Search

This study focuses on a hydraulic cylinder that is directly connected to a fixed-displacement hydraulic pump driven by an electric servo motor. This particular setup is referred to as a one-motor-one-pump motor-controlled hydraulic cylinder (MCC). This paper presents a new approach to address mode switching oscillation (MSO) in MCCs by incorporating system pressure control capabilities. It conducts a detailed investigation into the factors that contribute to MSO in standard MCCs and thoroughly evaluates the effectiveness of the proposed system in mitigating MSO. The simulation results demonstrate the successful suppression of MSO. In conclusion, the proposed MCC with system pressure control capabilities is validated and, furthermore, it shows great potential for practical applications involving small loads and rapid retraction. [ABSTRACT FROM AUTHOR]

Among various motor-controlled hydraulic cylinder (MCC) topologies, the two-motor-two-pump (2M2P) MCC distinguishes itself through several notable advantages, including precise cylinder pressure control and eliminating mode switch oscillations. Nevertheless, there are challenges remaining in fully realizing its operations across four quadrants and establishing an effective load-holding function within these operations. This study bridges this gap by implementing a 2M2P MCC prototype on a laboratory knuckle boom crane, enabling operation across all four quadrants. Experimental results indicate that position tracking errors remain within ±2.5 mm across three cases, which is well below 1% of the total cylinder travels in the experiments. Furthermore, smooth intersection of cylinder-bore-side and rod-side pressures is observed during transitions between quadrants. In conclusion, the proposed 2M2P MCC demonstrates seamless operation throughout all quadrants, with the load-holding function smoothly activating and deactivating in all four quadrants. [ABSTRACT FROM AUTHOR]

This paper is concerned with a hydraulic cylinder directly controlled by a variable speed motor-driven fixed-displacement pump. The considered configuration is referred to as a one-motor-one-pump (1M1P) motor-controlled hydraulic cylinder (MCC). A 1M1P MCC with a hydraulically driven passive load-holding function enabled by controlled system pressures is proposed. The proposed load-holding functionality works if there is a standstill command, a loss of power supply, or a hose rupture. Additionally, this paper conducts a comprehensive analysis of the proposed system's operation and load-holding function across four quadrants. The simulation results demonstrate four-quadrant operation and good load-holding performance under the aforementioned scenarios. In conclusion, the proposed 1M1P MCC can be successfully used on practical applications characterized by overrunning loads and four quadrant operation. [ABSTRACT FROM AUTHOR]

This paper presents the design, simulation and experimental verification of adaptive feedforward motion control for a hydraulic differential cylinder. The proposed solution is implemented on a hydraulic loader crane. Based on common adaptation methods, a typical electro-hydraulic motion control system has been extended with a novel adaptive feedforward controller that has two separate feedforward states, i.e, one for each direction of motion. Simulations show convergence of the feedforward states, as well as 23% reduction in root mean square (RMS) cylinder position error compared to a fixed gain feedforward controller. The experiments show an even more pronounced advantage of the proposed controller, with an 80% reduction in RMS cylinder position error, and that the separate feedforward states are able to adapt to model uncertainties in both directions of motion. [ABSTRACT FROM AUTHOR]