Search

The battery State of Charge (SoC) is critical information to overcome agricultural robots' limitations related to battery and energy management. Although several SoC estimation methods have been proposed in the literature, the performance of these methods has not been validated for different battery chemistries in agricultural mobile robot applications. Compared to previous work, this paper evaluates the limits of the SoC estimation using the RC model and the Thevenin model for a Lithium Iron Phosphate (LFP) battery and a Sealed Lead Acid (SLA) battery. This evaluation used a custom agricultural robot in a controlled indoor environment. Consequently, this work assessed the limitations of two ECM-based SoC estimation methods using battery packs, low-cost sensors and discharge cycles typically used in agricultural robot applications. Finally, the results indicate that the RC model is not suitable for SoC estimation for LFP battery; however, it achieved a mean absolute error (MAE) of 2.2% for the SLA battery. On the other hand, the Thevenin model performed properly for both chemistries, achieving MAE lower than 1%. [ABSTRACT FROM AUTHOR]

Powertrain electrification in the agricultural vehicles is still in the initial stages. This article analyzes the energy behavior of a Photovoltaic/Fuel Cell Agricultural Mobile Robot (PV/FCAMR) as the preliminary step before development. This concept incorporates three energy storage sources for the powertrain: a battery pack, a Fuel Cell (FC) system, and a Photovoltaic (PV) system. This paper proposes an approach based on the Grey Wolf Optimization (GWO) and Particle Swarm Optimization (PSO) algorithms to determine the sizes of the FC and battery of an FCAMR. A differential drive mobile robot was used as a case study to extract the typical working cycles of farming applications. The FCAMR vehicle model was developed in MATLAB/Simulink to evaluate vehicle energy consumption and performance. For the energy analysis and evaluation, the FCAMR was tested based on two realistic working cycles comprising circular and rectangular moving patterns. The results showed that the proposed arrangement could extend the FCAMR autonomy by 350% as opposed to the pure electric system. This allows for at least 8 h of work with a tank filled with 150 g hydrogen and a PV system with a 0.5 m 2 monocrystalline solar panel. The simulation results have demonstrated the relevance and robustness of this approach in relation to various working cycles. The cost comparison between the theoretical and optimization sizing methods showed at least an 8% decrease for the FCAMR. Furthermore, adding the PV system extended the vehicle's range by up to 5%. This study provides an optimal solution for energy sources sizing of mobile robots as futuristic agricultural vehicles. [ABSTRACT FROM AUTHOR]