Search

In this study, we investigated the process of preconcentrate and determine trace amounts of Auramine O (AO) and methylene blue (MB) dyes in environmental water samples. For this purpose, the ultrasound-assisted dispersive-magnetic nanocomposites-solid-phase microextraction (UA-DMNSPME) method was performed to extract AO and MB from aqueous samples by applying magnesium oxide nanoparticles (MgO-NPs). The proposed technique is low-cost, facile, fast, and compatible with many existing instrumental methods. Parameters affecting the extraction of AO and MB were optimized using response surface methodology (RSM). Short extraction time, low experimental tests, low consumption of organic solvent, low limits of detection (LOD), and high preconcentration factor (PF) was the advantages of method. The PF was 44.5, and LOD for AO and MB was 0.33 ng mL−1 and 1.66 ng mL−1, respectively. The linear range of this method for AO and MB were 1–1000 ng mL−1 and 5–2000 ng mL−1, respectively. In addition, the relative standard deviation (RSD; n = 5) of the mentioned analytes was between 2.9% and 3.1%. The adsorption–desorption studies showed that the efficiency of adsorbent extraction had not declined significantly up to 6 recycling runs, and the adsorbent could be used several times. The interference studies revealed that the presence of different ions did not interfere substantially with the extraction and determination of AO and MB. Therefore, UA-DMNSPME-UV/Vis method can be proposed as an efficient method for preconcentration and extraction of AO and MB from water and wastewater samples. [ABSTRACT FROM AUTHOR]

• Initial study by ultrasound-assisted dispersive solid-phase extraction using magnesium ferrite as a magnetic adsorbent. • The spectrophotometric method was successfully applied. • Response surface methodology was used to optimize the extraction of dyes. • The proposed method was sensitive, fast, inexpensive, reliable, simple, and eco-friendly. This study aimed to determine of malachite green (MG) and auramine O (AO) dyes in different environmental water samples. For this purpose, MG and AO dyes were pre-concentrated by ultrasound-assisted dispersive solid-phase extraction (UA-DSPE) and measured by spectrophotometry. Magnesium ferrite (MgFO) was applied as a magnetic adsorbent in the UA-DSPE-UV/Vis method. The effect of different parameters on the dye extraction efficiency, including pH of the solution, sorbent mass, sample volume, ultrasound frequencies, irradiation time, and type and volume of eluent, were investigated. In addition, response surface methodology (RSM) approach-based central composite design (CCD) was used to design and optimize parameters affecting the process. Analysis of variance (ANOVA) results based on high F-values, low p-values, coefficient of determination (R2 > 0.99), and adjusted-R2 (R2adj > 0.99) revealed that the quadratic model was the best model for defining the interaction of the studied variables. The calibration curve, the limit of detection (LOD), and relative standard deviation (RSD, n = 5) for MG and AO dyes were 1–800 ng mL−1 and 3–1200 ng mL−1, 0.33 ng mL−1 and 1 ng mL−1, and 3.2% and 2.8%, respectively. The effect of some external species (including cations and anions) on the determination of MG and AO dye was investigated. The results revealed that adding different ions does not significantly interfere with determining MG and AO dyes. The reusability of the MgFO adsorbent showed that it could be reused for up to 7 cycles, maintaining its high efficiency in the extraction of MG and AO dyes. Moreover, the proposed method was used for the extraction of MG and AO dyes from different water samples. The obtained extraction efficiency was in the range of 95.37–99.54%. [ABSTRACT FROM AUTHOR]