Search

Silicon dioxide (silica, SiO2, SAS) and titanium dioxide (TiO2) are produced in high volumes and applied in many consumer and food products. As a consequence, there is a potential human exposure and subsequent systemic uptake of these particles. In this study we show the characterization and quantification of both total silicon (Si) and titanium (Ti), and particulate SiO2 and TiO2 in postmortem tissue samples from 15 deceased persons. Included tissues are liver, spleen, kidney and the intestinal tissues jejunum and ileum. Low-level analysis was enabled by the use of fully validated sample digestion methods combined with (single particle) inductively coupled plasma high resolution mass spectrometry techniques (spICP-HRMS). The results show a total-Si concentration ranging from <2 to 191 mg Si/kg (median values of 5.8 (liver), 9.5 (spleen), 7.7 (kidney), 6.8 (jejunum), 7.6 (ileum) mg Si/kg) while the particulate SiO2 ranged from <0.2 to 25 mg Si/kg (median values of 0.4 (liver), 1.0 (spleen), 0.4 (kidney), 0.7 (jejunum, 0.6 (ileum) mg Si/kg), explaining about 10% of the total-Si concentration. Particle sizes ranged from 150 to 850 nm with a mode of 270 nm. For total-Ti the results show concentrations ranging from <0.01 to 2.0 mg Ti/kg (median values of 0.02 (liver), 0.04 (spleen), 0.05 (kidney), 0.13 (jejunum), 0.26 (ileum) mg Ti/kg) while particulate TiO2 concentrations ranged from 0.01 to 1.8 mg Ti/kg (median values of 0.02 (liver), 0.02 (spleen), 0.03 (kidney), 0.08 (jejunum), 0.25 (ileum) mg Ti/kg). In general, the particulate TiO2 explained 80% of the total-Ti concentration. This indicates that most Ti in these organ tissues is particulate material. The detected particles comprise primary particles, aggregates and agglomerates, and were in the range of 50–500 nm with a mode in the range of 100–160 nm. About 17% of the detected TiO2 particles had a size <100 nm. The presence of SiO2 and TiO2 particles in liver tissue was confirmed by scanning electron microscopy with energy dispersive X-ray spectrometry. [ABSTRACT FROM AUTHOR]

Detection and characterization of nanoparticles (NPs) in complex media as consumer products, food and toxicological test media is an essential part of understanding the potential benefits and risks of the application of nanoparticles. Single particle ICP-MS (spICP-MS) was studied as a screening tool for the detection and characterization of nanoparticles in complex matrices such as food and biological tissues. A data evaluation tool was created for the calculation of particle size, concentration and size distribution from the raw data. spICP-MS measurements were carried out on a standard quadrupole instrument as well as on a sector-field instrument. Performance characteristics were determined for four types of NPs. For the quadrupole instrument the size detection limits were 20 nm (Au and Ag), 50 (TiO2) and 200 nm (SiO2). For the sector-field instrument size detection limits are lower, 10 nm (Au). Concentration detection limits ranged from 1 ng L−1 for 60 nm Au NPs to 0.1 μg L−1 for 500 nm SiO2 particles. The dynamic range of spICP-MS is limited to two orders of magnitude and as a consequence sample dilution is often required. The precision of the method was found to be ＜5% and ＜10% for the determination of particle size and concentration, respectively while the accuracy for particle size (Au NP only) was ＜10%. The robustness against potential sample matrix components was investigated. The applicability to routine samples was demonstrated by four examples (food, waste water, culture media and biological tissues). The presented combination of spICP-MS measurements with a powerful data evaluation tool enables the use of this technique as a fast, cost efficient and easy to use screening tool for metal and metal oxide NPs that can be widely implemented in the statutory monitoring of food and consumer products for the presence of NPs, as well as in the analytical evaluation of toxicological studies. [ABSTRACT FROM AUTHOR]

Abstract: Since the EFSA enquired a call for data for TBBPA and HBCD in 2009, the analytical determination of these compounds in food became of regulatory interest. Therefore, a method for the simultaneous determination of TBBPA and the three major HBCD stereoisomers was developed. Conventional techniques like soxhlet, ASE, GPC, sulphuric acid digestion, and acidified silica SPE are generally used in sample pre-treatment while detection is mostly performed by LC–MSMS. A combined analysis of HBCD and TBBPA is problematic due to the hydroxyl groups in the TBBPA molecule. However, using a specific mesh-size sodium sulphate in ASE extraction and an acid silica column combined with a Sep-pack Plus silica cartridge for purification resulted in recoveries between 80% and 110% for all compounds. The accuracy and reproducibility determined using proficiency test samples were 104% and 4% for the sum of the HBCD isomers. Typical limits of detection were 0.01ng/g product or 0.004ng on column, while the linear dynamic range is between 0.01ng and 10ng on column. Levels of TBBPA and HBCD isomers were determined in eel samples. TBBPA was occasionally detected and only marginally above the quantification limit of 0.05ng/g, whereas total amounts of HBCD were between 0.2 and 150ng/g with α-HBCD being the dominant HBCD isomer. [Copyright &y& Elsevier]