Search

Anti-icing coatings have provided a very good alternative to current, uneconomic, active deicing methods, and their use would bring a number of significant benefits to many industries, such as aviation and energy. Some of the most promising icephobic surfaces are those with hydrophobic properties. However, the relationship between hydrophobicity and low ice adhesion is not yet clearly defined. In this work, chemical modification of an epoxy gelcoat with chemical modifiers from the group of double organofunctionalized polysiloxanes (generally called multifunctionalized organosilicon compounds (MFSCs)) was applied. The anti-icing properties of manufactured coatings were determined by means of measurements of shear strength between the ice layer and the modified surface, conducted using a tensile machine. In the work, tests were also performed on the roughness, wettability, and durability of the properties in an aging chamber. It was found that the performed modifications of the coating's chemical composition by the addition of polysiloxanes enabled us to reduce ice adhesion by 51% and to increase the water contact angle by 14% in comparison to the neat gelcoat. A reduction in ice adhesion was also observed with the increasing water contact angle and with decreasing surface roughness. In addition, only one modification recorded an increase in ice adhesion after exposure in the aging chamber. [ABSTRACT FROM AUTHOR]

Ice accumulation on aerodynamic surfaces is a well-known aspect in various industries, including wind turbines. Many solutions have been developed for several years to deal with this problem, but until now no suitable and energy-sufficient method available for industrial applications has been found. A potential solution is using hydrophobic and/or icephobic coatings, which would allow one to reduce ice adhesion to surfaces. In this study, modifications of a gelcoat based on unsaturated polyester resin with in-house synthesized polysiloxanes dual-functionalized with allyl glycidyl ether (AGE) and hexyl (HEX) or octyl (OCT) groups were used. Most of the chemical modifications used resulted in an increase in surface hydrophobicity (an increase in water contact angle and a decrease in contact angle hysteresis) and an improvement in icephobicity - a reduction in ice adhesion. The lowest ice adhesion achieved a value equal to 221 kPa (the decrease in ice adhesion was 36 % compared to the unmodified surface). The highest water contact angle exhibited a value of 96 °C. Furthermore, correlations were observed between roughness/wettability and ice adhesion: as roughness and wettability decrease, ice adhesion is reduced. The study also determined the durability of the produced surfaces after 100 icing/deicing cycles and the zeta potential surface. • The addition of organosilicon compounds having non-polar alkyl groups results in an increase in the hydrophobicity. • Chemical modification with functionalized polysiloxanes caused a decrease in ice adhesion. • A trend was observed that as the water contact angle increases and the roughness decreases, ice adhesion decreases. [ABSTRACT FROM AUTHOR]