Search

High performance collimation systems are required for current and proposed high energy hadron accelerators in order to protect superconducting magnets and experiments. In order to ensure that the collimation system designs are sufficient and will operate as expected, precision simulation tools are required. This paper discusses the current status of existing collimation system tools, and performs a comparison between codes in order to ensure that the simulated interaction physics between a proton and a collimator jaw is accurate., Proceedings of the 8th Int. Particle Accelerator Conf., IPAC2017, Copenhagen, Denmark

Precise proton therapy planning can be assisted by augmenting conventional medical imaging techniques with proton computed tomography (pCT). For adults this requires an incident proton energy up to around 330 MeV, requiring superconducting magnets if an imaging gantry is to replace a conventional 230-250 MeV gantry in the same space. Here we present optics considerations for a superconducting gantry to deliver 330 MeV protons within the context of the future Christie Hospital proton therapy centre, where it is proposed to increase the proton energy in the future with a booster linac., Proceedings of the 8th Int. Particle Accelerator Conf., IPAC2017, Copenhagen, Denmark

Crab Cavities will be installed in the High Luminosity LHC in order to increase the effective peak luminosity through a partial compensation of the geometric factor. This will allow extending the levelling time resulting in an increased production of integrated luminosity. Based on the availability of the LHC during 2016 operation, the expected yearly-integrated luminosity of the future HL-LHC was estimated using a Monte Carlo model. Crab cavity faults were added to the observed failure distribu-tions and their impact on integrated luminosity produc-tion as a function of fault time and fault frequency was studied. This allows identifying a breakeven point in luminosity production and defining minimum system availability requirements for the crab cavities to reach the design goal of 250 fb-1 of integrated luminosity per year., Proceedings of the 8th Int. Particle Accelerator Conf., IPAC2017, Copenhagen, Denmark

The recently observed beam induced heating issues in the BGI monitors of the LHC which could have been occurred due to a strong coupling between the beam and the localized modes at the sensor location showed the general importance of a thorough evaluation of the beam coupling impedance and the corresponding heat deposit in beam monitoring equipments. This paper is devoted to the examination of the beam coupling impedance and beam induced heating for a currently under development beam gas ionization (BGI) monitor which is intended to be a part of the CERN Proton Synchrotron (PS) beam monitoring equipment. Details of the EM and wake field simulations for this BGI monitor together with the RF measurement results and power loss calculations will be presented., Proceedings of the 8th Int. Particle Accelerator Conf., IPAC2017, Copenhagen, Denmark

It is well known that performance of accelerators critically depends on the interaction of high intensity beams with the surrounding structures. As a result of these beam interactions, it is required at CERN to characterize the beam coupling impedance of each new machine element that is to be installed in the accelerator ring. In the framework of the LIU (LHC Injectors Upgrade) project, a new design of rotational wire scanner to be used in the PS Booster is currently under development. As an intermediate step, the prototype of this wire scanner was evaluated with respect to its longitudinal beam coupling impedance. Depending on the performance of this machine element, it is planned to replace existing wire scanners in other machines at CERN (e.g. PS-Booster, PS and SPS) with very similar designs. This paper presents the simulations and describes the measurement methods used for benchmarking electromagnetic simulations performed for the impedance evaluation of the LIU wire scanner for the PS-Booster. Additionally, the device was fitted with an RF feed-through in order to monitor and attenuate certain undesired modes supported by this structure., Proceedings of the 8th Int. Particle Accelerator Conf., IPAC2017, Copenhagen, Denmark