Search

Owing to the increasing penetration level of distributed energy resources (DER) and direct current (DC) load, the usage of low-voltage direct current (LVDC) systems has expanded to achieve efficient operations. However, because the LVDC system reaches the peak fault current at a faster rate than the alternating current (AC) system, a solution that protects the system components is necessary to maintain system integrity. It is required by the low-voltage ride-through (LVRT) that the DERs maintain their interconnections with the LVDC system and support fault recovery. In this study, a method is proposed to allow the application of the superconducting fault current limiter (SFCL) to reduce the fault current and enhance the LVRT capability. However, when the DER maintain a connection to support fault recovery, the conventional resistive-type SFCL must withstand the burden of high-temperature superconducting (HTSC) operation during fault state dependence on LVRT. Therefore, this study proposes a trigger-type SFCL to reduce the burden of the HTSC element and enhance the LVRT capability. The voltage sag related to the LVRT was improved owing to the SFCL. The proposed solution was confirmed using PSCAD/EMTDC, which is a commercial software. [ABSTRACT FROM AUTHOR]

Most industrial technologies are automated by sensitive electric parts such as programmable logic controllers(PLCs) and magnetic contactors which are required high power quality. The voltage sags occur in the non-faulted power distribution feeders during the fault duration. Therefore, voltage causes economic losses in the production process of various companies. To solve the fault current and the voltage sags, the superconducting fault current limiter (SFCL) is in the spotlight. The SFCL where was located on starting point of the feeder improves the reliability of the facility by reducing the fault current. In addition, it compensates the voltage sags on the bus-bar. In this paper, evaluating the voltage sags based on fault location in the power distribution system with the SFCL through PSCAD/EMTDC simulation. Next, the expected the voltage sags frequency is predicted by the reliability analysis technique of the power distribution system. The expected voltage sags frequency of the power distribution feeder is compared with before and after the application of the SFCL. [ABSTRACT FROM AUTHOR]

The increase of various dispersed generations (DGs) such as wind power and solar cell in a power distribution system has been reported to increase the short-circuit current. In addition, the introduction of the DG in a power distribution system is expected to affect the operation of the protective device as well. The superconducting fault current limiter (SFCL), which has been continuously studied for the reduction of the circuit breaker's power burden, recently starts to be noticed as effective method to solve the fault current problem due to the introduction of the DG. Since the fault current limiting operation of the SFCL and the operations of the protective devices such as the over-current relay or the recloser are affected by the application location of the DG, the study on the protection cooperation of the protective devices with the SFCL considering the application location of the DG in a power distribution system is firstly required. [ABSTRACT FROM PUBLISHER]

The introduction of various dispersed generation (DG) in a power distribution system has caused the short-circuit current to increase, which can make the operation of the protective device deviate from its original set value. Especially, the increase of a short-circuit current in a power distribution system due to the increase of the DG is expected to be required for the related power utilities such as the circuit breaker to be replaced with a larger one. Among the countermeasures to solve the short-circuit problem in a power distribution system considering the increase of the DG, the superconducting fault current limiter (SFCL) has been noticed as one of the promising devices. [ABSTRACT FROM PUBLISHER]

In this study, we analyse the coordination of protective relays between a primary feeder and an interconnecting transformer grounded by using a superconducting fault current limiter (SFCL) of a wind farm. Most wind farms and utility systems are interconnected by a transformer. The winding configuration of most interconnecting transformers is wye grounded-delta. Therefore, the utility-side grounding of the interconnecting transformer can support a new single line-to-ground fault current path. Because the coordination plan of a protective relay in a power distribution system does not consider the new fault path, an unintended relay operation can occur. To overcome this problem, an SFCL is applied to the ground connection of the interconnecting transformer. We analyse the effect of the resistive SFCLs on the coordination of the ground faults using time-domain transient simulation software (PSCAD/EMTDC). [ABSTRACT FROM PUBLISHER]

In this paper, we propose a protection scheme using a superconducting fault current limiter (SFCL) for the electric railway with traction power supply system with the automatic power changeover switch (ACS) system. The Korean electric railway uses a Scott transformer with many traction power substations. Each traction power substation has a neutral section. The ACS system is being installed at the neutral section and studied. In this system, shorting between the M- and T-phases prevents phase-to-phase faults, which was not considered for the conventional AC railway, due to the ACS. The proposed protection scheme using the SFCL mitigates this problem. In addition, we analysed the effect of the proposed protection scheme using the time-domain transient simulation software PSCAD/EMTDC. [ABSTRACT FROM PUBLISHER]

In this paper, the application method of superconducting fault current limiter (SFCL) for the protection coordination of the protective devices in a power distribution system was analyzed. The SFCL has been announced as better solution among many methods to limit a fault current effectively, which has continuously increased due to more complex network of a power system. However, the application of the SFCL in a power system affects the operation of the protection devices and the protection coordination, which requires the study on the protection coordination of the protective devices considering the application of the SFCL in a power distribution system. [ABSTRACT FROM PUBLISHER]

As the application of low-voltage-direct-current system increases, fault analysis in the low-voltage-direct-current system has essential because the fault response has different from the conventional AC distribution system. Especially, the fault current by the discharge current of the capacitor in the low-voltage-direct-current distribution system has very large compared with the conventional AC distribution system. Therefore, this paper proposed the application of the superconducting fault current limiter for limiting the fault current on the low-voltage-direct-current system. As one of the protected methods against fault current, the superconducting fault current limiter which could quickly limit the fault current has been noticed as an attractive method. However, the protection relay may malfunction such as over current relay, selective protection relay due to limiting fault current by applying superconducting fault current limiter. Therefore, in this paper proposed a solution to malfunction problem of the protection relay using the voltage components of the high temperature superconductivity. This paper verified the effect of the proposed method through test modelling and PSCAD/EMTDC. [ABSTRACT FROM AUTHOR]

In this paper, we propose a protection scheme using a superconducting fault current limiter (SFCL) for the power transmission system with Thyristor Controlled Series Capacitor (TCSC). TCSC can lead effectiveness such as power flow control, increase in transmission capacity, and improvement for system transient phenomena. But, because this has same effect to the reducing series impedances in transmission system, there are serious problem such as increase in fault current, transient stability deterioration and series voltage stress of TCSC in the transmission line. The proposed protection scheme using the SFCL into TCSC configuration can mitigate these problems. In addition, SFCL can be expected to protect the TCSC from a large transient current generated by lightning or switching surge in power transmission system. To verify the effect of the proposed protection scheme, PSCAD/EMTDC is used. From simulation result, we had good results for fault current limitation and insulating protection of TCSC. [ABSTRACT FROM AUTHOR]