Search

Neutron-induced uranium fission reactions play an essential role in advanced nuclear energy research, basic and applied nuclear science. Based on the China Spallation Neutron Source (CSNS) Back-streaming white neutron source (Back-n), the measurement of the 236,238U fission cross sections relative to 235U from the threshold to 200 MeV was carried out by using time-of-flight (TOF) method with a multi-cell fast fission ionization chamber in double-bunch mode. The TOF spectra in double-bunch mode were unfolded by using Bayesian method. The fission cross section ratios of 238U/235U and 236U/235U were obtained. The experimental data of the 236,238U/235U fission cross section ratios measured in single-bunch mode were re-analyzed in high energy region and the upper limit was extended to 200 MeV for comparison. The experimental results in double-bunch mode are in good agreement with those in single-bunch mode and the main evaluation data within experimental uncertainties. The 236,238U(n,f) cross sections were obtained from the measured ratios and the standard 235U(n,f) cross sections and they agree well with the theoretical calculation, previous experiments, main evaluations and IAEA NDS. The experimental results can provide technical support for further experimental researches in double-bunch mode and relevant nuclear data evaluations. [ABSTRACT FROM AUTHOR]

The measurement of the relative differential cross sections of the neutron-deuteron ( n - d) elastic scattering, i.e., the 2 H(n, el) 2 H reaction, for 12 neutron energies from 13.56 MeV to 52.48 MeV has been carried out at the Back-n White Neutron Source of the China Spallation Neutron Source (CSNS). By detection of the recoil deuterons using the light charged particle detector array (LPDA) system, the relative differential cross sections of the neutrons in the center-of-mass frame were obtained and then compared with previous measurements, the theoretical calculations performed using the Nijmegen I nucleon-nucleon potential in the Faddeev formalism, and the evaluated from libraries including the ENDF-B/VIII.0, JEFF-3.3, JENDL-4.0, CENDL-3.2, and FENDL-3.2. The present work was the first measurement relative differential cross sections of the n-d scattering for the 30 MeV < E n ≤ 60 MeV neutron energy range using a white neutron source. [ABSTRACT FROM AUTHOR]

Aluminum and its alloys are widely used in the nuclear industry. Therefore, it is essential to precisely measure and accurately know the neutron total cross section of aluminum in the wider energy region. The measurement is performed by using the transmission method at the Back-n White Neutron Source of CSNS. Two aluminum samples 70 mm in diameter and thicknesses of 40 and 60 mm, respectively, were positioned at 55 m from the neutron source. The transmission detector consisted of a multi-layer fast fission chamber loaded with 235 U and 238 U, and it was located at the 76-m measurement station. By applying the time-of-flight technique, it was possible to extract the n+ 27 Al total cross section in a wide energy region, from 1 eV to 20 MeV, after the correction for the double-bunch mode of the CSNS accelerator. The total cross sections obtained with the two Al samples are consistent and the results obtained with the 235 U fission cells are in good agreement with that with 238 U in the energy range of 1–20 MeV. The uncertainty of neutron total cross section measured with 235 U for 40 mm and 60 mm thick aluminum is 0.7–22.3% and 0.6–12.4% in the energy range of 10 keV–20 MeV. Results are in fair agreement with respect to previous data and evaluations. [ABSTRACT FROM AUTHOR]

The obtainment of the neutron multiplicity distribution is the precondition of the neutron coincidence or multiplicity measurement. In related measurements, the calibration of the detector and the optimization of the analysis parameters prefer acquiring the neutron multiplicity distribution through the offline time-correlation analysis of the measured time stamps, while the usual measurement tasks tend to get it online. To meet with the demands of online and offline obtainment of the neutron multiplicity distribution, an online time-correlation analysis method on the basis of list-mode data acquisition technique is proposed in present work. The reliability of the obtained neutron multiplicity distribution is verified through the experiments carried out with a strong and a weak 252Cf neutron sources. [ABSTRACT FROM AUTHOR]

As the light output function of the EJ309 liquid scintillator is nonlinear with respect to the energy of the recoil proton and it is difficult to be predicted, it need to be measured. In the present work, an EJ309 liquid scintillator, 5.1 cm in diameter and 5.1 cm in length, is calibrated with an AmBe neutron source using the time-of-flight method. A Monte Carlo simulation is performed to improve the accuracy of the measured light output function. The obtained light output function is presented and it is compared with existing measurements. The energy resolution of the EJ309 Liquid scintillator is also illustrated. [ABSTRACT FROM AUTHOR]

The original article can be found online at https://doi.org/10.1140/epja/s10050-021-00513-9. J. A (2021) 57:232 https://doi.org/10.1140/epja/s10050-021-00513-9 In the original article the name of the second author was incorrectly written as Yiwei Zhang. [Extracted from the article]

The Back-n white neutron source at the China Spallation Neutron Source (CSNS) was put into operation in 2018, providing a good platform for the cross-section measurement of neutron induced light charged particle (l c p) emission (n , l c p) reactions. Currently, in order to detect and identify light charged particles produced in (n , l c p) reactions at Back-n, a silicon detector array has been developed as a part of Light-charged Particle Detector Array. Composed of 15 silicon detectors, the array can detect the emitted particles ranging from 19.2°to 160.8°. The energy resolution of each silicon detector unit is better than 1% for 5.499 MeV α particles. Adopting this silicon detector array, several experimental measurements have been completed. Differential cross sections and angle-integrated cross sections in the neutron energy region ranging from the eV to the MeV range are extracted. Compared with previous measurements and evaluations, new results are obtained in the present measurements. These experiments indicate the feasibility of the silicon detector array in (n , l c p) reaction cross-section measurements. [ABSTRACT FROM AUTHOR]

China Spallation Neutron Source (CSNS) has been built and commissioned successfully in 2018 which is implemented by impinging 1.6 GeV protons onto a tungsten target with 25 Hz repetition frequency. An associated white neutron beam line exploiting the back-streaming neutrons, named Back-n, with a flight path of 55 m in endstation 1 (#ES1) and 76 m in endstation 2 (#ES2) was built mainly for nuclear data measurements. The Back-n beam line started running since the beginning of 2018 and the neutron energy spectrum was measured at the very beginning since it is an essential information for feasibility study and analysis of any measurement. In this paper, the measurement of the neutron energy spectrum of Back-n #ES2 is reported. The first result of the neutron flux from 1 eV to 100 MeV measured by a fission chamber based on the 235U(n, f) reaction is presented. The total neutron flux normalized to the proton beam power of 100 kW is 7. 03 × 10 6 neutrons/cm2/s. The results show a good agreement with that of the Monte Carlo simulation as well. [ABSTRACT FROM AUTHOR]

The Back-n beam line of the China Spallation Neutron Source is the first white neutron facility in China. One of its goals is to perform radiative neutron capture cross-section (σ nγ) measurements. To study the experimental backgrounds of this new facility, a measurement of the σ nγ of 197Au was carried out with a C 6 D 6 detector system at Back-n. Time-dependent backgrounds induced by the scattered neutrons and in-beam gamma-rays were measured and analyzed with nat C and nat Pb samples. The black resonance filter technique was employed to evaluate the shape of the backgrounds and perform the normalization. Besides, Monte Carlo simulations of these backgrounds were carried out with the Geant4 toolkit. The simulated results were compared with the experimental ones and the good agreement found allowed us to validate the background evaluation method. [ABSTRACT FROM AUTHOR]

The Back-n is a high luminosity white neutron beamline at the China Spallation Neutron Source (CSNS). It started running in 2018 for various nuclear data measurements. A Light charged Particle Detector Array (LPDA) is designed for (n , lcp) reaction experiments, which includes a group of detectors and supporting systems. The Δ E - E telescope, consisting of a Low-Pressure Multi-Wire Proportional Chamber (LPMWPC) and a Si-PIN detector, is the core detector of the LPDA. From the beginning of 2018, several measurements have been performed using the Δ E-E telescopes, and the light charged particles such as 1H, 3H, 4He, and 7Li, were identified successfully. At present, the LPMWPC can identify the protons with energy as low as 0.5 MeV. In the near future, combining with CsI(Tl) crystals, a system consisting of sixteen telescopes with an energy acceptance from 0.5 MeV to 100 MeV (proton) will be constructed for general purpose of (n , lcp) measurements. [ABSTRACT FROM AUTHOR]

• Measured the 238U/235U fission cross section ratio in 1–20 MeV. • The nonuniformity of the neutron beam profile was considered. • Experimental uncertainties of 2.3%–3.6% in 1.4–20 MeV while 4.1%–11% in 1–1.4 MeV. • Provide information and data support in relevant nuclear data evaluation. Based on the China Spallation Neutron Source (CSNS) – Back-streaming white neutron source (Back-n WNS), the measurement of the U-238/U-235 fission cross section ratio in 1–20 MeV neutron energy region has been carried out by a multi-cell fast fission ionization chamber using the time-of-flight method. The measured resonance peaks of the 235U(n, f) reaction are in good agreement with those of the ENDF/B-8.0 database. The measured six groups of the U-238/U-235 fission cross section ratios in 1–20 MeV neutron energy region agree with those of the ENDF/B-8.0 database in trend, and the average discrepancies between experiment and database are from 1.9% to 2.6%. The relative experimental uncertainties are 2.3%–3.6% (1.4–20 MeV), and the measured data agree with those of database within experimental uncertainties at most energy points. The measured U-238/U-235 fission cross section ratio could provide information and data support in relevant nuclear data evaluation. [ABSTRACT FROM AUTHOR]

Combined photon and neutron radiography can integrate merits of X/gamma-ray radiography and energy-selective neutron radiography and has the potential of simultaneously visualizing objects composed of high-Z materials, low-Z materials and particular isotopes that resonantly absorb neutrons at certain energies. Intense pulsed gamma bursts and wide energy spectrum neutrons at spallation sources provide a unique opportunity to perform such combined radiography research. We present the results of the combined radiography experiments performed at the back-streaming white neutron (back-n) beamline at China Spallation Neutron Source (CSNS). Gamma-ray and energy-selective neutron radiographic images of multi-element samples were taken by an ICCD camera coupled with scintillators using the time of flight (TOF) technique. High-Z (Pb, Au, W, Ta, et al.) components were visualized with the intense gamma-ray bursts. The low-Z (10B) component was confirmed with varied image contrast when neutrons with varied energies were selected. The specific elements ( nat In, 197Au and nat W) were identified with neutrons at corresponding resonant energies. The experimental results prove the potential for simultaneously visualizing and identifying high-Z materials, low-Z materials and particular nuclides via combined X-ray radiography and energy-selective neutron radiography. [ABSTRACT FROM AUTHOR]

A white neutron source for nuclear data measurement has been built and put into operation on China Spallation Neutron Source (CSNS). We developeda beam monitor for real-time online monitoring of neutron flux on the white neutron source. The beam monitor work simultaneously with other nuclear data measurement detectors to provide neutron flux for data analysis. To minimize beam disturbance and reduce the background generated by the monitor, a structure in which neutron conversion layer and Si detectors are separated is employed: A 6LiF film with a mass thickness of 360 μ g/cm 2 was deposited on a 10 μ m aluminum foil and placed inside the beam line. Eight Si-detectors with a size of 20 × 20 mm2 were placed around the film outside the beam to maximize the reception of secondary particles from the conversion layer and to avoid neutron beam irradiation. The simulation of the beam monitor (layout, counting rate, neutron disturbance, etc.), construction and online performance are described in the paper. Good online performance of the monitor was achieved during the CSNS white neutron source flux calibration experiment in March, 2018: The counting rate for the beam line operating at Ф30 mm and Ф60 mm beam pattern modes was normalized to 100 kW proton beam power, and the result is consistent with the simulation. The total uncertainty of the normalized counting rate is less than 1%. Moreover, the measurement of neutron flux in low energy region below 10 keV of the white neutron source by the monitor is discussed. [ABSTRACT FROM AUTHOR]