Search

This paper presents the development of a ground-based arc-scanning synthetic aperture radar (ArcSAR) system mounted on a truck. ArcSAR formulates synthetic aperture by a horizontal circular motion of antennas attached at the end of an extendable boom. The ArcSAR system is designed to operate in two different imaging modes: the spot mode and the scan mode . The spot mode obtains a high-resolution image by fixing the view angle of antennas toward a target. The scan mode obtains wider image coverage with a reduced resolution by fixing the antennas relative to the boom. Different SAR focusing algorithms were implemented for the accuracy and efficiency of image processing: the time domain algorithm for the spot mode and the range Doppler algorithm for the scan mode. An exemplary X-band ArcSAR spot mode image, obtained with a 180 ° scanning of 4-m boom, has an azimuth resolution of 0.07 ° , which is equivalent to the 12.6-m linear scanning of a conventional ground-based SAR system. An ArcSAR scan mode image was successfully obtained as well, covering a 350 ° image area at an azimuth resolution of 1.07 °, which is 11 times better than that of arc-scanning real aperture radar that would have 11.84 ° azimuth resolution.

In this paper, we analyzed the phase change of 5-triangular trihedral comer reflectors by using X-band Ground-Based Synthetic Aperture Radar (GB-SAR) system. Each reflector was set as a stationary target at a different distance from the system. We obtained total 123 full-polarization images during 40 hours continuously at 20 minute interval. Results of SAR interferometric analysis showed phase changes of maximum 2 radians and followed similar pattern with atmospheric data. Through a GB-SAR phase formula that includes refractive index in the air, we performed regression analysis for refractive index as a function of atmospheric humidity, temperature and pressure. As a result, refractive index of air in X-band showed relatively high coefficient of determination with humidity and temperature (0.72 and 0.76 on average, respectively) but not so with pressure (0.34). The refractive index of air in X -band changed by during the measuring time with a humidity range of 50% ~ 90% and a temperature range of ~ . We expect that a total expression of refractive index of air including humidity, temperature and pressure can be calculated when more extensive data would be collected at various atmospheric conditions.

We made a ground-based synthetic aperture radar (GB-SAR) system and tested its interferometric SAR (InSAR) measurement on the displacement of a trihedral corner reflector with atmospheric correction in terms of humidity and range. The GB-SAR worked at C-band with the synthetic aperture length of 5 m. Fully-polarimetric images were obtained with resolutions of 25 cm in range and 0.32 degree in azimuth direction. Located 160 m away from the system, the reflector was moved from 1 mm to 40 mm toward the system during each acquisition. An atmospheric correction function was obtained in terms of humidity and range by analyzing the phase of several stationary targets. The result showed an atmospheric delay of 3 mm at 160 m range when humidity changed from 47% to 58%. After atmospheric correction, DInSAR error was less than 1 mm with the correlation coefficient of 0.9999 when compared with the actual displacements. We concluded that atmospheric correction should be reinforced somehow for most spaceborne InSAR applications.