Search

Cobalt oxide thin films were prepared by a facile spray pyrolysis technique, using a perfume atomizer with an aqueous solution of hydrated cobalt chloride salt with a molar concentration of 0.025 M as a source of cobalt. The films were deposited onto glass substrates at temperature of 350 °C. The structural, morphological, and electrochromic properties of the obtained films were studied. It was found from X-ray diffraction analysis that the films were polycrystalline in nature with spinel-type cubic structure and preferred orientation along [111] direction. The Scanning Electron Microscopy images revealed a porous structure with the average grain size around 200 nm. The cyclic voltammetry measurements revealed that Cobalt oxide thin film is an anodically coloring electrochromic material with a transmittance variation in the visible range of 31%, and a fast response time (about 2 seconds) and a good cycling stability. These electrochromic performances make cobalt oxide thin film an attractive material for using as an anodic electrochromic material in smart windows devices. The photoluminescence spectra exhibited a strong emission in the visible region confirming the good crystallinity properties of Co3O4 thin films. [ABSTRACT FROM AUTHOR]

The effective nanometer-sized thin layer (about 1–2 nm) located between a crystalline ZnS film and glass substrate is studied here using photoinduced optical and second-order non-linear optical (second harmonic generation (SHG) and electrooptics effects) techniques. A photoinduced shift of the effective energy gap is found for the first time in ZnS films doped with the same amount (4 at.%) of different elements, namely, In, Al and Sn. The photoinduced second-order non-linear optical properties (linear electrooptics (LEO) and SHG) of the specimens show a good correlation with the corresponding features of the linear optical susceptibilities, particularly, the imaginary part of dielectric susceptibility near the absorption edge. The maximal response of the photoinduced signal is observed for the pump–probe delaying time of about 20 ps. The performed experimental measurements indicate that the observed effects are stimulated by two factors: the first one is connected with the interface potential gradients at the glass–ZnS film boarder; the second one is a consequence of the additional polarization due to the insertion of Al, In and Sn atoms. The observed phenomenon may be proposed as a sensitive tool for investigation of thin semiconducting-glass interface layer. Moreover, such nanolayers may be applied in quantum electronic devices. [Copyright &y& Elsevier]