Search

The filtered backprojection (FBP) algorithm is viewed as a preferred candidate for general bistatic synthetic aperture radar (BiSAR) imaging since it does not pose any restrictions on SAR configurations or flight paths. However, high-efficient autofocus methods such as phase gradient autofocus (PGA) or Mapdrift (MD) cannot be effectively integrated with the FBP algorithm due to the unknown properties of the BiSAR FBP imagery spectrum. In this article, a novel Fourier-based interpretation of the BiSAR FBP algorithm is presented. Based on the new viewpoint, spectral characteristics of the BiSAR FBP imagery in the wavenumber domain, including range spectral ambiguity, space-variant spectral support, and the structural 2-D phase error, are derived in detail. Using these characteristics, a computationally efficient 2-D autofocus approach is proposed. First, a preprocessing is performed to eliminate the range spectral ambiguity and to align the skewed spectrum support, which facilitates the following phase error estimation and correction. Then, an estimation of the 1-D azimuth phase error (APE) is applied by combining multiple estimation results from different subband data. Finally, the 2-D phase error is computed directly from the estimated APE by exploiting the derived analytical structure of the 2-D phase error, which is then applied to restore the BiSAR FBP image. The simulation results are presented to show the effectiveness of the proposed approach. [ABSTRACT FROM AUTHOR]

A 360° video synthetic aperture radar (VideoSAR) appears as an interactive observation capability to understand the dynamic scenarios. VideoSAR system mounted on an unmanned aerial vehicle (UAV) delivers a highly flexible and cost-effective approach. In this letter, the UAV-borne repeat-pass circular stripmap (CSM) VideoSAR observation is formulated in the format of video area overflown to enhance the wide-area surveillance capability. A completely two-dimensional interpolation-free polar format algorithm is employed, especially in terms of repeat-pass CSM-VideoSAR configuration. We conduct the repeat-pass CSM-VideoSAR experiments on multirotor UAV-borne system in the interests of imaging demonstration and promoting the inspirations on the related open issues. [ABSTRACT FROM AUTHOR]

An alternate transmitting mode (ATM) is an important synthetic aperture radar (SAR) imaging mode as it can provide rich waveform design degrees of freedom to improve the system performance, especially to mitigate range ambiguities. However, the azimuth ambiguity issue caused by the differences between the autocorrelation functions of transmitted waveforms is ignored in existing studies. In this article, a deep understanding of the ambiguities in the ATM allows a correct evaluation of the ambiguity-to-signal ratio and the design of quasi-orthogonal nonlinear frequency modulation (NLFM) waveforms optimized for ambiguity suppression. Moreover, a novel azimuth compensation method is developed to remove the azimuth ambiguities caused by waveform diversity. Finally, detailed simulation experiments are carried out to verify the theoretical analysis. [ABSTRACT FROM AUTHOR]

The filtered backprojection (FBP) algorithm is a popular choice for complicated trajectory synthetic aperture radar (SAR) image formation processing due to its inherent nonlinear motion compensation capability. However, how to efficiently refocus the defocused FBP imagery when the motion measurement is not accurate enough is still a challenging problem. In this paper, a new interpretation of the FBP derivation is presented from the Fourier transform point of view. Based on this new viewpoint, the property of the residual 2-D phase error in FBP imagery is analyzed in detail. Then, by incorporating the derived a priori knowledge on the 2-D phase error, an accurate and efficient 2-D autofocus approach is proposed. This new approach performs the parameter estimation in a dimension-reduced parameter subspace by exploiting the a priori analytical structure of the 2-D phase error, therefore it possesses much higher accuracy and efficiency than the conventional blind methods. Finally, experimental results clearly demonstrate the effectiveness and robustness of the proposed method. [ABSTRACT FROM AUTHOR]

Video synthetic aperture radar (VideoSAR) technology, which has fine resolution and high frame rate, is used to obtain the dynamic information of the observation scene. However, the height information of the target produces some additional offsets of target location in the digital elevation model under multiangle VideoSAR image sequence. This study analyses the reason for the target location displacement in VideoSAR, which includes the deduction of the mathematical relation between the location displacement and VideoSAR imaging geometry, as well as the influence of target height. Finally, the simulation results validate the theoretical analysis. [ABSTRACT FROM AUTHOR]

An improved space-variant postfiltering approach to compensate for the wavefront curvature effect in polar format imagery is presented in this letter. The main contribution of this new method is the construction of a space-variant filter, which is based on exploiting the endomorphism property of the polar format transformation. The new approach provides an accurate and general solution to wavefront curvature compensation under arbitrary radar flight path. Finally, point target simulation has validated the effectiveness of the new approach. [ABSTRACT FROM PUBLISHER]