Search

A new algorithm (Xcounts) is introduced for estimating the activity concentrations of the xenon isotopes 131mXe, 133mXe, 133Xe, and 135Xe using beta-gamma coincidence data. The algorithm simultaneously estimates the decay counts associated with the four xenon isotopes, background, and radon in contrast to the net-counts method that uses sequential residual removal to account for background and interferences. Calibration data for background counts are determined from gas-background measurements and simulation. In Xcounts, the false positive count rates for 131mXe and 133mXe are lower than those for 133Xe and 135Xe. This algorithm appears to reliably detect the metastable isotopes at lower activity levels than the net-counts method and have similar performance for the other isotopes. • New approach for estimating radioxenon activity concentrations in air. • Approach uses simultaneous isotope count estimation using beta-gamma coincidence data. • Background and radon daughter counts are estimated rather than subtracted. • Performance compares well with existing models for 133Xe and 135Xe. • Detection limits for 131mXe and 133mXe are lower than for net-count based algorithms. [ABSTRACT FROM AUTHOR]

Absolute efficiency calibration of radiometric detectors is frequently difficult and requires careful detector modeling and accurate knowledge of the radioactive source used. In the past we have calibrated the β–γ coincidence detector of the Automated Radioxenon Sampler/Analyzer (ARSA) using a variety of sources and techniques which have proven to be less than desirable (Reeder et al., J Radioanal Nucl Chem, 235, 1989). A superior technique has been developed that uses the conversion-electron (CE) and X-ray coincidence of 131mXe to provide a more accurate absolute gamma efficiency of the detector. The 131mXe is injected directly into the beta cell of the coincident counting system and no knowledge of absolute source strength is required. In addition, 133Xe is used to provide a second independent means to obtain the absolute efficiency calibration. These two data points provide the necessary information for calculating the detector efficiency and can be used in conjunction with other noble gas isotopes to completely characterize and calibrate the ARSA nuclear detector. In this paper we discuss the techniques and results that we have obtained. [ABSTRACT FROM AUTHOR]

The Source Term Analysis of Xenon (STAX) project has been installing stack detectors at medical isotope production facilities to measure radioxenon emissions to investigate the effect of radioxenon releases on nuclear explosion monitoring. This paper outlines the installation of the first STAX detection system at the National Institute for Radioelements (IRE) in Fleurus, Belgium which has been operating for over three years and transferring collected data to the STAX repository. Information about the equipment installed, the data flow established, and calculations for determination of radioxenon releases from the facility are presented. Data quality was investigated to confirm values reported by STAX automated data processing and in a comparison of collected STAX data with data collected by IRE for regulatory reporting. • A STAX detection system was installed at the National Institute for Radioelements. • The detection system has been operating for over three years. • The system is integral to development of project data transfer, storage, and visualization tools. • STAX data was analyzed to verify calculations for reported release values. • Equipment performance for approximately two years of operation is discussed. [ABSTRACT FROM AUTHOR]