Search

An oil spill is a catastrophic event that results in various toxic polycyclic aromatic hydrocarbons (PAHs) entering the environment. Polycyclic aromatic nitrogen heterocycles (PANHs) are more toxic to the environment than their parent PAHs. The high cost and paucity of available PANH standards, the lower abundance of PANHs relative to PAHs, and the difficult separation due to co-elution with PAHs have all contributed to the scarcity of related published literature on the determination of these compounds. To overcome these challenges, a new quantitative method has been successfully developed and validated for the inclusion of 113 polycyclic aromatic carbon (PAC) compounds in a single injection. The 113 compounds consist of PAHs, nitrogen heterocycles, sulfur heterocycles, and alkylated equivalents. Distinct separation of the PANHs and their alkylated counterparts (APANHs) from PAHs was achieved using a gas chromatography quadrupole time-of-flight (GC-QToF) mass spectrometer. The instrument resolved compounds by the high-resolution extraction of monoisotopic masses, allowing response correction factors (RCFs) to be determined from available PANH standards and to calculate concentrations from PAH calibration standards. The developed method was applicable to crude oil samples, generating concentrations of PANHs and relevant information on compound stability for use in oil spill forensics investigation. Development of this practical PAC method provides a powerful tool for screening toxic contaminants, assessing environmental impact, and monitoring recovery following an oil spill. [ABSTRACT FROM AUTHOR]

Biofilm communities on intertidal mudflats are recognized as major producers of nutrients, especially fatty acids. The rising threats posed by both climatic and anthropogenic stressors increase the necessity of understanding and conserving these communities. Shorebirds provide a proxy for studying the complex ecology of biofilm communities because of their heavy reliance on fatty acids from diatomaceous biofilm for successful long-distance migration. Herein, we review biofilm feeding patterns by migratory shorebirds, experimental design considerations for sampling and studying the fatty acid content of biofilm, and the literature describing established and emerging analytical methodology. Techniques for fatty acid analysis include the commonly employed gas chromatography–flame ionization detection (GC/FID) and gas chromatography–mass spectrometry (GC/MS) with derivatization. Liquid chromatography–mass spectrometry (LC/MS) and liquid chromatography–quadrupole time of flight (LC/QTOF) are newly emerging techniques that enable derivatization to be eliminated. In addition, Fourier transform infrared spectroscopy (FT/IR), a common instrument in chemistry laboratories, has applications in fatty acid research, specifically for screening. Using a combination of sampling and analytical methods is necessary for improved understanding of intertidal biofilm, both as a source of essential fatty acids in aquatic systems and a critical food for shorebirds. [ABSTRACT FROM AUTHOR]

• Unassisted stoichiometric degradation of DOSS to monooctyl sulfosuccinate 2 (MOSS). • LC/QToF method for DOSS and MOSS as dual tracers for oil spill dispersant. • Dispersant plus dilbit in seawater microcosm study of DOSS conversion to MOSS. • Extension of environmental seawater sample collection time. A high resolution mass spectrometry method was developed for the environmental impact monitoring of oil spill dispersants. Previously reported instability of dioctyl sulfosuccinate (DOSS) dispersant tracer was addressed by the new procedure. The method monitors both DOSS and its degradation product, monooctyl sulfosuccinate (MOSS), by liquid chromatography time-of-flight mass spectrometry. The related isomer, 4-(2-ethylhexyl) 2-sulfobutanedioate, was chromatographically resolved from MOSS but was not a product of DOSS degradation. Using this direct injection method (10 μL), the practical lower limit of quantitation was 0.5 nM for each analyte, a concentration equivalent to 0.22 ng mL−1, or 0.30 ng mL−1 including initial dilution factor with acetonitrile. The method was shown applicable to analysis of the dispersants Corexit® EC9500 A, Finasol OSR 52, Slickgone NS, and Slickgone EW for which DOSS is an active ingredient. A marine microcosm study of Corexit EC9500A, together with diluted bitumen (dilbit), at 15 ± 1 °C, provided evidence of the stoichiometric conversion of DOSS to MOSS under conditions reflecting a western Canadian marine environment. The advantage of the developed method is in its ability to extend environmental seawater sample collection time from 4 days for DOSS alone, to 14 days when both DOSS and MOSS are simultaneously analysed and results combined. The collection time is likely extended beyond the 14 day period with cooler temperatures. Preservation of collected seawater samples using sodium hydroxide, converting DOSS into MOSS in situ , was rejected due to stability issues. Addition of disodium ethylenediaminetetraacetic acid did not improve hold times, thus eliminating the theory of cation induced micelle effects causing DOSS loss. [ABSTRACT FROM AUTHOR]

A rapid and sensitive liquid chromatography quadrupole time of flight method has been established for the determination of total naphthenic acid concentrations in aqueous samples. This is the first methodology that has been adopted for routine, high resolution, high throughput analysis of total naphthenic acids at trace levels in unprocessed samples. A calibration range from 0.02 to 1.0 μg mL −1 total Merichem naphthenic acids was validated and demonstrated excellent accuracy (97–111% recovery) and precision (1.9% RSD at 0.02 μg mL −1 ). Quantitative validation was also demonstrated in a non-commercial oil sands process water (OSPW) acid extractable organics (AEOs) fraction containing a higher percentage of polycarboxylic acid isomers than the Merichem technical mix. The chromatographic method showed good calibration linearity of ≥0.999 RSQ to 0.005 μg mL −1 total naphthenic acids with a precision <3.1% RSD and a calculated detection limit of 0.0004 μg mL −1 employing Merichem technical mix reference material. The method is well suited to monitoring naturally occurring and industrially derived naphthenic acids (and other AEOs) present in surface and ground waters in the vicinity of mining developments. The advantage of the current method is its direct application to unprocessed environmental samples and to examine natural naphthenic acid isomer profiles. It is noted that where the isomer profile of samples differs from that of the reference material, results should be considered semi-quantitative due to the lack of matching isomer content. The fingerprint profile of naphthenic acids is known to be transitory during aging and the present method has the ability to adapt to monitoring of these changes in naphthenic acid content. The method's total ion scan approach allows for data previously collected to be examined retrospectively for specific analyte mass ions of interest. A list of potential naphthenic acid isomers that decrease in response with aging is proposed and a quantitative assay of an adamantane carboxylic acid is reported. [ABSTRACT FROM AUTHOR]

• Rapid, direct injection LC/MS-QTOF method for resin acids without derivatization. • MDL in range 0.05 to 0.07 µgL−1 for six resin acids in aqueous alkaline matrix. • Precision and accuracy from 1 µgL−1 to 40 µgL−1 in matrix. • Isopimaric as calibrant for six C 20 H 30 O 2 resin acids. • Transferred to LC/MS/MS and successfully applied to environmental samples. A rapid and sensitive liquid chromatography (LC) quadrupole time of flight (QTOF) method has been developed for the determination of resin acid concentrations in aqueous pulp and paper effluent related samples. Calibration R2 of ≥0.995 for twelve resin acids, namely dehydroabietic, 8(14)-abietenic, dihydroisopimaric, levopimaric, neoabietic, pimaric, sandaracopimaric, abietic, isopimaric, palustric, chlorodehydroabietic, and dichlorodehydroabietic acids, was demonstrated in the range 1 µgL−1 to 40 µgL−1. An improved lower limit of quantitation was achieved without use of complex sample extraction and clean-up procedures undertaken by other published methods. Excellent precision and accuracy results were achieved for dehydroabietic, chlorodehydroabietic, dichlorodehydroabietic, isopimaric (integrated inclusive of all C 20 H 30 O 2 resin acids), dihydroisopimaric and 8(14)-abietenic resin acids, with t-99 percentile detection limits spanning the range 0.05 to 0.07 µgL−1. While measurement for the C 20 H 30 O 2 resin acids by isopimaric equivalence is considered semi-quantitative and could be an under estimate for the abietic acid component, the developed method demonstrated clear advantage over time consuming, hazardous, and unstable derivatization procedures used for gas chromatography and capillary electrophoresis. The developed LC/QToF method was successfully transferred to an LC triple quadrupole mass spectrometer for routine high throughput trace level analysis. Real world samples, including sea water and estuary water, demonstrated excellent spike recoveries by this procedure, indicating that the method is well suited to the monitoring of industrially derived resin acids in environmental surface waters. While no interferences were observed during routine sample analysis using myristic-1-13C acid and palmitic-1-13C acid internal standards, these were later substituted by myristic-d 27 and palmitic-d 31 acid in order to improve method robustness for environmental samples where endogenous parent fatty acids could be present. [ABSTRACT FROM AUTHOR]

• Timber extracts exploited using GC/QToF for chemotyping forensic analysis. • Differentiation and determination of wood achieved at genus/species level. • CITES listed wood species investigated and identified with the new method. • EI wood spectral library suitable for method transfer to routine environmental labs. The international trade in illegally logged and environmentally endangered timber has spurred enforcement agencies to seek additional technical procedures for the identification of wood species. All Dalbergia species are listed under the Convention on International Trade in Endangered Species (CITES) which is the reason this genus was chosen for study. Multiple sources of the heartwood from different Dalbergia species were extracted and chromatographic profiles collected by gas chromatography with high resolution quadrupole Time of Flight mass spectrometry (GC/QToF). The collected data was mined to select peaks and mass ions representative of the investigated Dalbergia species, and used to develop a Microsoft Excel® template offering immediate graphical representation of the results. Using wood specimens sourced from different xylaria, this graphical fingerprint proved adept at definitive identification of Dalbergia species. The CITES Appendix I species, D. nigra , was easily distinguished from D. melanoxylon and look-alike species of other genera. Similarly, a number of other Dalbergia species were differentiated using this current approach. Kernel discrimination analysis (KDA) was applied to increase the confidence of the species identification. The mislabeling of specimens appears to be common, and the emerging technique of GC/QToF in combination with other techniques, offers improved confidence in identification. GC/QToF further provides automation, the dimension of chromatography to avoid interferences, and production of reproducible electron impact positive (EI+) spectra. The prospect of building an EI+ spectral database for future wood identification is an important feature considering the limited accessibility of authenticated wood species specimens. [ABSTRACT FROM AUTHOR]