Search

Microdosimetry is a particularly powerful method to estimate the relative biological effectiveness (RBE) of any mixed radiation field. This is particularly convenient for therapeutic heavy ion therapy (HIT) beams, referring to ions larger than protons, where the RBE of the beam can vary significantly along the Bragg curve. Additionally, due to the sharp dose gradients at the end of the Bragg peak (BP), or spread out BP, to make accurate measurements and estimations of the biological properties of a beam a high spatial resolution is required, less than a millimetre. This requirement makes silicon microdosimetry particularly attractive due to the thicknesses of the sensitive volumes commonly being ∼10 m or less. Monte Carlo (MC) codes are widely used to study the complex mixed HIT radiation field as well as to model the response of novel microdosimeter detectors when irradiated with HIT beams. Therefore it is essential to validate MC codes against experimental measurements. This work compares measurements performed with a silicon microdosimeter in mono-energetic , and ion beams of therapeutic energies, against simulation results calculated with the Geant4 toolkit. Experimental and simulation results were compared in terms of microdosimetric spectra (dose lineal energy,), the dose mean lineal energy, y D and the RBE10, as estimated by the microdosimetric kinetic model (MKM). Overall Geant4 showed reasonable agreement with experimental measurements. Before the distal edge of the BP, simulation and experiment agreed within ∼10% for y D and ∼2% for RBE10. Downstream of the BP less agreement was observed between simulation and experiment, particularly for the and beams. Simulation results downstream of the BP had lower values of y D and RBE10 compared to the experiment due to a higher contribution from lighter fragments compared to heavier fragments. [ABSTRACT FROM AUTHOR]

Using the CMRP ‘bridge' μ + probe, microdosimetric measurements were undertaken out-of-field using a therapeutic scanning proton pencil beam and in-field using a 12C ion therapy field. These measurements were undertaken at Mayo Clinic, Rochester, USA and at HIMAC, Chiba, Japan, respectively. For a typical proton field used in the treatment of deep-seated tumors, we observed dose-equivalent values ranging from 0.62 to 0.99 mSv/Gy at locations downstream of the distal edge. Lateral measurements at depths close to the entrance and along the SOBP plateau were found to reach maximum values of 3.1 mSv/Gy and 5.3 mSv/Gy at 10 mm from the field edge, respectively, and decreased to ~0.04 mSv/Gy 120 mm from the field edge. The ability to measure the dose-equivalent with high spatial resolution is particularly relevant to healthy tissue dose calculations in hadron therapy treatments. We have also shown qualitatively and quantitively the effects critical organ motion would have in treatment using microdosimetric spectra. Large differences in spectra and RBE10 were observed for treatments where miscalculations of 12C ion range would result in critical structures being irradiated, showing the importance of motion management. [ABSTRACT FROM AUTHOR]

The CERN-EU high-energy reference field facility is used for testing and calibrating both active and passive radiation dose-meters for radiation protection applications in space and aviation. Through a combination of a primary particle beam, target and a suitable designed shielding configuration, the facility is able to reproduce the neutron component of the high altitude radiation field relevant to the jet aviation industry. Simulations of the facility using the GEANT4 (GEometry ANd Tracking) toolkit provide an improved understanding of the neutron particle fluence as well as the particle fluence of other radiation components present. The secondary particle fluence as a function of the primary particle fluence incident on the target and the associated dose equivalent rates were determined at the 20 designated irradiation positions available at the facility. Comparisons of the simulated results with previously published simulations obtained using the FLUKA Monte Carlo code, as well as with experimental results of the neutron fluence obtained with a Bonner sphere spectrometer, are made. [ABSTRACT FROM AUTHOR]

Recent developments in the fabrication and simulation of prototype silicon-on-insulator (SOl) microdosimeter arrays are presented. A new planar array design has been proposed which has a number of advantages over the previous elongated parallelepiped and cylindrical mesa array designs. This novel planar array design, which incorporates a guard ring, is based upon 2500 planar cylindrically shaped p-i-n detectors and was fabricated via dopant diffusion and ion implantation. The dopant-diffused arrays were successfully fabricated and tested using 2 μm and 10-μm-thick SOl substrates. Technology computer-aided design modeling of the ion-implanted structure is presented which includes the electrostatic potential profile, showing possible avalanche signal multiplication around the n+ core of the microdosimeter. The alpha particle charge transient response was simulated to determine the charge collection in the sensitive region. [ABSTRACT FROM AUTHOR]