Search

Flucloxacillin is prescribed to treat skin infections but its highly bitter taste is poorly tolerated in children. This work describes the application of the D-optimal mixture experimental design to identify the optimal component ratio of flucloxacillin, Eudragit EPO and palmitic acid to prepare flucloxacillin taste-masked microparticles that would be stable to storage and would inhibit flucloxacillin release in the oral cavity while facilitating the total release of the flucloxacillin load in the lower gastrointestinal tract (GIT). The model predicted ratio was found to be very close to the stoichiometric equimolar component ratio, which supported our hypothesis that the ionic interactions among flucloxacillin, Eudragit EPO and palmitic acid underscore the polyelectrolyte complex formation in the flucloxacillin taste-masked microparticles. The excipient–drug interactions showed protective effects on the microparticle storage stability and minimised flucloxacillin release at 2 min in dissolution medium. These interactions had less influence on flucloxacillin release in the dissolution medium at 60 min. Storage temperature and relative humidity significantly affected the chemical stability of the microparticles. At the preferred storage conditions of ambient temperature under reduced RH of 23%, over 90% of the baseline drug load was retained in the microparticles at 12 months of storage. [ABSTRACT FROM AUTHOR]

It is extremely challenging to formulate age-appropriate flucloxacillin medicines for young children, because flucloxacillin sodium (FS) has a lingering, highly bitter taste, dissolves quickly in saliva, and requires multiple daily dosing at relatively large doses for treating skin infections. In this paper, we describe a promising taste-masked flucloxacillin ternary microparticle (FTM) formulation comprising FS, Eudragit EPO (EE), and palmitic acid (PA). To preserve the stability of the thermolabile and readily hydrolysed flucloxacillin, the fabrication process employed a non-aqueous solvent evaporation method at ambient temperature. Optimisation of the fabrication method using a mixture design approach resulted in a robust technique that generated stable and reproducible FTM products. The optimised method utilised only a single solvent evaporation step and minimal amounts of ICH class III solvents. It involved mixing two solution phases—FS dissolved in ethanol:acetone (1:4 v/v), and a combination of EE and PA dissolved in 100% ethanol—to give a ternary FS:EE:PA system in ethanol: acetone (3:1 v/v). Solvent evaporation yielded the FTMs containing an equimolar ratio of FS:EE:PA (1:0.8:0.6 w/w). The fabrication process, after optimisation, demonstrated robustness, reproducibility, and potential scalability. [ABSTRACT FROM AUTHOR]