Search

This work demonstrates how to enhance contact damage resistance of alumina‐based ceramics combining tailored microstructures in a multilayer architecture. The multilayer system designed with textured alumina layers under compressive residual stresses embedded between alumina–zirconia layers was investigated under Hertzian contact loading and compared to the corresponding monolithic reference materials. Critical forces for crack initiation under spherical contact were detected through an acoustic emission system. Damage was assessed by combining cross‐section polishing and ion‐slicing techniques. It was found that a textured microstructure can accommodate the damage below the surface by shear‐driven, quasi‐plastic deformation instead of the classical Hertzian cone cracking observed in equiaxed alumina. In the multilayer system, a combination of both mechanisms, namely Hertzian cone cracking on the top (equiaxed) surface layer and quasi‐plastic deformation within the embedded textured layer, was identified. Further propagation of cone cracks at higher loads was hindered and/or deflected owed to the combined action of the textured microstructure and compressive residual stresses. These findings demonstrate the potential of embedding textured layers as a strategy to enhance the contact damage tolerance in alumina ceramics. [ABSTRACT FROM AUTHOR]

Fabrication of 3D-printed ceramic parts with high complexity and high spatial resolution often demands low wall thickness as well as high stiffness at the green state, whereas printing simpler geometries may tolerate thicker, more compliant walls with the advantage of a rapid binder-burn-out and sintering process. In this work, the influence of the binder system on the thermophysical properties of 3D-printed stabilized zirconia ceramics was investigated. Samples were fabricated with the lithography- based ceramic manufacturing (LCM) technology using two different photosensitive ceramic suspensions (LithaCon 3Y230 and LithaCon 3Y210), with the same ZrO2 powder. A significant difference in stiffness in the green state (~3 MPa vs. ~32 MPa for LithaCon 3Y230 and LithaCon 3Y210, respectively) was measured, associated with a rather loose or a linked network formed in the binder due to photopolymerization. Both materials reached high relative densities, that is, >99%, exhibiting a homogeneous fine-grained microstructure. No significant differences on the coefficient of thermal expansion (11.18 ppm/K vs. 11.17 ppm/K) or Young's modulus (207 GPa vs. 205 GPa) were measured, thus demonstrating the potential of tailoring binder systems to achieve the required accuracy in 3D-printed parts, without detrimental effects on material's microstructure and thermophysical properties at the sintered state. [ABSTRACT FROM AUTHOR]

Mimicking the damage tolerance of biological materials such as nacre has been realised in textured layered alumina ceramics, showing improved reliability as well as fracture resistance at room temperature. In this work, the fracture behaviour of alumina ceramics with textured microstructure and laminates with embedded textured layers are investigated under uniaxial bending tests at elevated temperatures (up to 1200 °C). At temperatures higher than 800 °C monolithic textured alumina favours crack deflection along the basal grain boundaries, corresponding to the transition from brittle to more ductile behaviour. In the case of laminates, the loss of compressive residual stresses is counterbalanced by the textured microstructure, effective up to 1200 °C. This study demonstrates the potential of tailoring microstructure and architecture in ceramics to enhance damage tolerance within a wide range of temperatures. [ABSTRACT FROM AUTHOR]