Search

We present a new S-wave velocity tomographic model of the upper mantle beneath the Australian Plate and its boundaries that we call Aus22. It includes azimuthal anisotropy and was constrained by waveforms from 0.9 million vertical-component seismograms, with the densest data sampling in the hemisphere centred on the Australian continent, using all available data covering this hemisphere. Waveform inversion extracted structural information from surface waves, S- and multiple S-waves and constrained S- and P-wave speeds and S-wave azimuthal anisotropy of the crust and upper mantle, down to the 660-km discontinuity. The model was validated by resolution tests and, for particular locations in Australia with notable differences from previous models, independent inter-station measurements of surface-wave phase velocities. Aus22 can be used to constrain the structure and evolution of the Australian Plate and its boundaries in fine detail at the regional scale. Thick, high-velocity (and, by inference, cold) cratonic lithosphere occupies nearly all of western and central Australia but shows substantial lateral heterogeneity. It extends up to the northern edge of the plate, where it collides with island arcs, without subducting. Diamondiferous kimberlites and lamproite deposits are underlain by cratonic lithosphere, except for the most recent diamondiferous lamproites in the King Leopold Orogen. The rugged eastern boundary of the cratonic lithosphere resolved by the model provides a lithospheric definition of the Tasman Line. Just east of the Tasman Line, an area of intermediate-thick lithosphere is observed in the southern part of the continent. The eastern part of Australia is underlain by thin, warm lithosphere, evidenced by low seismic velocities. All the sites of Cenozoic intraplate volcanism in eastern Australia are located on thin lithosphere. A low-velocity anomaly is present in the mantle transition zone (410–660 km depths) beneath the Lord Howe and Tasmanid hotspots, indicative of anomalously high temperature and consistent with a deep mantle upwelling feeding these hotspots and, possibly, also the East Australia hotspot. High seismic velocities at 200–410 km depth below New Guinea indicate the presence of slab fragments, probably linked to the subduction of the Australian Plate. High seismic velocities are observed in the transition zone below northeast Australia and indicate the presence of subducted lithospheric fragments trapped in the transition zone, possibly parts of the former northern continental margin of Australia. [ABSTRACT FROM AUTHOR]

We present a new global thermochemical model of the lithosphere and underlying upper mantle constrained by state of the art seismic waveform inversion, satellite gravity (geoid and gravity anomalies and gradiometric measurements from ESA's GOCE mission), surface elevation and heat flow data: WINTERC-G. The model is based upon an integrated geophysical–petrological approach where seismic velocities and density in the mantle are computed within a thermodynamically self-consistent framework, allowing for a direct parametrization in terms of the temperature and composition variables. The complementary sensitivities of the data sets allow us to constrain the geometry of the lithosphere–asthenosphere boundary, to separate thermal and compositional anomalies in the mantle, and to obtain a proxy for dynamic surface topography. At long spatial wavelengths, our model is generally consistent with previous seismic (or seismically derived) global models and earlier integrated studies incorporating surface wave data at lower lateral resolution. At finer scales, the temperature, composition and density distributions in WINTERC-G offer a new state of the art image at a high resolution globally (225 km average interknot spacing). Our model shows that the deepest lithosphere–asthenosphere boundary is associated with cratons and, also, some tectonically active areas (Andes, Persian Gulf). Among cratons we identify considerable differences in temperature and composition. The North American and Siberian Cratons are thick (>260 km) and compositionally refractory, whereas the Sino-Korean, Aldan and Tanzanian Cratons have a thinner, fertile lithosphere, similar to younger continental lithosphere elsewhere. WINTERC-G shows progressive thickening of oceanic lithosphere with age, but with significant regional differences: the lithospheric mantle beneath the Atlantic and Indian Oceans is, on average, colder, more fertile and denser than that beneath the Pacific Ocean. Our results suggest that the composition, temperature and density of the oceanic mantle lithosphere are related to the spreading rate for the rates up to 50–60 mm yr–1: the lower spreading rate, the higher the mantle fertility and density, and the lower the temperature. At greater spreading rates, the relationship disappears. The 1-D radial average of WINTERC-G displays a mantle geothermal gradient of 0.55–0.6 K km–1 and a potential temperature of 1300–1320 °C for depths >200 km. At the top of the mantle transition zone the amplitude of the maximum lateral temperature variations (cratons versus hotspots) is about 120 K. The isostatic residual topography values, a proxy for dynamic topography, are large (>1 km) mostly in active subduction settings. The residual isostatic bathymetry from WINTERC-G is remarkably similar to the pattern independently determined based on oceanic crustal data compilations. The amplitude of the continental residual topography is relatively large and positive (>600 m) in the East European Craton, Greenland, and the Andes and Himalayas. By contrast, central Asia, most of Antarctica, southern South America and, to a lesser extent, central Africa are characterized by negative residual topography values (>–400 m). Our results show that a substantial part of the topography signal previously identified as residual (or dynamic) is accounted for, isostatically, by lithospheric density variations. [ABSTRACT FROM AUTHOR]

We present a tomographic model of the crust, upper mantle and transition zone beneath the South Atlantic, South America and Africa. Taking advantage of the recent growth in broadband data sampling, we compute the model using waveform fits of over 1.2 million vertical-component seismograms, obtained with the automated multimode inversion of surface, S and multiple S waves. Each waveform provides a set of linear equations constraining perturbations with respect to a 3-D reference model within an approximate sensitivity volume. We then combine all equations into a large linear system and solve it for a 3-D model of S - and P -wave speeds and azimuthal anisotropy within the crust, upper mantle and uppermost lower mantle. In South America and Africa, our new model SA2019 reveals detailed structure of the lithosphere, with structure of the cratons within the continents much more complex than seen previously. In South America, lower seismic velocities underneath the transbrasilian lineament (TBL) separate the high-velocity anomalies beneath the Amazon Craton from those beneath the São Francisco and Paraná Cratons. We image the buried portions of the Amazon Craton, the thick cratonic lithosphere of the Paraná and Parnaíba Basins and an apparently cratonic block wedged between western Guyana and the slab to the west of it, unexposed at the surface. Thick cratonic lithosphere is absent under the Archean crust of the São Luis, Luis Álves and Rio de La Plata Cratons, next to the continental margin. The Guyana Highlands are underlain by low velocities, indicating hot asthenosphere. In the transition zone, we map the subduction of the Nazca Plate and the Chile Rise under Patagonia. Cratonic lithosphere beneath Africa is more fragmented than seen previously, with separate cratonic units observed within the West African and Congo Cratons, and with cratonic lithosphere absent beneath large portions of Archean crust. We image the lateral extent of the Niassa Craton, hypothesized previously and identify a new unit, the Cubango Craton, near the southeast boundary of the grater Congo Craton, with both of these smaller cratons unexposed at the surface. In the South Atlantic, the model reveals the patterns of interaction between the Mid-Atlantic Ridge (MAR) and the nearby hotspots. Low-velocity anomalies beneath major hotspots extend substantially deeper than those beneath the MAR. The Vema Hotspot, in particular, displays a pronounced low-velocity anomaly under the thick, high-velocity lithosphere of the Cape Basin. A strong low velocity anomaly also underlies the Cameroon Volcanic Line and its offshore extension, between Africa and the MAR. Subtracting the global, age-dependent VS averages from those in the South Atlantic Basins, we observe areas where the cooling lithosphere is locally hotter than average, corresponding to the location of the Tristan da Cunha, Vema and Trindade hotspots. Beneath the anomalously deep Argentine Basin, we image unusually thick, high-velocity lithosphere, which suggests that its anomalously great depth can be explained, at least to a large extent, by isostatic, negative lithospheric buoyancy. [ABSTRACT FROM AUTHOR]