Search

Objectives: In this study, we aimed to determine conditions associated with the development of air bubbles in the pulmonary veins during lung resection., Methods: A total of 28 patients who underwent lung resection at our institution between October 2016 and March 2018 were included in the study. An intraoperative transesophageal echocardiography was conducted, and the influx of air bubbles in the orifice of the pulmonary vein leading to the left atrium was observed during lung resection., Results: The median age of all patients was 75 years. The study included 13 men and 15 women. Moreover, seven, 14, and seven patients underwent wedge resection, segmentectomy, and lobectomy, respectively. The presence of air bubbles was observed in 15 patients and was detected when the lung parenchyma was cut (13 patients) or compressed (3 patients) using staplers and when an energy device was used (1 patient). No postoperative organ infarction occurred in any patients., Conclusions: Although the presence of air bubbles was noted in the pulmonary vein during lung resection via transesophageal echocardiography, the clinical condition of the patients in our study did not deteriorate. The clinical significance of air bubbles is not clear. Therefore, more data about such events must be collected in future.

Since 2004, over 300 patients have undergone thoracoscopic segmentectomy without mini-thoracotomy. Thoracoscopic segmentectomy is one of the most complicated surgeries. To perform the complex segmentectomies, pre-operative simulation and 3-dimensional multi-detector computed tomography( 3DCT) are both essential for safely performing operations and for securing adequate surgical margins. Comprehension of the intersegmental and intrasegmental veins to visualize the segmental border facilitates an easier parenchymal dissection. We describe our method and knack for creating an inflation-deflation line for lung segmentectomy that could especially be useful in thoracoscopic procedures for seg-mentectomy. The 5-year over overall survival, cancer specific survival and recurrence free survival rates were 91.8%( curative intent 98.1% versus compromised 74.6%), 100% and 98.1%( curative intent 100% versus compromised 93.3%). According to these technical aspects, our method of thoracoscopic segmentectomy is acceptable for selective patient.

Objective: Anatomic resection of the dorsal area of the basal segment of the lower lobe is difficult because of the deep location of vessels and bronchi in the parenchyma. This study aimed to describe a novel technique for port-access thoracoscopic segmentectomy of the dorsal (S10) and lateral dorsal segments (S9+10)., Methods: This retrospective study analyzed 20 patients who underwent S10 and S9+10 thoracoscopic segmentectomy via a posterior approach between January 2004 and March 2016. In this approach, the lung parenchyma between S6 and S10 was divided along V6b,c from the dorsal side of the lower lobe, which exposed the targeted bronchus (B10, B9+10) and artery (A10, A9+10) and enabled anatomic S10 and S9+10 segmentectomy., Results: Of the 20 patients, 15 had lung cancer, 3 had metastases, and 2 had benign nodules. The number of segmentectomies of the right S10, right S9+10, left S10, and left S9+10 was 5, 5, 1, and 9, respectively. Median operative time was 165 minutes (range, 107-276 minutes). The median duration of chest tube insertion was 1 day (range, 1-2 days). One patient had atelectasis. Median hospital stay was 6 days (range, 3-11 postoperative days). No recurrence or mortality was observed during the median follow-up period of 46 months., Conclusions: The posterior approach for port-access thoracoscopic segmentectomy at S10 or S9+10 is technically challenging, but in our hands it has been feasible. It exposes the targeted bronchus (B10, B9+10) and artery (A10, A9+10) and enables anatomic S10 and S9+10 segmentectomy while avoiding inessential parenchymal splitting from the major fissure., (Copyright © 2017 The American Association for Thoracic Surgery. Published by Elsevier Inc. All rights reserved.)

Objectives: Although wedge resection can be curative for small lung tumours, tumour marking is sometimes required for resection of non-palpable or visually undetectable lung nodules as a method for identification of tumours. Tumour marking sometimes fails and occasionally causes serious complications. We have performed many thoracoscopic segmentectomies using 3D computed tomography simulation for undetectable small lung tumours without any tumour markings. The aim of this study was to investigate whether thoracoscopic segmentectomy planned with 3D computed tomography simulation could precisely remove non-palpable and visually undetectable tumours., Methods: Between January 2012 and March 2016, 58 patients underwent thoracoscopic segmentectomy using 3D computed tomography simulation for non-palpable, visually undetectable tumours. Surgical outcomes were evaluated., Results: A total of 35, 14 and 9 patients underwent segmentectomy, subsegmentectomy and segmentectomy combined with adjacent subsegmentectomy, respectively. All tumours were correctly resected without tumour marking. The median tumour size and distance from the visceral pleura was 14 ± 5.2 mm (range 5-27 mm) and 11.6 mm (range 1-38.8 mm), respectively. Median values related to the procedures were operative time, 176 min (range 83-370 min); blood loss, 43 ml (range 0-419 ml); duration of chest tube placement, 1 day (range 1-8 days); and postoperative hospital stay, 5 days (range 3-12 days). Two cases were converted to open thoracotomy due to bleeding. Three cases required pleurodesis for pleural fistula. No recurrences occurred during the mean follow-up period of 44.4 months (range 5-53 months)., Conclusions: Thoracoscopic segmentectomy using 3D computed tomography simulation was feasible and could be performed to resect undetectable tumours with no tumour markings., (© The Author 2017. Published by Oxford University Press on behalf of the European Association for Cardio-Thoracic Surgery. All rights reserved.)

Background: Stapling or suturing techniques are commonly used to close bronchial stumps in lung lobectomy, although with the segmentectomy procedure, various types of closure are likely to be performed. We investigated the safety of various types of bronchial closure methods used in anatomic lung segmentectomy., Methods: Between 2005 and 2013, we performed anatomic lung segmentectomies including segmentectomies through open thoracotomy for 41 patients and thoracoscopy for 167 patients. Bronchial closures were performed through open and thoracoscopy methods for 66 and 231 stumps, respectively. Data were collected regarding segmental bronchus type, stump closure methods, and closure-related complications. Since 2006, bronchial caliber was measured from preoperative 1 mm(3) computed tomography., Results: In the open group, 17 stumps (26%) were closed by stapling, 48 (73%) by thread ligation, and 1 (1%) by suturing. In the thoracoscopy group, 116 stumps (50%) were closed by stapling, 76 (33%) by thread ligation, and 39 (17%) by polymer clip ligation (p < 0.001). Staplers were used for all bronchial trunks that supplied more than a single segment; the mean diameter was 8.1 mm. For single segmental bronchi, ligation was used for 80% in the open group and stapling for 75% in the thoracoscopy group; the mean diameter was 6.6 mm. For subsegmental bronchi, ligation or clipping were applied for 95% in both groups; the mean diameter was 4.6 mm. One bronchopleural fistula was observed at 6 months postoperatively in upper division segmentectomy of the left upper lobe using a stapler in the open group., Conclusions: Ligation can be used safely for small-diameter segmental bronchial stump closures in anatomic lung segmentectomies or subsegmentectomies. The use of a polymer clip can be an alternative method to close the bronchial stump of subsegmentectomies., (Copyright © 2016 The Society of Thoracic Surgeons. Published by Elsevier Inc. All rights reserved.)

We report a novel monofilament slip knot technique for bronchial ligation and for visualization of the anatomic plane during lung segmentectomy. After threading the bronchus, a slip knot is made outside the thorax. During lung ventilation, one end of the string is pulled, and the knot slips to reach the bronchus without a knot-pusher. Bronchial ligation is then performed to block the outflow of segmental air while the segment remains expanded, whereas the other segments become collapsed. This technique allows identification of the anatomic intersegmental plane, facilitating thoracoscopic anatomic lung segmentectomy., (Copyright © 2014 The Society of Thoracic Surgeons. Published by Elsevier Inc. All rights reserved.)

Objectives: The diagnosis of small lung nodules has increased in recent years; limited resection and minimally invasive surgery are highly desirable in patients with these lesions. While wedge resection may be curative for small lung nodules, the technique is sometimes difficult to perform when the tumour nodule is near the pulmonary hilum. In such situations, either anatomical segmentectomy or subsegmentectomy can obtain an adequate surgical margin; port-access thoracoscopic surgery is the preferred type of minimally invasive surgery. Three-dimensional (3D) computed tomography (CT) simulations are reportedly useful in planning and performing thoracoscopic surgery. We use 3D CT simulation to aid thoracoscopic segmentectomy for small lung nodules and subsegmentectomy for even smaller nodules and conduct here a retrospective evaluation of the clinical results of subsegmentectomy. We present our technique for 3D CT simulation-assisted port-access thoracoscopic subsegmentectomy in the superior segment of the left lower lobe., Methods: Between July 2008 and June 2012, 15 patients underwent port-access thoracoscopic subsegmentectomy. We evaluated the pathological diagnoses, the tumour sizes, the indications, the operative times and the volumes of blood loss., Results: Seven patients were diagnosed with lung cancer (LC) and eight had metastatic lung tumours (MLT). The median tumour size was 12 mm. The indication for using this surgical technique was to secure surgical margins in 13 patients (LC, 6; MLT, 7) and because of poor surgical risk in two patients (LC, 1; MLT, 1). The mean surgical time was 166 min and the median blood loss was 19 ml. There were no recurrences., Conclusions: Port-access thoracoscopic lung subsegmentectomy using 3D CT simulation can be safely performed and is able to secure adequate surgical margins.

Sublobar resection and the optimum approach for small-sized lung cancer remain controversial. We defined the criteria for the selection of cT1aN0M0 patients for thoracoscopic lung surgery and the criteria for other patients for open lung surgery in 2004. Limited resection for small-sized lung cancer was performed when the diameter of the solid lesion was less than 20% the diameter of lesions of groundglass opacity( GGO). The 5-year overall survival and 5-year disease-free survival( 5Y-DFS) was 89.9% and 91.7%, respectively. The 5Y-DFS according to the pathological stage was as follows:stage IA, 96.5%;IB, 100%;IIA, 50%;IIIA, 66.7%;and stage IV, 100%. According to computed tomography (CT) findings, the 5Y-DFS was as follows:pure GGO lesion, 100%;mixed GGO lesion, 100%;and solid lesion, 84.6%. Lymph node metastases and recurrence were noticed only in patients with a solid lesion. Thus, patients with GGO lesions are considered good candidates for thoracoscopic sublobar resection. In addition, thoracoscopic segmentectomy was performed in cT1bN0M0 patients with GGO lesions, and good prognostic results were obtained;therefore, these patients are also considered good candidates for the procedure.