Search

This paper describes the first Vertical Electron Cyclotron Emission (V-ECE) measurement of non-thermal electron distributions in the \textit{Tokamak \`a Configuration Variable}, TCV. These measurements were conducted in runaway electron scenarios and in the presence of Electron Cyclotron Current Drive. Measured intensities of linearly polarised X- and O-mode radiation from fast electrons allow the analysis of the energy distribution. The measurements were made possible through the creation of an operational regime for the diagnostic that is free of thermal background radiation, in relaxed electron density operations. This operational regime notably enables the cross-calibration of the diagnostic system, relying on thermal plasma measurements and modeling with the ray-tracing code SPECE., Comment: Submitted to: Plasma Phys. Control. Fusion

Because negative triangularity plasma scenarios remain in L-mode, they do not require external heating systems that exceed the H-mode power threshold. Operating with less heating has the potential to improve performance as heating generally degrades confinement in tokamaks. Using simple zero dimensional power balance and standard empirical scaling laws for confinement, we analyze the impact of external heating on several different reactor-relevant devices (i.e. SPARC, MANTA, ITER and DEMO). We compare the nominal externally heated scenarios against equivalent negative tringularity cases without external heating. For most of these devices, the Ohmically heated negative triangularity versions achieve better performance, particularly for devices with high magnetic field and/or high fusion gain.

Runaway electrons (REs) are a concern for tokamak fusion reactors from discharge startup to termination. A sudden localized loss of a multi-megaampere RE beam can inflict severe damage to the first wall. Should a disruption occur, the existence of a RE seed may play a significant role in the formation of a RE beam and the magnitude of its current. The application of central electron cyclotron resonance heating (ECRH) in the Tokamak \`a Configuration Variable (TCV) reduces an existing RE seed population by up to three orders of magnitude within only a few hundred milliseconds. Applying ECRH before a disruption can also prevent the formation of a post-disruption RE beam in TCV where it would otherwise be expected. The RE expulsion rate and consequent RE current reduction are found to increase with applied ECRH power. Whereas central ECRH is effective in expelling REs, off-axis ECRH has a comparatively limited effect. A simple 0-D model for the evolution of the RE population is presented that explains the effective ECRH-induced RE expulsion results from the combined effects of increased electron temperature and enhanced RE transport.

In this work, we study the impact of aspect ratio A = R0 /r (the ratio of major radius R0 to minor radius r) on the confinement benefits of Negative Triangularity (NT) plasma shaping. We use high-fidelity flux tube gyrokinetic GENE simulations and consider several different scenarios: four of them inspired by TCV experimental data, a scenario inspired by DIII-D experimental data and a scenario expected in the new SMART spherical tokamak. The present study reveals a surprising and non-trivial dependence. NT improves confinement at any value of A for ITG turbulence, while for TEM turbulence confinement is improved only in the case of large and conventional aspect ratios. Additionally, through a detailed study of a large aspect ratio case with pure ITG drive, we develop an intuitive physical picture that explains the beneficial effect of NT at large and conventional aspect ratios. This picture does not hold in TEM-dominated regimes, where a complex synergistic effect of many factors is found. Finally, we performed the first linear gyrokinetic simulations of SMART, finding that both NT and PT scenarios are dominated by micro-tearing-mode (MTM) turbulence and that NT is more susceptible to MTMs at tight aspect ratio. However, we found that a regime where ITG dominates in SMART can be found, and in this regime NT is more linearly stable.

In recent years, negative triangularity (NT) has emerged as a potential high-confinement L-mode reactor solution. In this work, detachment is investigated using core density ramps in lower single null Ohmic L-mode plasmas across a wide range of upper, lower, and average triangularity (the mean of upper and lower triangularity: $\delta$) in the TCV tokamak. It is universally found that detachment is more difficult to access for NT shaping. The outer divertor leg of discharges with $\delta\approx -0.3$ could not be cooled to below $5~\mathrm{eV}$ through core density ramps alone. The behavior of the upstream plasma and geometrical divertor effects (e.g. a reduced connection length with negative lower triangularity) do not fully explain the challenges in detaching NT plasmas. Langmuir probe measurements of the target heat flux widths ($\lambda_q$) were constant to within 30% across an upper triangularity scan, while the spreading factor $S$ was lower by up to 50% for NT, indicating a generally lower integral Scrape-Off Layer width, $\lambda_{int}$. The line-averaged core density was typically higher for NT discharges for a given fuelling rate, possibly linked to higher particle confinement in NT. Conversely, the divertor neutral pressure and integrated particle fluxes to the targets were typically lower for the same line-averaged density, indicating that NT configurations may be closer to the sheath-limited regime than their PT counterparts, which may explain why NT is more challenging to detach.

Results from the last FTU campaigns on the deuterium large (wrt FTU volume) pellet REs suppression capability, mainly due to the induced burst MHD activity expelling REs seed are presented for discharges with 0.5 MA and 5.3T. Clear indications of avalanche multiplication of REs following single pellet injection on 0.36 MA flat-top discharges is shown together with quantitative indications of dissipative effects in terms of critical electrical field increase due to fan-like instabilities. Analysis of large fan-like instabilities on post-disruption RE beams, that seem to be correlated with low electrical field and background density drops, reveal their strong RE energy suppression capability suggesting a new strategy for RE energy suppression controlling large fan instabilities. We demonstrate how such density drops can be induced using modulated ECRH power on post-disruption beams., Comment: DRAFT that will be submitted to NF (the conference version is on FEC/IAEA conference 2020)

Global gradient driven GENE gyrokinetic simulations are used to investigate TCV plasmas with negative triangularity. Considering a limited L-mode plasma, corresponding to an experimental triangularity scan, numerical results are able to reproduce the actual transport level over a major fraction of the plasma minor radius for a plasma with $\delta_{\rm LCFS}=-0.3$ and its equivalent with standard positive triangularity $\delta$. For the same heat flux, a larger electron temperature gradient is sustained by $\delta<0$, in turn resulting in an improved electron energy confinement. Consistently with the experiments, a reduction of the electron density fluctuations is also seen. Local flux-tube simulations are used to gauge the magnitude of nonlocal effects. Surprisingly, very little differences are found between local and global approaches for $\delta>0$, while local results yield a strong overestimation of the heat fluxes when $\delta<0$. Despite the high sensitivity of the turbulence level with respect to the input parameters, global effects appear to play a crucial role in the negative triangularity plasma and must be retained to reconcile simulations and experiments. Finally, a general stabilizing effect of negative triangularity, reducing fluxes and fluctuations by a factor dependent on the actual profiles, is recovered.

Modern Tokamaks have evolved from the initial axisymmetric circular plasma shape to an elongated axisymmetric plasma shape that improves the energy confinement time and the triple product, which is a generally used figure of merit for the conditions needed for fusion reactor performance. However, the elongated plasma cross section introduces a vertical instability that demands a real-time feedback control loop to stabilize the plasma vertical position and velocity. At the Tokamak \`a Configuration Variable (TCV) in-vessel poloidal field coils driven by fast switching power supplies are used to stabilize highly elongated plasmas. TCV plasma experiments have used a PID algorithm based controller to correct the plasma vertical position. In late 2013 experiments a new optimal real-time controller was tested improving the stability of the plasma. This contribution describes the new optimal real-time controller developed. The choice of the model that describes the plasma response to the actuators is discussed. The high order model that is initially implemented demands the application of a mathematical order reduction and the validation of the new reduced model. The lower order model is used to derive the time optimal control law. A new method for the construction of the switching curves of a bang-bang controller is presented that is based on the state-space trajectories that optimize the time to target of the system. A closed loop controller simulation tool was developed to test different possible algorithms and the results were used to improve the controller parameters. The final control algorithm and its implementation are described and preliminary experimental results are discussed., Comment: Preprint submitted to IEEE Transactions on Nuclear Science

13MW of electron cyclotron current drive (ECCD) power deposited inside the q = 1 surface is likely to reduce the sawtooth period in ITER baseline scenario below the level empirically predicted to trigger neo-classical tearing modes (NTMs). However, since the ECCD control scheme is solely predicated upon changing the local magnetic shear, it is prudent to plan to use a complementary scheme which directly decreases the potential energy of the kink mode in order to reduce the sawtooth period. In the event that the natural sawtooth period is longer than expected, due to enhanced alpha particle stabilisation for instance, this ancillary sawtooth control can be provided from > 10MW of ion cyclotron resonance heating (ICRH) power with a resonance just inside the q = 1 surface. Both ECCD and ICRH control schemes would benefit greatly from active feedback of the deposition with respect to the rational surface. If the q = 1 surface can be maintained closer to the magnetic axis, the efficacy of ECCD and ICRH schemes significantly increases, the negative effect on the fusion gain is reduced, and off-axis negative-ion neutral beam injection (NNBI) can also be considered for sawtooth control. Consequently, schemes to reduce the q = 1 radius are highly desirable, such as early heating to delay the current penetration and, of course, active sawtooth destabilisation to mediate small frequent sawteeth and retain a small q = 1 radius., Comment: 29 pages, 16 figures

A control oriented, lumped parameter model for the tokamak transformer including the slow flux penetration in the plasma (skin effect transformer model) is presented. The model does not require detailed or explicit information about plasma profiles or geometry. Instead, this information is lumped in system variables, parameters and inputs. The model has an exact mathematical structure built from energy and flux conservation theorems, predicting the evolution and non linear interaction of the plasma current and internal inductance as functions of the primary coil currents, plasma resistance, non-inductive current drive and the loop voltage at a specific location inside the plasma (equilibrium loop voltage). Loop voltage profile in the plasma is substituted by a three-point discretization, and ordinary differential equations are used to predict the equilibrium loop voltage as function of the boundary and resistive loop voltages. This provides a model for equilibrium loop voltage evolution, which is reminiscent of the skin effect. The order and parameters of this differential equation are determined empirically using system identification techniques. Fast plasma current modulation experiments with Random Binary Signals (RBS) have been conducted in the TCV tokamak to generate the required data for the analysis. Plasma current was modulated in Ohmic conditions between 200kA and 300kA with 30ms rise time, several times faster than its time constant L/R\approx200ms. The model explains the most salient features of the plasma current transients without requiring detailed or explicit information about resistivity profiles. This proves that lumped parameter modeling approach can be used to predict the time evolution of bulk plasma properties such as plasma inductance or current with reasonable accuracy; at least in Ohmic conditions without external heating and current drive sources.