Search

The structural potential of plant fibres as reinforcing agents can only be realized when the highest reinforcement efficiency is employed. Hence, aligned plant fibre composites are of interest. However, due to the short length of technical plant fibres, the reinforcement needs to be in the form of staple fibre yarns, which have a twisted structure. Although twist facilitates yarn processability, it has several detrimental effects on the composites produced from such twisted yarn reinforcements; one of which is fibre obliquity and misalignment. This results in a drastic drop in composite mechanical properties. No analytical model currently exists to accurately predict the effect of yarn twist on aligned plant fibre composite tensile strength. In this paper, a novel mathematical model is developed. The model is based on (i) a modified rule of mixtures for plant fibre composites, (ii) well-defined structure-property relationships in an idealised twisted staple fibre yarn and (iii) the Krenchel orientation efficiency factor. The developed model includes a corrected orientation efficiency factor of cos2(2α), where α is the yarn surface twist angle. The model is validated with extensive experimental data from Goutianos and Peijs (Goutianos S, Peijs T (2003) Adv Compos Lett 12(6):237) and is found to be a near-perfect fit (R2 = 0.960). Experimental data from other studies are also used for further verification. [ABSTRACT FROM AUTHOR]

Abstract: The effect of fibre volume fraction on the physical and tensile properties of aligned plant fibre composites (PFCs) produced via vacuum infusion has been investigated. There is no clear correlation between fibre volume fraction and porosity. However, low fibre content PFCs are prone to intra-yarn voids, while high fibre content PFCs are prone to inter-yarn voids. This is due to changing resin flow dynamics with increasing fibre content. The tensile behaviour of PFCs with increasing fibre content is similar to that of conventional fibre reinforced plastics (FRPs). Interestingly, the non-linear stress–strain response of plant fibres has been transferred to the composites. Fibre content and tensile properties are found to be linearly related, as per the rule of mixtures. A void content of up to 4% is found to have minimal effect on the tensile properties of PFCs. The minimum and critical (vf , crit ) fibre volume fractions for aligned flax and jute–polyester composites are found to be substantially higher than conventional aligned FRPs; vf , crit for jute–polyester and carbon–polyester is 8.1% and 2.4%, respectively. A simple model has also been developed to approximate the theoretical maximum obtainable fibre volume fraction of PFCs reinforced with staple fibre yarns. The absolute theoretical maximum fibre content is found to be 58.9%, which agrees with experimental values in literature. A high vf , crit (∼10%) and low vf , max (∼45%) implies that the range of useful fibre volume fractions for PFCs containing staple fibre twisted yarns is only 35%. [Copyright &y& Elsevier]