Search

Manufactured nanomaterials (MNMs) are incorporated as "nanofillers" into consumer products to enhance properties of interest. Multiwalled carbon nanotubes (MWCNTs) are known for their unique properties and have many applications in polymers. However, the release of MWCNTs during the nanoenabled product life cycle is concerning. During the use phase, mechanical stresses can produce fragmented materials containing MNMs. The degree of MNM release, the resulting exposure to these materials, and the potential impacts of their release are active research topics. In this study, we describe methodological improvements to study the abrasion of plastics containing MNMs (nanocomposites) and report on characteristics of abrasion products produced and rates of microplastic production. The abrasion device developed for this work allows for the measurement of power inputs to determine scaled release rates. Abrasion rates for plastics used in 3D printing were found to be 0.27 g/m 2 /s for the PETG polymer and 0.3 g/m 2 /s for the 2% MWCNT-PETG nanocomposite. Embedded and protuberant MWCNTs appeared to impact the particle size, shape, hydrophobicity, and surface charge of the microplastics, while the inclusion of MWCNTs had a small effect on microplastic production. Measurements of power input to the abrasion process provided a basis for estimating microplastic production rates for these nanocomposites.

The release of CeO 2 -bearing residues during the weathering of an acrylic stain enriched with CeO 2 nanomaterial designed for wood protection (Nanobyk brand additive) was studied under two different scenarios: (i) a standard 12-weeks weathering protocol in climate chamber, that combined condensation, water spraying and UV-visible irradiation and (ii) an alternative accelerated 2-weeks leaching batch assay relying on the same weathering factors (water and UV), but with a higher intensity of radiation and immersion phases. Similar Ce released amounts were evidenced for both scenarios following two phases: one related to the removal of loosely bound material with a relatively limited release, and the other resulting from the degradation of the stain, where major release occurred. A non-linear evolution of the release with the UV dose was evidenced for the second phase. No stabilization of Ce emissions was reached at the end of the experiments. The two weathering tests led to different estimates of long-term Ce releases, and different degradations of the stain. Finally, the photo-degradations of the nanocomposite, the pure acrylic stains and the Nanobyk additive were compared. The incorporation of Nanobyk into the acrylic matrix significantly modified the response of the acrylic stain to weathering., (Copyright © 2018 Elsevier Ltd. All rights reserved.)

The inherent properties of hydrophilicity and mechanical strength of cellulose nanocrystals (CNCs) make them a possible alternative to carbon nanotubes (CNTs) that may present fewer objections to application water-treatment membranes. In this work, the hydrophilicity and mechanical properties of CNCs and CNTs nanocomposite poly(ether sulfone) (PES) membranes were characterized and compared. Membrane pore geometry was analyzed by scanning electron microscopy (SEM). Overall porosity and mean pore radius were calculated based on a wet-dry method. Results showed that PES polymers were loosely packed in the top layer of both the CNC- and CNT-composite membranes (CNC-M and CNT-M). The porosity of the CNC-M was greater than that of the CNT-M. Membrane hydrophilicity, measured by water-contact angle, free energy of cohesion, and water flux, was increased through the addition of either CNCs or functionalized CNTs to an otherwise hydrophobic polymer membrane. The hydrophilicity of the CNC-M was greater than the CNT-M. In addition, the Young's modulus and tensile strength was enhanced for both the CNC-M and CNT-M. While smaller concentrations of CNTs were required to achieve an equal increase in Young's modulus compared with the CNCs, the elasticity of the CNC-composite membranes was greater.