Search

Radiometals play a fundamental role in the development of personalized nuclear medicine. In particular, copper radioisotopes are attracting increasing interest since they offer a varying range of decay modes and half-lives and can be used for imaging (60Cu, 61Cu, 62Cu and 64Cu) and targeted radionuclide therapy (64Cu and 67Cu), providing two of the most promising true theranostic pairs, namely 61Cu/67Cu and 64Cu/67Cu. Currently, the most widely used in clinical applications is 64Cu, which has a unique decay scheme featuring β+-, β--decay and electron capture. These characteristics allow its exploitation in both diagnostic and therapeutic fields. However, although 64Cu has extensively been investigated in academic research and preclinical settings, it is still scarcely used in routine clinical practice due to its insufficient availability at an affordable price. In fact, the most commonly used production method involves proton irradiation of enriched 64Ni, which has a very low isotopic abundance and is therefore extremely expensive. In this paper, we report on the study of two alternative production routes, namely the 65Cu(p,pn)64Cu and 67Zn(p, α)64Cu reactions, which enable low and high 64Cu specific activities, respectively. To optimize the 64Cu production, while minimizing the mass of copper used as a target in the first case, or the co-production of other copper radioisotopes in the second case, an accurate knowledge of the production cross sections is of paramount importance. For this reason, the involved nuclear reaction cross sections were measured at the Bern medical cyclotron laboratory by irradiating enriched 65CuO and enriched 67ZnO targets. On the basis of the obtained results, the production yield and purity were calculated to assess the optimal irradiation conditions. Several production tests were performed to confirm these findings.

The half-lives of 44Sc and 44mSc were measured by following their decay rate using several measurement systems: two ionization chambers and three γ-spectrometry detectors with digital and/or analogue electronics. For 44Sc, the result was the combination of seven half-life values giving a result of 4.042(7) h, which agrees with the last reported value of 4.042(3) h and confirms the near to 2% deviation from the recommended half-life of 3.97(4) h. Scandium-44 is present as an impurity in the production of 44Sc by cyclotron proton irradiation. Its half-life was determined by measurements performed a few days after End of Bomardment (EoB), so that the 44Sc decayed down to a negligible level. Seven measurements were combined to obtain an average of 58.7(3) h, which is in agreement with the recommended value of 58.6(1) h.

The availability of novel radionuclides plays a fundamental role in the development of personalized nuclear medicine. In particular, there is growing interest in pairs formed by two radioisotopes of the same element, the so-called true theranostic pairs, such as 61,64Cu/67Cu, 43,44Sc/47Sc and 155Tb/149,161Tb. In this case, the two radionuclides have identical kinetics and chemical reactivity, allowing to predict whether the patient will benefit from a therapeutic treatment on the basis of nuclear imaging data. 47Sc [t1/2 = 3.349 d, E [Formula: see text] = 440.9 keV (68.4%); 600.3 keV (31.6%), Eγ = 159.4 keV (68.3%)] is a promising radionuclide for theranostic applications in nuclear medicine. Its physical characteristics make it suitable for radionuclide therapy and allow SPECT imaging during treatment. Moreover, 47Sc is foreseen as the therapeutic partner of the β+-emitters 43Sc and 44Sc, both under study for PET imaging, opening new avenues towards the true theranostics concept. 47Sc can be produced by proton irradiation of an enriched 50Ti oxide target with a medical cyclotron equipped with a solid target station. To optimize the production yield and the radionuclidic purity, an accurate knowledge of the production cross sections is necessary. In this paper, we report on measurements of the production cross section of 47Sc and 46Sc using enriched 50Ti titanium oxide targets, performed at the Bern University Hospital cyclotron laboratory. On the basis of the obtained results, a study of the production yield and purity was performed to assess the optimal irradiation conditions. A production test was also carried out to confirm these findings.

The availability of novel medical radionuclides is a key point in the development of personalised nuclear medicine. In particular, copper radioisotopes are attracting considerable interest as they can be used to label various molecules of medical interest, such as proteins and peptides, and offer two of the most promising true theranostic pairs, namely 61Cu/67Cu and 64Cu/67Cu. Although 64Cu (t1/2 = 12.7006 h, β+: 17.6%, β-: 38.5%) is nowadays the most commonly used as a diagnostic radionuclide, 61Cu (t1/2 = 3.339 h, β+: 61%) features more favourable nuclear properties, such as a higher positron decay fraction and the absence of β- emissions. To date, the production of 61Cu has been carried out irradiating highly enriched 61Ni targets with a low energy proton beam. However, the use of the very expensive 61Ni targets requires an efficient recovery of the target material and makes this method quite inconvenient. Another promising production route is the proton irradiation of natural Zn or enriched 64Zn targets, exploiting the (p,α) nuclear reaction. Along this line, a research program is ongoing at the Bern medical cyclotron, equipped with an external beam transfer line and a solid target station. In this paper, we report on cross-section measurements of the 64Zn(p,α)61Cu nuclear reaction using natural Zn and enriched 64Zn material, which served as the basis to perform optimized 61Cu production tests with solid targets.

155Tb [t1/2 = 5.32 d, Eγ = 87 keV (32%); 105 keV (25%) (IAEA, 2021)] is a novel promising radionuclide for theranostic applications in nuclear medicine. Its physical properties make it suitable for single photon emission computed tomography (SPECT) imaging, while its chemistry allows it to be used as a diagnostic partner for therapeutic radiolanthanides or pseudo-radiolanthanides, such as 177Lu and 90Y. Moreover, 155Tb could be used as a precise diagnostic match for the β−-emitter 161Tb, opening doors for the true theranostics concept. The availability of 155Tb in quantity and quality suitable for medical applications is an open issue and its production with medical cyclotrons via the 155Gd(p,n)155Tb and 156Gd(p,2n)155Tb nuclear reactions represents a possible but challenging solution. For this purpose, an accurate knowledge of the production cross sections is mandatory. In this paper, we report on the measurement of the production cross sections of 155Tb and other terbium radionuclides formed by proton irradiation of natGd2O3, 155Gd2O3 and 156Gd2O3 enriched targets, performed at the Bern University Hospital cyclotron laboratory. On the basis of the obtained results, the production yield and purity were calculated to assess the optimal irradiation conditions. The results of several production tests are also presented., Applied Radiation and Isotopes, 184, ISSN:0969-8043, ISSN:1872-9800