Search

In this paper we examine the transmission of two types of ultra-wideband (UWB) signals, multiband orthogonal frequency division multiplexing (MB-OFDM) and impulse radio ultra-wideband (IR-UWB), over single mode fiber at 1550 nm. In order to investigate the impact of optical components such as laser diode, external modulator and single mode fiber on UWB signals, we develop mathematical models for these components. These models are experimentally verified and corresponding numerical parameter values are obtained by experiment. Using these models we discuss the transmission of two types of UWB signals over single mode fiber. A new figure of merit namely distortion factor is defined. Using this figure of merit the direct modulation of distributed feedback (DFB) laser diode and the external modulation with Mach-Zehnder modulator (MZM) are compared in terms of their impact on UWB signals. Using intensive simulation we also compare MB-OFDM and IR-UWB in terms of their sensitivity to the distortions of a UWB over fiber link using error vector magnitude (EVM) as a figure of merit. An EVM measurement is accomplished for a MB-OFDM over fiber link. The impact of IR-UWB pulse shape on its resistance to the nonlinearity of modulation transfer function is also investigated. [ABSTRACT FROM PUBLISHER]

In this paper, the authors analyze conditions under which they can be certain on the intensity addition of a given device, such as tapped-delay lines, used in digital incoherent all-optical communication systems. A general expression for phase-induced intensity noise that is applicable to all types of semiconductor lasers is derived by defining an optical self-SNR expression that can be used to analyze and measure phase-induced intensity noise. The result shows that in order to have a minimal phase-induced intensity noise in most digital optical incoherent systems, a large optical self-SNR, e.g., 20 dB or more, is needed. This in turn is shown to place a limit on the maximum rate of processing in a typical incoherent optical system even neglecting the bandwidth limitation of the photodetector. Furthermore, it is shown that the maximum rate of processing depends on the laser autocorrelation function and laser coherence time [ABSTRACT FROM PUBLISHER]

Due to the low cardinality of optical orthogonal codes (OOCs) with a correlation value of 1, the capability of an internal channel-coding scheme cannot be applied effectively for an increasing number of simultaneous users in a typical fiber-optic code division multiple-access (FO-CDMA) system. In this paper, we consider applying the internal channel-coding scheme to the framed time-hopping (FTH) FO-CDMA system. Due to the extremely high cardinality of the spreading sequence in FTH FO-CDMA, the technique highlights the ability of the internal channel-coding scheme to increase the effective number of users in an FO-CDMA system. For the FTH FO-CDMA system, we only consider a Poisson noise-limited channel and do not take into account the physical fiber-optic channel impairments. Our simulation and analytical results show that, due to the large cardinality of spreading codes, the capability of the internal channel-coding technique to increase the maximum number of simultaneous users becomes more obvious in the FTH FO-CDMA system. [ABSTRACT FROM PUBLISHER]

In this paper, we consider using practical low-rate error correcting codes in fiber-optic code division multiple-access (CDMA) communication systems. To this end, a different method of low-rate channel coding is proposed. As opposed to the conventional coding schemes, this method does not require any further bandwidth expansion for error correction in fiber-optic CDMA communication systems. The low-rate channel codes that are used for demonstrating the capabilities of the proposed method are super-orthogonal codes. These codes are near optimal and have a relatively low complexity. We evaluate the upper bounds on the bit-error probability of the proposed coded fiber-optic CDMA system assuming both on-off keying and binary pulse position modulation schemes. It is shown that the proposed method significantly outperforms the uncoded systems for various receiver structures such as a correlator with and without hard-limiter and chip-level detector. Furthermore, the performance of the proposed coded fiber-optic CDMA system is also evaluated in the presence of different values of dark current [ABSTRACT FROM PUBLISHER]

We study the performance of optical code-division multiple access (CDMA) systems using various receivers structures. Two general classes of receivers based on required electronic bandwidth are studied. Optical orthogonal codes (OOCs) are utilized as signature sequences and the performance studied in this paper takes into account the effect of all major noise sources, i.e., quantum shot-noise, dark current noise, and Gaussian circuit noise. Furthermore, this paper introduces a generalized method of analyzing the performance of various optical CDMA receiver structures. Required mean number of photon count per chip time for reliable transmission of data bits for various receiver structures is investigated. Finally, the advantages and disadvantages of various receiver structures are discussed [ABSTRACT FROM PUBLISHER]