor, and good output regulation. A development overview is presented for RHVPS ranging from 14 to 80 kV at several-megawatt power with typical output results. Having extensive tests performed with an 80-kV 75-A RHVPS, it is being regularly used for a neutral beam injector (NBI) at the Institute for Plasma Research (IPR). A large number of identical and series-connected switched power modules (SPMs) are fed from multisecondary transformers. Pulse step modulation control applied to an insulated-gate bipolar transistor switch within SPMs regulates output. Different rise and fall times of voltage can be set from few microsecond to millisecond range. Fast detection of instantaneous overcurrent reduces turnoff time within 2 \mu\s. Due to higher frequency of ripple at higher voltages, output filter component value is of smaller order, which, in turn, limits fault energy below 10 J. The development of RHVPS at IPR started by making a functional prototype at lower rating (14 kV; 35 A) to have an experience in testing design concepts. This was divided in various activities like selection of topology, selection and design of different subparts, e.g., control, switching power converters with protections, and multisecondary transformers. Having successful results and testing all functional parameters on prototype, a series of RHVPSs at higher ratings (up to 80 kV), are developed and installed for NBI and radio-frequency heating system. The design details for each subsystem along with results are discussed. [ABSTRACT FROM PUBLISHER]

This article describes the control system for a 5 MW ion source of the NBI (neutral beam injector) for steady-state superconducting tokamak-1 (SST-1). The system uses both hardware and software solutions. It comprises a DAS (data acquisition system) and a control system. The DAS is used to read the voltage and current signals from eight filament heater power supplies and 24 discharge power supplies. The control system is used to adjust the filament heater current in order to achieve an effective control on the discharge current in the plasma box. The system consists of a VME (Verse Module Eurocard) system and C application program running on a VxWorks™ real-time operating system. A PID (proportional, integral, and differential) algorithm is used to control the filament heater current. Experiments using this system have shown that the discharge current can be controlled within 1% accuracy for a PID loop time of 20 ms. Response of the control system to the pressure variation of the gas in the chamber has also been studied and compared with the results obtained from those of an uncontrolled system. The present approach increases the flexibility of the control system. It not only eases the control of the plasma but also allows an easy changeover to various operation scenarios. [ABSTRACT FROM AUTHOR]