Search

The increasing impact of climate change has worsened drought conditions, leading to a surge in the demand for seawater desalination. However, current seawater reverse osmosis (SWRO) desalination technologies are not energy-efficient for handling the high-salinity, high-temperature, and high-turbidity seawater found in the Arabian Gulf. Therefore, a pilot-scale SWRO desalination plant was established to evaluate the new desalination technologies. The pilot plant tested high-performance SWRO membranes, meshed tube filtration (MTF) as a low-energy pretreatment for the high turbidity induced by algal blooms, and membrane capacitive deionization (MCDI) to improve permeate quality. The high-performance SWRO membrane demonstrated exceptional salt rejection and produced permeate quality in the range of 250–455 mg/L from the feed with salinities of 47,500–53,500 mg/L. MTF was effective in controlling turbidity, and the energy consumption was reduced by 77 % compared to the existing pretreatment process. Furthermore, MCDI exhibited similar levels of energy efficiency as brackish water reverse osmosis and may have the potential for future deployment by enhancing process development. Based on the pilot plant results, it is expected that a 100,000–200,000 m3/d SWRO desalination plant will have a specific energy consumption of 3.11–3.13 kWh/m3 for final product water quality at or below 200 mg/L. [Display omitted] • A pilot-scale SWRO desalination plant was used to investigate low-energy technologies. • Developed SWRO membranes significantly decreased feed TDS under normal pressure. • MTF reduced feed turbidity effectively and consumed lower energy compared to DAF. • MCDI demonstrated potential as a substitute for BWRO in two-pass RO systems. • The SEC of SWRO desalination plants was evaluated as 3.11 kWh/m3 through scale-up. [ABSTRACT FROM AUTHOR]

Brine management systems are imperative for sustainable water supply and for securing valuable resources from desalination plants. The utilization of membrane brine concentrators has recently been focused on because of their high energy and cost efficiencies compared with those of thermal brine concentrators. In this paper, we investigated the recent candidates of membrane concentrators in terms of their future potential in brine management systems and categorized the types of utilized membranes into two groups: single solution passing (SSP)-type membranes and double solution passing (DSP)-type membranes. The current membrane technologies for manufacturing these types of membranes were critically analyzed, and future directions for membrane development towards efficient brine management systems were suggested. SSP-type membranes and their accompanying systems should be durable at pressures higher than 230 bar to utilize membrane brine concentrators. On the other hand, DSP-type membranes should exhibit high-pressure durability (higher than 40 bar) and low structure parameters (less than 50 μm). This study examines the current status of membrane systems and presents the technical specifications of membranes required for membrane brine management systems. [Display omitted] • Brine management systems using membrane concentrators are summarized and analyzed. • Two types of membranes are classified in the applications of membrane concentrators. • The required specifications of membranes are determined for membrane concentrators. • Future directions for membrane development are suggested towards brine management. [ABSTRACT FROM AUTHOR]

Pressure retarded osmosis (PRO) harnesses salinity gradient energy through the mixing of freshwater and saltwater, addressing the demand for sustainable energy sources. PRO typically utilizes river water or secondary wastewater as the feed solution, paired with seawater reverse osmosis (SWRO) brine as the draw solution. However, the limited availability of low-saline water presents a significant obstacle to energy generation. Therefore, the feasibility of a high-pressure PRO process utilizing seawater as the feed solution and hypersaline water as the draw solution was assessed to generate sustainable blue energy. Seawater has the potential to achieve the maximum extractable Gibbs-free energy through high-pressure PRO by maximizing the feed/draw ratio. The performance of the high-pressure PRO was theoretically evaluated, resulting in a tenfold increase in specific energy production compared to conventional SWRO-PRO due to the higher feed/draw ratio. However, high hydraulic pressure increased the membrane structural parameter and further reduced water flux and power density due to significant internal concentration polarization. Nevertheless, the high-pressure PRO process can achieve a power density exceeding 84 W/m2 when the structural parameter remains below 100 μm. The implications of the high-pressure PRO were further discussed to advance the concept of a blue circular economy, enhance environmental resilience, and promote sustainability. [Display omitted] • Feasibility of high-pressure PRO was investigated using seawater/hypersaline water. • Higher feed/draw ratio boosted energy production in the PRO process. • Seawater was assessed as a feed for high-pressure PRO for blue energy generation. • High-pressure operation raised the structural parameter reducing power density. • High-pressure PRO achieved >80 W/m2 at structural parameter <100 μm. [ABSTRACT FROM AUTHOR]

Owing to the significant increase in seawater desalination, seawater exhibiting extreme conditions of high salinity and high temperature cannot be avoided in the production of fresh water. Although seawater reverse osmosis (SWRO) is one of the most energy-saving desalination technologies, it might not be favorable for treating extreme seawater due to the operational limitations associated with the single-stage SWRO configuration. To overcome these limitations, the applicability of two-stage SWRO was examined. The recovery of single-stage SWRO was limited to 31% for stable operation, whereas two-stage SWRO, utilizing pressure exchangers as energy recovery devices, achieved 34% recovery for the same number of pressure vessels. Furthermore, the maximum water fluxes in the front SWRO elements were reduced under the design constraints of the two-stage configuration than that of the single-stage configuration. The two-stage SWRO system was energy-efficient with high recovery; however, under extreme conditions, the permeate quality was similar to that of single-stage SWRO. To improve the applicability of two-stage SWRO, internally staged design (ISD) and split partial second pass (SPSP) can be adopted. ISD can reduce water fluxes in the front elements, increasing system recovery, whereas SPSP design enables the reverse osmosis system to produce high-quality permeate with low additional energy. Unlabelled Image • SWRO performance was evaluated for high-salinity and high-temperature seawater. • Single-stage SWRO suffered from low recovery and high water flux for front elements. • Two-stage SWRO achieved higher recovery and exhibited lower front water flux. • ISD further increased recovery by reducing water fluxes of front elements. • SPSP improved product quality and energy efficiency by treating rear permeate. [ABSTRACT FROM AUTHOR]

Seawater reverse osmosis (SWRO) is usually combined with brackish reverse osmosis (BWRO) to improve the water quality in seawater desalination; however, this configuration often results in high energy consumption. Consequently, membrane capacitive deionization (MCDI) has been suggested as a lower energy alternative technology, but cyclic operation within the cell (i.e., discontinuous operation of ad/desorption) is a main disadvantage. On the other hand, flow electrode capacitive deionization (FCDI) can be continuously operated by using a flow electrode. In this study, the feasibility of a SWRO-FCDI system was examined by using a suitable electrolyte in the flow electrode: seawater or SWRO concentrate. In addition, by employing a selective ion exchange membrane (IEM), the FCDI was able to selectively remove monovalent ions rather than divalent ions, unlike BWRO, thus producing a final product water containing divalent ions, which is more suitable for corrosion control in the subsequent pipe distribution systems. As a result, the remineralization process can be minimized. To test the SWRO-FCDI concept, actual SWRO permeate was first treated in a single mode with an electrolyte comprising real seawater in a flow electrode, and the feasibility of long-term operation was proven by batch-mode, which allowed the optimization of the FCDI active area. Unlabelled Image • The feasibility of a SWRO-FCDI system for low-energy desalination was examined. • Simulated seawater and SWRO concentrate were tested as electrolytes in FCDI. • FCDI removed divalent ions over monovalent ions with 30% higher efficiency. • Actual SWRO permeate was treated by FCDI using with a real seawater electrolyte. • In the batch mode, over 95% removal efficiency was achieved at a 1.3 kWh/m3. [ABSTRACT FROM AUTHOR]

While single-stage is the general configuration for seawater reverse osmosis (SWRO), the two-stage design can increase the overall recovery of an SWRO system. Due to its high-recovery operation, the specific energy consumption (SEC) of two-stage SWRO is higher than that of single-stage. Thus, the two-stage configuration has not been extensively applied in the current desalination market. In contrast, recent studies have reported that the two-stage design can lower the SEC of SWRO compared to that of single-stage. However, the analyses were biased towards SEC, and the practical design aspects (e.g., permeate quality, water flux, and design ratios) were not systemically considered. Thus, this study examines the applicability of a two-stage SWRO system with a capacity of 100,000 m3/d that employs 1200 pressure vessels (PVs). Two-stage SWRO actually consumed a greater amount of energy than that of single-stage for typical SWRO recovery with the same number of PVs. In contrast, single- and two-stage SWRO produced permeate similar in quality, while the two-stage exhibited superior water-flux distribution along the PVs. Additionally, optimal ratios of permeate flow rate and number of PVs were determined by energy recovery devices type, where the ratio of 1:2 was selected for the reverse osmosis system with a pressure exchanger and 2:1 for that with a Pelton turbine. Considering SEC and other operational aspects, the use of two-stage SWRO was feasible at a 50–70% recovery rate. Image 1 • Two-stage SWRO is fundamentally analyzed and optimized for seawater desalination. • SEC of two-stage SWRO is higher than that of single-stage in typical recovery. • Water quality of single- and two-stage SWRO is similar at the same average flux. • Optimal ratios of permeate flow rate and number of PVs vary depending on ERD types. • Two-stage SWRO is more energy-efficient at a high recovery rate (e.g., 50–70%). [ABSTRACT FROM AUTHOR]

Harmful algal blooms (HABs) are a major barrier to the stable and efficient operation of seawater reverse osmosis (SWRO) desalination plants. Although the intensity varies regionally, the occurrence of HABs impairs plant operation through severe particulate, organic, and biological fouling of both pretreatment and RO systems. As a result, considerable effort has been put into developing and optimizing pre-treatment techniques to mitigate these problems. This study reviews the historical changes and current status of pretreatment applications based on >110 datasets for large SWRO desalination plants. Chronological analysis underscores the increasing trend in the operation of dissolved air flotation and ultrafiltration systems since severe HABs in the Middle East from 2008 to 2009. The impact of HAB characteristics on system performance was also analyzed, and the efficiency of current pretreatment systems for the removal of HABs was evaluated, along with proposals for operational guidelines. Finally, future strategies for i) intelligent monitoring and prediction of HABs, ii) improvement of unit processes for the removal of algal organic matter, and iii) utilization of algal biomass to alleviate environmental impact were systematically delineated for smarter, safer, and greener operation of future SWRO desalination plants in response to the occurrence of HABs. [Display omitted] • Review on the impact of harmful algal blooms (HABs) on seawater desalination • Analysis of >110 datasets of full-scale SWRO desalination plants • Historical trends and current practice of pretreatment applications • Guidelines for pretreatment operation under HABs occurrences • Future operational directions for smarter, safer and greener desalination practice [ABSTRACT FROM AUTHOR]