Search

This paper is divided into two parts; the first describes a CFD analysis of a gland packing labyrinth seals in 20 MW steam turbine in LNG plant using ANSYS CFX code as an isothermal simulation in fluid domain. The results of two turbulence models k-ε and k-ω SST are compared and validated against experimental data. It is shown that the labyrinth seal leakage is proportional to the clearance cube so any variation in clearance can have a significant impact on the steam leakage. This clearance between the shaft and the labyrinth seal vary as a function of operating temperature due to the different rates of thermal expansion of the materials for these two components. Likewise the fluid temperature has a direct effect on fluid dynamic behavior. For that; the second part of the paper investigates the effect of fluid thermal conditions of the labyrinth seal via the heat transfer and Nusselt number variation in the stator and the rotor, for different cases of inlet temperature (400 °C, 200 °C, 100 °C, 50 °C) and pressure ratio (2.5, 4.5, 6.5) for an ideal gas. Also it is important to know the temperature distribution across tooth and cavities of the labyrinth seal, and finally the Influence of Inlet total temperature on fluid pressure drop in the labyrinth seal will be treated for improving and readjusting the steam turbine sealing system. [ABSTRACT FROM AUTHOR]

Tubular light guides are applicable for daylighting of windowless areas in buildings. Despite their many positive indoor climate aspects they can also present some problems with heat losses and condensation. A computer CFD model focused on the evaluation of temperature distribution and air flow inside tubular light guides of different dimensions was studied. The physical model of the tested light guides of lengths more than 0.60 m proves shows that Rayleigh numbers are adequate for a turbulent air flow. The turbulent model was applied despite the small heat flux differences between the turbulent and laminar model. The CFD simulations resulted into conclusions that the growing ratio of length/diameter increases the heat transmission loss/linear transmittance as much as by 50 percent. Tubular light guides of smaller diameters have lower heat transmission losses compared to the wider ones of the same lengths with the same outdoor temperature being taken into account. The simulation results confirmed the thermal bridge effect of the tubular light guide tube inside the insulated flat roof details. The thermal transmittance of the studied light guides in the whole roof area was substituted with the point thermal bridges. This substitution gives possibility for simple thermal evaluation of the tubular light pipes in roof constructions. [ABSTRACT FROM AUTHOR]