Search

Protective polymer coatings have been used to enhance the retention of enzymes in sol-gel films as immobilisation phases in electrochemical biosensors. Carbon film electrodes were electrochemically modified with poly(neutral red) (PNR). These electrodes were coated with oxysilane sol-gels incorporating glucose oxidase and an outer coating of carboxylated PVC (CPVC) or polyurethane (PU), with and without Aliquat-336 or isopropyl myristate (IPM) plasticizer, was applied. The biosensors were characterised electrochemically using cyclic voltammetry and amperometry, electrochemical impedance spectroscopy and scanning electron microscopy. Impedance spectra showed that the electrode surface is most active when the sol-gel-GOx layer is not covered with a membrane. However, membranes without plasticizer extend the lifetime of the biosensor to more than 2 months when PU is used as an outer membrane. The linear range of the biosensors was found to be 0.05-0.50 mM of glucose and the biosensor with PU outer membrane exhibited higher sensitivity (ca.117 nA mM(-1)) in the region of linear response than that with CPVC. The biosensors were applied to glucose measurement in natural samples of commercial orange juice.

Variously loaded polypyrrole films, including those containing proteins and polysaccharides, were prepared on gold-coated polycarbonate coverslips. The characteristics of human keratinocytes were studied on these films by microscopy, biochemical assays, and immunocytochemistry. We found keratinocyte viability to be load dependent. For chloride, polyvinyl sulphate, dermatan sulphate, and collagen-loaded polypyrrole films, keratinocyte viability as assessed by the AlamarBlue assay was respectively 47.22, 60.43, 87.71, and 22.65% of tissue culture polystyrene controls after 5 days. This was found to require a previously unreported polymer washing step prior to cell seeding due to the observed toxicity of untreated films. In the case of bare polycarbonate and gold substrates, viability was respectively 75.44 and 61.04% of tissue culture polystyrene controls after 5 days. Keratinocytes stained positive for PCNA (proliferation), K10 (suprabasal differentiation), and K16 (hyperproliferation) markers although cell morphology was poor for organotypical cultures on dermatan- loaded polypyrrole compared with de-epidermalized dermis. From our studies, we concluded that optimized polypyrrole films adequately support keratinocyte growth in submerged cultures with some improvements needed for organotypical cultures. Polypyrrole composites are attractive candidates for tissue-engineering applications since they may incorporate biomolecules and are electrically addressable with the potential to both direct and report on cell activity.

The concept of enzyme-assisted substrate sensing based on use of fluorescent markers to detect the products of enzymatic reaction has been investigated by fabrication of micron-scale polyelectrolyte capsules containing enzymes and dyes in one entity. Microcapsules approximately 5 μm in size entrap glucose oxidase or lactate oxidase, with peroxidase, together with the corresponding markers Tris(4,7-diphenyl-1,10-phenanthroline)ruthenium(II) dichloride (Ru(dpp)) complex and dihydrorhodamine 123 (DHR123), which are sensitive to oxygen and hydrogen peroxide, respectively. These capsules are produced by co-precipitation of calcium carbonate particles with the enzyme followed by layer-by-layer assembly of polyelectrolytes over the surface of the particles and incorporation of the dye in the capsule interior or in the multilayer shell. After dissolution of the calcium carbonate the enzymes and dyes remain in the multilayer capsules. In this study we produced enzyme-containing microcapsules sensitive to glucose and lactate. Calibration curves based on fluorescence intensity of Ru(dpp) and DHR123 were linearly dependent on substrate concentration, enabling reliable sensing in the millimolar range. The main advantages of using these capsules with optical recording is the possibility of building single capsule-based sensors. The response from individual capsules was observed by confocal microscopy as increasing fluorescence intensity of the capsule on addition of lactate at millimolar concentrations. Because internalization of the micron-sized multi-component capsules was feasible, they could be further optimized for in-situ intracellular sensing and metabolite monitoring on the basis of fluorescence reporting. [ABSTRACT FROM AUTHOR]

Abstract: An electrochemical approach has been used to model and measure acetaminophen transport through a microporous polycarbonate membrane. The dynamic response of a membrane covered planar electrode system was investigated to derive a simplified middle point formula, the time at which amperometric current reaches half steady state value, that provided reliable solute diffusion coefficients. Experimental values may be noise-contaminated; when this noise is significant, the diffusion coefficient by this method needs to be refined. Here a direct simulation method with a bipartite mathematical expression for current transient was used, which fitted calculated current transients to experimental data. A best fit was reached by minimising the standard deviation between the simulated and experimental current profiles. Mathematically, the simulated curve was linear operated, i.e. shifted and stretched vertically, as well as shifted and stretched horizontally to coincide with the experimental curve. The single point formula, bipartite expression and simulation approach allowed extraction of accurate diffusion values from a previously reported approximated method. The computation approach is not only valid for membrane covered electrodes, but is suitable for other experimental set ups where a one-dimensional Fickian diffusion model is valid, for example, for axial diffusion through cylindrical geometries. [Copyright &y& Elsevier]