Search

Solubility and permeability are key parameters for establishing in vitro-in vivo correlation for poorly water-soluble active pharmaceutical ingredients (APIs). Recent studies demonstrate that not only solubility, but also effective permeability of the API may change due to the addition of solubilizing agents, and there is a certain mathematical relation between these physicochemical parameters. The aim of this study was to show the importance of early screening of solubility and permeability in presence of additives in order to achieve the expected bioavailability of the API. In this work, the effect of surfactants and microenvironmental pH modifiers were in focus, and pimobendan was chosen as model drug. In the case of pH modifiers, the equilibrium solubility of the API increased, while the permeability decreased significantly. No negative effect was observed for two surfactants at low additive levels, but these two additives also exhibited a slightly negative effect on permeability when used at higher concentrations. In the simultaneous dissolution-permeation studies the surfactants-containing formulation was found to have slightly higher flux than the pH-modifier-containing one. It can be due to the phenomenon that the dissolution of the active substance can be enhanced by these surfactants without any significant permeability reducing effect. The results obtained from the present study clearly demonstrate the importance of studying drug-additive interactions in every step of formulation development and based on these, the selection of the appropriate quality and quantity of additives. In addition, the results also underline the significance of performing simultaneous dissolution-permeation studies to predict bioavailability. [ABSTRACT FROM AUTHOR]

Absorption through the skin of topically applied chemicals is relevant for both formulation development and safety assessment, especially in the early stages of development. However, the supply of human skin is limited, and the traditional in vitro methods are of low throughput. As an alternative, an artificial membrane-based Skin Parallel Artificial Membrane Permeability Assay (Skin-PAMPA) has been developed to mimic the permeability through the stratum corneum. In this study, this assay was used to measure the permeability of a model compound, 4-phenylethyl-resorcinol (PER), dissolved in 13 different solvents that are commonly used in cosmetic formulation development. The study was performed at concentrations close to the saturated solution of PER in each solvent to investigate the maximum thermodynamic potential of the solvents. The permeability of PER in selected solvents was also measured on ex vivo pig skin for comparison. Pig ear skin is an accepted alternative model of human skin. The permeability coefficient, which is independent of the concentration of the applied solution, showed a good correlation (R2 = 0.844) between the Skin-PAMPA and the pig skin permeation data. Our results support the use of the Skin-PAMPA to screen the suitability of different solvents for non-polar compounds at an early stage of formulation development. [ABSTRACT FROM AUTHOR]