Search

Precast concrete, cold weather concreting, and the emerging technique of concrete additive manufacturing are applications in which the acceleration of cement hydration plays a critical role. To allow precise control of early cement hydration in these applications, a thorough understanding of the working mechanisms of cement hydration accelerators is required. This study contributes to the understanding of the mechanism by which calcium nitrate (Ca(NO3)2) influences early cement hydration. The influence of Ca(NO3)2 on the hydration of an ordinary Portland cement has been followed by isothermal calorimetry, in situ X‐ray diffraction (XRD), quantitative XRD, compressive strength testing, and the analysis of the pore solution composition. Further, the initial pore solution, the initial phase composition, and the phase composition in the fully hydrated cement have been estimated by thermodynamic calculations to corroborate the experimentally obtained results. The results indicate that Ca(NO3)2, especially at the highest analyzed dosage of 5 wt.%, enhances the formation of ettringite and a nitrate‐containing AFm phase. Furthermore, Ca(NO3)2 accelerates alite hydration. Besides the increased Ca concentration in solution, it has been found that a reduction of the Al concentration in the initial pore solution by Ca(NO3)2 possibly contributes to the accelerating effect of Ca(NO3)2 on alite hydration. [ABSTRACT FROM AUTHOR]

• 3D printable mortars containing different dosages of nanosilica (NS) were developed and evaluated. • NS accelerates significantly the setting and hardening of printable mortar, while reducing its open time. • Increment of yield stress, together with an increment in NS dosage, was found to have occurred. • Optimal NS dosage results in improvement of the compressive strength and pore structure. • Incorporation of NS in the mixture resulted in improved buildability and decrement in pore anisotropy. This study presents the experimental results of an investigation on the effects of nanosilica (NS) on the material characteristics of printable mortars used for additive manufacturing. Printable cement mortars based on Ordinary Portland Cement, limestone filler and silica sand were modified with different dosages of nanosilica (from 2% to 6% by weight of binder) and its influence on their hydration, rheological, mechanical and transport properties was assessed. The study showed that NS accelerates significantly the setting and hardening of printable mortar, while reducing its open time. Moreover, an increment of yield stress, together with an increment in NS dosage, was found to have occurred. The incorporation of an optimal NS dosage results in a noticeable increase in the compressive strength and alteration of the pore structure as determined by the MIP measurements. Moreover, transport properties of the produced mortar are significantly improved due to incorporation of NS. In addition to the microstructure refinement, Micro-CT and scanning electron microscopy (SEM) studies revealed that 3D printed mortars exhibit pore anisotropy in accordance with the printing direction. However, incorporation of NS in the mixture resulted in improved buildability, thus decreasing pore anisotropy. [ABSTRACT FROM AUTHOR]