Search

Reciprocating spur gear rack is prone to lubrication failure near the reversing dead center position. Ree‐Eyring lubrication fluid, multigrid method and multigrid integral method were used to calculate the pressure profile, film thickness and oil temperature rise. Compared with linear motion, the process of reciprocating commutative movement is more complicated and the lubrication state are more unstable. The effects of different reversing duration time and commutation meshing state on lubricant film were analysed. The results show that, the oil thickness during the gear reversing process is significantly reduced. While shortening the reversing time can improve the lubricating film thickness, it causes the instantaneous oil temperature to rise. Therefore, the gear tooth damage caused by high temperature can be avoided by prolonging the reversing duration time properly. The longer the reversing duration time, the minimum value of central film thickness and central pressure is closer to the meshing outlet area. No matter what the reversing time change, the minimum lubrication film thickness is in the reversing dead center position. So the reversing dead center is still the dangerous point for the lubrication failure of the spur gear rack mechanism. When the reversing dead center is in the leading tooth of double‐tooth meshing, the gear has the largest film thickness and the largest contact area. In addition, the synthetic radius of curvature and entrainment velocity become larger so the lubrication conditions have been improved. The results provide the theoretical basis and guidance for the reasonable design of the spur gear rack and the improvement of its lubricating performance. [ABSTRACT FROM AUTHOR]

An elastohydrodynamic model of ferrofluid‐lubricated involute spur gears was established, and transient thermal elastohydrodynamic lubrication (EHL) analysis was conducted using multigrid method and multigrid integral method. The transient lubricant film thickness, pressure, and friction coefficient characteristics of the spur gears were compared under different carrier fluid ferrofluids. Ester‐based H01 ferrofluid was selected to further examine the lubricant film elastohydrodynamic characteristics of the involute spur gears under different loads and speeds. The results indicated that the film thickness and the inlet area pressure were the largest when hydrocarbon‐based E02 ferrofluid was used for lubrication and were the smallest when ester‐based ferrofluid H01 was used for lubrication. When ester‐based H01 ferrofluid was used, the film thickness, the inlet area pressure, and the second pressure peak increased with the increase of speed, and the second pressure peak shifted toward the inlet area. The friction coefficient and the maximum temperature gradually decreased with the increase of speed, and the second pressure peak, the friction coefficient, and the maximum temperature gradually increased with the increase of load, while the film thickness gradually decreased. [ABSTRACT FROM AUTHOR]