Search

The PETROTOX model was developed to perform aquatic hazard assessment of petroleum substances based on substance composition. The model relies on the hydrocarbon block method, which is widely used for conducting petroleum substance risk assessments providing further justification for evaluating model performance. Previous work described this model and provided a preliminary calibration and validation using acute toxicity data for limited petroleum substance. The objective of the present study was to re-evaluate PETROTOX using expanded data covering both acute and chronic toxicity endpoints on invertebrates, algae, and fish for a wider range of petroleum substances. The results indicated that recalibration of 2 model parameters was required, namely, the algal critical target lipid body burden and the log octanol-water partition coefficient (K OW ) limit, used to account for reduced bioavailability of hydrophobic constituents. Acute predictions from the updated model were compared with observed toxicity data and found to generally be within a factor of 3 for algae and invertebrates but overestimated fish toxicity. Chronic predictions were generally within a factor of 5 of empirical data. Furthermore, PETROTOX predicted acute and chronic hazard classifications that were consistent or conservative in 93 and 84% of comparisons, respectively. The PETROTOX model is considered suitable for the purpose of characterizing petroleum substance hazard in substance classification and risk assessments. Environ Toxicol Chem 2017;36:2245-2252. © 2017 SETAC., (© 2017 SETAC.)

Substance risk assessments require estimation of predicted no-effect concentrations (PNECs) in soil and sediment. The present study applies the target lipid model (TLM) and equilibrium partitioning (EqP) model to toxicity data to evaluate the extrapolation of the TLM-derived aquatic PNECs to these compartments. This extrapolation assumes that the sensitivity of aquatic species is similar to that of terrestrial and benthic species. The acute species sensitivity distribution, expressed in terms of species-specific critical target lipid body burdens, was computed using the TLM-EqP framework and found to span a similar range as the aquatic organism species sensitivity distribution but with a slightly lower median value (less than 2 times). The species sensitivity distribution for acute-to-chronic ratios also exhibited a similar range and distribution across species, suggesting similar mechanisms of action. This hypothesis was further tested by comparing empirical soil/sediment chronic effect levels to the calculated PNEC derived using TLM-EqP. The results showed that 95% of the compiled chronic effects data fell above the PNEC, confirming an adequate protection level. These findings support the conclusion that TLM-derived aquatic PNECs can be successfully extrapolated to derive credible PNECs for soil and sediment compartments., (© 2014 SETAC.)

PETRORISK is a modeling framework used to evaluate environmental risk of petroleum substances and human exposure through these routes due to emissions under typical use conditions as required by the European regulation for the Registration, Evaluation, Authorization and Restriction of Chemicals (REACH). Petroleum substances are often complex substances comprised of hundreds to thousands of individual hydrocarbons. The physicochemical, fate, and effects properties of the individual constituents within a petroleum substance can vary over several orders of magnitude, complicating risk assessment. PETRORISK combines the risk assessment strategies used on single chemicals with the hydrocarbon block approach to model complex substances. Blocks are usually defined by available analytical characterization data on substances that are expressed in terms of mass fractions for different structural chemical classes that are specified as a function of C number or boiling point range. The physicochemical and degradation properties of the blocks are determined by the properties of representative constituents in that block. Emissions and predicted exposure concentrations (PEC) are then modeled using mass-weighted individual representative constituents. Overall risk for various environmental compartments at the regional and local level is evaluated by comparing the PECs for individual representative constituents to corresponding predicted no-effect concentrations (PNEC) derived using the Target Lipid Model. Risks to human health are evaluated using the overall predicted human dose resulting from multimedia environmental exposure to a substance-specific derived no-effect level (DNEL). A case study is provided to illustrate how this modeling approach has been applied to assess the risks of kerosene manufacture and use as a fuel., (© 2014 SETAC.)