Search

This study examines a new finite element/discrete element method (FE-DEM) with interchangeable modeling between FEM and DEM for tire traction analysis. In the method, named iFE-DEM, the soil in a soil bin is modeled initially by FEM except for the region under or near the tire, which is modeled using DEM. When the FEM tire model starts to travel over DEM soil elements, the updated tire location will activate new conversion of modeling from FEM to DEM so that the zone of influence around the contact interface between tire and soil can be analyzed continuously using DEM. Those mobilized DEM elements rearward of the tire might be converted again to FEM elements by assuming that the effect of the stress state in DEM generated by tire travel might be negligible. The computational time for two-dimensional iFE-DEM analysis of a slip of 40% using the smallest region of initial DEM under the tire could be reduced to 23% of that obtained using DEM only soil modeling. [ABSTRACT FROM AUTHOR]

Normal and tangential stresses acting over a contact interface of a tire driven on dry sand were investigated to expand the applicability of our model incorporating 2D FE–DEM with proportional–integral–derivative (PID) control. A simple averaging method for contact reaction was introduced: computational segments were defined over the lower half part of the tire circumference that translates without rotation with the tire; then the contact stresses were calculated segment by segment. For the analysis, it was assumed that the tire was in rigid contact mode and that it would travel on the model sand terrain in stationary condition. The integration of normal and tangential contact stresses with respect to the angle of rotation was then applied to calculate the vertical contact load, gross tractive effort, net traction, and running resistance of the tire by parametric (or semi-empirical) analysis. The result of tractive performance obtained through the parametric analysis was found to be similar to the result of tractive performance obtained directly using FE–DEM analysis. A forward shift of the consistent angle of rotation for maximum normal contact stress and that for maximum tangential contact stress with the increase of slip from 22% was also observed in the FE–DEM result. [ABSTRACT FROM AUTHOR]