Search

This article discusses the development and analysis of a broadband filter capable of suppressing specific frequencies of wireless applications at 4.7 GHz for WLAN, 8.3 GHz, and 11.5 GHz (for satellite communication) by combining a T-shaped stub loaded resonator with a central square ring to achieves high performance and compact size within the bandwidth of interest. The filter achieves low signal loss of 0.4 dB across the entire passband of 14.9 GHz bandwidth, good reflection suppression exceeding 10 dB, and independently adjustable multi stopbands. It utilizes a simple planar topology for a small footprint of 0.52 λ g × 0.32 λ g , where λ g represents the wavelength at 4.7 GHz. The proposed filter evaluated using classical method an even-odd-mode analysis, and a 3D software tool HFSS-15 is used for simulations. The physical prototype is built on a Rogers RO-4350 substrate using LPKF S63 ProtoLaser machine. To confirm the accuracy and performance of the prototype, measurements were conducted using a ZNB20 vector network analyser. The simulations and measurement results confirm its effectiveness, paving the way for applications in various fields such as radar systems, medical imaging, and wireless communication. [ABSTRACT FROM AUTHOR]

Designing microwave filters with high selectivity and sharp roll-off between the stop and pass bands can be challenging due to the complex nature of the R.F. signals and the requirements for achieving high performance in a limited physical space. To achieve a high selectivity and sharp roll-off rate, this paper presents a compact filter with a triple passband response. The two different passbands at 1.57 GHz and 3.5 GHz are achieved using a step impedance resonator (SIR) with metallic slots perturbation added to the lower corner of the high impedance section of the SIRs, which helps to enhance the filter's selectivity and size reduction greatly. The embedded L-shaped structure originates a third passband at 4.23 GHz, resulting in a triband response with eight transmission zeros below and above the passbands at 1.22/1.42/1.98/3.18/3.82/3.98/4.38/4.53 GHz, respectively. The prototype has low signal attenuation of <1.2 dB and high signal reflection of >25 dB for the three passbands. The fractional bandwidths achieved are 2.54%, 4.2%, and 1.65% at 1.57/3.57/4.23 GHz, respectively, with rejection levels in the stopband greater than 15 dB. Lastly, the structure is fabricated on RO-4350B PCB and observed good matching between experimental and measured results. This demonstrates that the prototype can be successfully implemented in real-world applications such as GPS, WiMAX, and Satellite systems. The area occupied by the filter on a substrate or in a circuit is 0.31 λg × 0.24 λg, where λg is the guided wavelength of the material calculated at the lowest frequency. [ABSTRACT FROM AUTHOR]