Search

The ASDEX Upgrade (AUG) tokamak requires an electrical power up to a few hundred MVA for a time period of 10–20 s. The power and energy is provided by three separate networks based on flywheel generators. In 1999, during a routine check performed on generator EZ3, it was discovered that coupling bolts of the flywheel generator shaft were deformed. Given that the active load of the generator (∼100 MW) in service is well below the design value of the shaft (∼800 MW), the damages may only be explained by a torsional resonance of the shaft line, itself excited by active power transients from the converter loads. A value of 23.6 Hz was calculated for the first eigen-frequency of the shaft line. Frequencies between 10 and 30 Hz have been identified in the spectrum of the load curves. Since torsional shaft oscillations are characterised by very low damping, torsional resonance can become dangerous even for over-dimensioned generator shafts. Therefore, a novel ‘torque’ measurement system was installed. The paper presents results from calculations and measurements showing that devices capable to measure the stress in the shaft line are essential for generator protection in feedback controlled fusion experiments. [Copyright &y& Elsevier]

Abstract: The ohmic heating system and the poloidal field coils of ASDEX upgrade are supplied by 15 thyristor converter units with an installed apparent power of 600 MVA. To protect the thyristor converters against dc overvoltage arising from abnormal operations and resulting damages caused by the large energy stored in the AUG magnet coils an overvoltage protection system was required. The paper describes the motivation for—and the design and testing of the thyristor crowbar system representing the thyristor converter overvoltage protection system. It will present the layout, analyse the results of measurements obtained during commissioning, compare them to the calculated (design) values and report on the first experience of operation on the AUG coils improving the safety of the equipment. [Copyright &y& Elsevier]

The power supply of the ASDEX Upgrade (AUG) tokamak consists of 11 thyristor converter modules which feed the poloidal field coils. All converters installed are powered by 10.5 kV flywheel generators starting at a frequency of 110 Hz, running down to 85 Hz during a pulse. For quasi-stationary advanced tokamak experiments with enlarged flat-top phase, the power supply system must be extended. The variable frequency of the pulsed network, fast load changes, together with the different parameters of the load coils require a very sophisticated converter design with reduced reactive power consumption. The paper describes the design and testing of the modular Thyristor Converter Group 6 with neutral control and four quadrant possibilities. It presents the various configurations available for operation on AUG magnetic coils, analyses the results of measurements obtained during commissioning, compares them to the calculated (design) values and reports on the performance achieved in fast four quadrant operation, improving the possibilities of the AUG feedback control of plasma shape and position. [Copyright &y& Elsevier]