Search

Aerobic granulation in sequencing batch reactors is widely reported in literature and in particular in SBAR (Sequencing batch airlift reactor) configuration, due to the high localised hydrodynamic shear forces that occur in this type of configuration. The aim of this work was to observe the phenomenon of the aerobic granulation and to confirm the excellent removal efficiencies that can be achieved with this technology. In order to do that, a laboratory-scale plant, inoculated with activated sludge collected from a conventional WWTP, was operated for 64 days: 42 days as a SBAR and 22 days as a SBBC (sequencing batch bubble column). The performances of the pilot plant showed excellent organics removal. COD and BOD removal efficiencies were respectively, 93 and 94%; on the contrary, N-removal efficiency was extremely low (5%-45%). The granules dimensions increased during the whole experimentation; change of reactor configuration contributed to further improve this aspect. The experimental work confirmed the essential role of hydraulic settling time in the formation of aerobic granules and in the sludge settleability and the need to find an optimum between granule size and oxygen supply to achieve good N-removal efficiency. [ABSTRACT FROM AUTHOR]

In recent years there has been an increasing interest in the development of hybrid biofilm reactors, especially in the upgrading of existing WWFP that are no longer able to respect concentration limits. In fact, today's challenge is the achievement of a good aquatic state for the receiving water bodies according to the Water Framework Directive requirements, which indeed limit even more the continuous emissions, i.e. coming from WWTP. This paper presents the setting up of a mathematical model for the simulation of a hybrid MBBR system; the model calibration/validation has been carried out considering a field gathering campaign on an experimental pilot plant. The main goal is to gain insight about MBBR processes attempting to overcome main shortcomings in particular referring to the modelling aspects. The model is made up of two connected sub-models for the simulation of the suspended and attached biomass. The model is mainly based on the concepts of the activated sludge model No. 1 (ASM1) for the description of the biokinetic process both for the suspended and for the attached biomass. The results show a good agreement between predicted and observed values both for the attached and for the suspended biomass moreover they are encouraging for further researches. [ABSTRACT FROM AUTHOR]

• Biological and photocatalysis treatments in-series enabled high TOC removal (ca. 95%). • High photocatalysis performance was achieved because of the MBR pre-treatment. • The addition of K 2 S 2 O 8 reduced the necessity of cumulative impinging energy (60 E). • Membrane fouling mechanisms were the "cake layer deposition" and the "pore blocking". This study investigated the treatment of a shipboard slop containing commercial gasoline in a pilot plant scale consisting of a membrane biological reactor (MBR) and photocatalytic reactor (PCR) acting in series. The MBR contributed for approximately 70% to the overall slop purification. More precisely, the biological process was able to remove approximately 40%, on average, of the organic pollution in the slop. Nevertheless, the membrane was capable to retain a large amount of organic molecules within the system, amounting for a further 30% of the influent total organic content removal. However, this affected the membrane fouling, thus resulting in the increase of the pore blocking mechanism that accounted for approximately 20% to the total resistance to filtration (2.85∙1013 m−1), even if a significant restoration of the original membrane permeability was obtained after chemical cleanings. On the other hand, the biological treatment produced a clear solution for the photocatalytic system, thereby optimizing the light penetration and generation of highly oxidizing active oxygen species that enabled the degradation of bio-recalcitrant compounds. Indeed, low total organic carbon (TOC) values (<10 mg L−1) were achieved in the output of the photocatalytic reactor by means of only 60 Einstein (E) of cumulative impinging energy after the addition of K 2 S 2 O 8. Overall, coupling the two processes enabled very high TOC removal (ca. 95%). [ABSTRACT FROM AUTHOR]