Search

Cosmetic hair removal procedures are everyday routines in our society. However, it is unclear if such routines lead to increased uptake of applied substances such as drugs or formulation compounds, potentially resulting in skin irritation or sensitization. The aim of this study was to elucidate the effect of common depilation and epilation methods on skin penetration of two surfactants and four model drugs of different physicochemical properties using the porcine ear model. It should be elucidated whether the substances' skin penetration behavior would be affected by hair removal procedures and if potential effects would be related to their polarity. Confocal Raman spectroscopy revealed no effect of hair removal on total penetration depths of SDS and sulfathiazole. Significantly higher relative penetrated amounts within 0-6 µm of stratum corneum depth were found for SDS after dry shaving, depilatory cream and waxing and for sulfathiazole after all depilation methods and partly after epilation. ATR-FTIR spectroscopy revealed no effect of hair removal on the penetration depth of lecithin LPC80, but higher relative amounts at the skin surface after wet shaving and electric epilation. Diffusion cell experiments using a lecithin-based microemulsion as carrier system for fluconazole, fludrocortisone acetate and flufenamic acid showed higher cumulative amounts, higher drug fluxes and shorter lag times for the more lipophilic drugs for some of the methods, but only shorter lag times in some cases for fluconazole. In summary, the observed effects appeared to depend on drug polarity and experimental setup., (Copyright © 2019 Elsevier B.V. All rights reserved.)

Skin penetration amounts of a highly lipophilic drug, ufenamate, prepared in four oily vehicles, including white petrolatum (WP), liquid paraffin (LP), isopropyl myristate (IPM), and isocetyl stearate (ICS), were compared. Ufenamate was mixed in each vehicle at 5% and applied at a rate of 2 mg/cm 2 to intact, stripped, and delipidized Yucatan micropig skin. The amounts of ufenamate and IPM in the stratum corneum (SC), epidermis, and dermis were determined. The skin penetration amounts of ufenamate from liquid oils were significantly higher than those from WP; the amounts of ufenamate were in the order WP

For some time, in-silico models to address substance transport into and through the skin are gaining more and more importance in different fields of science and industry. In particular, the mathematical prediction of in-vivo skin absorption is of great interest to overcome ethical and economical issues. The presented work outlines a strategy to address this problem and in particular, investigates in-vitro and in-vivo skin penetration experiments of the model compound flufenamic acid solved in an ointment by means of a mathematical model. Experimental stratum corneum concentration-depth profiles (SC-CDP) for various time intervals using two different in-vitro systems (Franz diffusion cell, Saarbruecken penetration model) were examined and simulated with the help of a highly optimized three compartment numerical diffusion model and compared to the findings of SC-CDPs of the in-vivo scenario. Fitted model input parameters (diffusion coefficient and partition coefficient with respect to the stratum corneum) for the in-vitro infinite dose case could be used to predict the in-use conditions in-vitro. Despite apparent differences in calculated partition coefficients between in-vivo and in-vitro studies, prediction of in-vivo scenarios from input parameters calculated from the in-vitro case yielded reasonable results., (Copyright © 2015 Elsevier B.V. All rights reserved.)

In the present study, porcine buccal and vaginal mucosae were successfully characterised by ATR-FTIR for the first time and compared to porcine ear skin. By analysing typical bands of the spectra, the structure of proteins and the lipid matrix were elucidated. According to the body site, differences in membrane permeability were detected when analysing the CH2-stretching and -scissoring vibrations. The results indicated a higher permeability for porcine vaginal and buccal tissue compared to skin. Furthermore, the influence of a lecithin-based microemulsion on the barrier properties of the above mentioned tissues was investigated by ATR-FTIR; the results revealed structural changes in all tissues. In addition, the ATR-FTIR technique was employed to semi-quantitatively analyse compounds directly on skin. To this end, tape stripping experiments were performed with a deuterated liposomal drug delivery system containing the model drug flufenamic acid. While the amount of penetrated deuterated liposomes was determined directly on skin samples by ATR-FTIR, the drug amount was analysed by HPLC after extraction of the tape strips since higher sensitivity was achieved in this fashion. Thus, it was possible to monitor the skin penetration of drug and vehicle simultaneously. Interestingly, the results indicated an independent drug penetration after release from the liposomal carrier system., (Copyright © 2013 Elsevier B.V. All rights reserved.)

This work investigates in vitro finite dose skin absorption of the model compounds flufenamic acid and caffeine experimentally and mathematically. The mass balance in different skin compartments (donor, stratum corneum (SC), deeper skin layers (DSL), lateral skin parts and acceptor) is analyzed as a function of time. For both substances high amounts were found in the lateral skin compartment after 6h of incubation, which emphasizes not to elide these parts in the modeling. Here, three different mathematical models were investigated and tested with the experimental data: a pharmacokinetic model (PK), a detailed microscopic two-dimensional diffusion model (MICRO) and a macroscopic homogenized diffusion model (MACRO). While the PK model was fitted to the experimental data, the MICRO and the MACRO models employed input parameters derived from infinite dose studies to predict the underlying diffusion process. All models could satisfyingly predict or describe the experimental data. The PK model and MACRO model also feature the lateral parts., (Copyright © 2012 Elsevier B.V. All rights reserved.)

Eight nonionic surface-active agents were each incorporated at a concentration of 10% into a white petrolatum ointment base containing 10% flufenamic acid with or without dimethyl sulfoxide. Percutaneous absorption was studied by determining the plasma concentration of flufenamic acid in New Zealand White rabbits at regular intervals for 8 hr following application of the ointment. The percutaneous absorption of flufenamic acid was significantly increased when sorbitan trioleate, polyoxyl 8 stearate, or polyoxyethylene 2 oleyl ether were added to the ointment containing flufenamic acid and white petrolatum. The percutaneous absorption of flufenamic acid was increased significantly when sorbitan monopalmitate, sorbitan trioleate, polyoxyl 8 stearate, polyoxyethylene 20 cetyl ether, or polyoxyethylene 2 oleyl ether were added to the ointment containing dimethylsulfoxide, flufenamic acid, and white petrolatum.