Search

When properly designed, pretreatments may enhance the methane potential and/or anaerobic digestion rate, improving digester performance. This paper aims at providing some guidelines on the most appropriate pretreatments for the main feedstocks of biogas plants. Waste activated sludge was firstly investigated and implemented at full-scale, its thermal pretreatment with steam explosion being most recommended as it increases the methane potential and digestion rate, ensures sludge sanitation and the heat needed is produced on-site. Regarding fatty residues, saponification is preferred for enhancing their solubilisation and bioavailability. In the case of animal by-products, this pretreatment can be optimised to ensure sterilisation, solubilisation and to reduce inhibition linked to long chain fatty acids. With regards to lignocellulosic biomass, the first goal should be delignification, followed by hemicellulose and cellulose hydrolysis, alkali or biological (fungi) pretreatments being most promising. As far as microalgae are concerned, thermal pretreatment seems the most promising technique so far., (Copyright © 2015 Elsevier Ltd. All rights reserved.)

The present study focused on the application of the Anaerobic Digestion Model 1 on the methane production from acidified sorghum extract generated from a hydrogen producing bioreactor in a two-stage anaerobic process. The kinetic parameters for hydrogen and volatile fatty acids consumption were estimated through fitting of the model equations to the data obtained from batch experiments. The simulation of the continuous reactor performance at all HRTs tested (20, 15, and 10d) was very satisfactory. Specifically, the largest deviation of the theoretical predictions against the experimental data was 12% for the methane production rate at the HRT of 20d while the deviation values for the 15 and 10d HRT were 1.9% and 1.1%, respectively. The model predictions regarding pH, methane percentage in the gas phase and COD removal were in very good agreement with the experimental data with a deviation less than 5% for all steady states. Therefore, the ADM1 is a valuable tool for process design in the case of a two-stage anaerobic process as well., (Copyright © 2011 Elsevier Ltd. All rights reserved.)

This study focuses on the exploitation of cheese whey as a source for hydrogen and methane, in a two-stage continuous process. Mesophilic fermentative hydrogen production from undiluted cheese whey was investigated at a hydraulic retention time (HRT) of 24 h. Alkalinity addition (NaHCO(3)) or an automatic pH controller were used, to maintain the pH culture at a constant value of 5.2. The hydrogen production rate was 2.9+/-0.2 L/Lreactor/d, while the yield of hydrogen produced was approximately 0.78+/-0.05 mol H(2)/mol glucose consumed, with alkalinity addition, while the respective values when using pH control were 1.9+/-0.1 L/Lreactor/d and 0.61+/-0.04 mol H(2)/mol glucose consumed. The corresponding yields of hydrogen produced were 2.9 L of H(2)/L cheese whey and 1.9 L of H(2)/L cheese whey, respectively. The effluent from the hydrogenogenic reactor was further digested to biogas in a continuous mesophilic anaerobic bioreactor. The anaerobic digester was operated at an HRT of 20 d and produced approximately 1L CH(4)/d, corresponding to a yield of 6.7 L CH(4)/L of influent. The chemical oxygen demand (COD) elimination reached 95.3% demonstrating that cheese whey could be efficiently used for hydrogen and methane production, in a two-stage process.

In this study fungal pretreatment of willow sawdust (WSD) via the white rot fungi Leiotrametes menziesii and Abortiporus biennis was studied and the effect on fractionation of lignocellulosic biomass and biochemical methane potential (BMP), was evaluated. Scanning electron microscopy (SEM) and IR spectroscopy were used to investigate the changes in the structural characteristics of the pretreated WSD. Fungal pretreatment results revealed that A. biennis is more attractive, since it resulted in higher lignin degradation and lower holocellulose uptake. Samples of the 14th and 30th d of cultivation (i.e. the middle and the end of the pretreatment experiment) with both fungi were used for BMP tests and the effect of pretreatment duration was also evaluated. BMP increase by 31 and 43% was obtained due to the cultivation of WSD with A. biennis , for 14 and 30 d, respectively. In addition, combination of biological (after 30 d of cultivation) with alkaline (NaOH 20 g/100 gTS) pretreatment was performed, in order to assess the effect of the chemical agent on biologically pretreated WSD, in terms of lignocellulosic content and BMP. Combination of alkaline with fungal pretreatment led to high lignin degradation for both fungi, while the cellulose and hemicellulose removal efficiencies were higher for combined alkaline and L. menziesii pretreatment. The maximum BMP was observed for the combined alkaline and A. biennis pretreatment and was 12.5 and 50.1% higher than the respective alkaline and fungal pretreatment alone and 115% higher than the respective BMP of raw WSD. [ABSTRACT FROM AUTHOR]

In this study the effect of nitrogen (N) supplementation in the fungal pretreatment of willow sawdust (WSD) via the white rot fungus Abortiporus biennis (A. biennis) was studied in terms of the fractionation of lignocellulosic biomass and biochemical methane potential (BMP). Thus, different external nitrogen sources (yeast extract (YE), urea (UR), and ammonium nitrate (AN)) at different ratios (N/C of 1/250 and 1/50) were added and the effect of the above parameters on the chemical composition of WSD during solid-state fermentation (SSF) experiments with A. biennis was assessed and compared to the experiment of fungal pretreatment without N supplementation (N/C was 1/500, control experiment). The results indicated that the addition of an external nitrogen source did not facilitate delignification, regardless of the type of nitrogen source and the ratio of N/C used. On the other hand, enhanced cellulose uptake was observed. Samples of the 28th day of cultivation, with and without N supplementation, were used for BMP tests, where a reduction in methane yield was observed, compared to the control experiment. In addition, a combination of fungal with alkali (20% NaOH w/w dry mass) pretreatment was performed in order to assess the effect of combined pretreatment on the lignocellulosic content and the BMP. [ABSTRACT FROM AUTHOR]

Abstract: The present study focuses on the exploitation of sweet sorghum biomass as a source for hydrogen and methane. Fermentative hydrogen production from the sugars of sweet sorghum extract was investigated at different hydraulic retention times (HRT). The subsequent methane production from the effluent of the hydrogenogenic process and the methane potential of the remaining solids after the extraction process were assessed as well. The highest hydrogen production rate (2550ml H2/d) was obtained at the HRT of 6h while the highest yield of hydrogen produced per kg of sorghum biomass was achieved at the HRT of 12h (10.4l H2/kg sweet sorghum). It has been proved that the effluent from the hydrogenogenic reactor is an ideal substrate for methane production with approximately 29l CH4/kg of sweet sorghum. Anaerobic digestion of the solid residues after the extraction process yielded 78l CH4/kg of sweet sorghum. This work demonstrated that biohydrogen production can be very efficiently coupled with a subsequent step of methane production and that sweet sorghum could be an ideal substrate for a combined gaseous biofuels production. [Copyright &y& Elsevier]

The effect of liquid hot water (LHW) pretreatment with or without acid addition (A-LHW) on the production of hydrogen—through dark fermentation (DF)—and methane—through anaerobic digestion (AD)—using three different lignocellulosic biomass types (sunflower straw (SS), grass lawn (GL), and poplar sawdust (PS)) was investigated. Both pretreatment methods led to hemicellulose degradation, but A-LHW resulted in the release of more potential inhibitors (furans and acids) than the LHW pretreatment. Biological hydrogen production (BHP) of the cellulose-rich solid fractions obtained after LHW and A-LHW pretreatment was enhanced compared to the untreated substrates. Due to the release of inhibitory compounds, LHW pretreatment led to higher biochemical methane potential (BMP) than A-LHW pretreatment when both separated fractions (liquid and solid) obtained after pretreatments were used for AD. The recovered energy in the form of methane with LHW pretreatment was 8.4, 12.5, and 7.5 MJ/kg total solids (TS) for SS, GL, and PS, respectively. [ABSTRACT FROM AUTHOR]

In the present study the bioconversion of dried household food waste (FORBI) to energy carriers was investigated aiming to its sustainable management and valorization. FORBI was either directly fermented towards ethanol and hydrogen or was previously subjected to extraction with water resulting to a liquid fraction (extract) rich in sugars and a solid residue, which were then fermented separately. Subsequently, the effluents were assessed as substrates for methane production via anaerobic digestion (AD). Mono-cultures and co-cultures of C5 and C6 yeasts were used for the alcoholic fermentation whereas for the production of hydrogen, mixed acidogenic consortia were used. Taking into account the optimum yields of biofuels, the amount of recoverable energy was estimated based for each different approach. The maximum ethanol yield was 0.16 g ethanol per kg of FORBI and it was achieved for separate fermentation of liquid and solid fractions of the waste. The highest hydrogen yield that was observed was 210.44 L ± 4.02 H 2 /kg TS FORBI for 1% solids loading and supplementation with cellulolytic enzymes. Direct AD of either the whole FORBI or its individual fractions led to lower overall energy recovery, compared to that obtained when fermentation and subsequent AD were applied. The recoverable energy was estimated for the different exploitation approaches of the waste. The maximum achieved recoverable energy was 21.49 ± 0.57 MJ/kg. Unlabelled Image • FORBI (food waste) was bio converted to H 2 , ethanol and methane in 2 stage systems. • Water extraction for separate fermentation of sugars/solids enhanced ethanol yield. • Extraction process did not affect final hydrogen yields. • Energy gain was higher from 2 stage approach than direct AD of FORBI or fractions. [ABSTRACT FROM AUTHOR]

[Display omitted] • Simultaneous ammonia mitigation and biogas upgrading using an integrated BES was accomplished. • Ammonia utilization and hydrogen production reached 73.67% and 202.87 mL under an applied voltage 0.4 V. • The highest methane production and content were attained with in situ H 2 injection at the beginning. • Both microbial communities and enzymatic abundances related to methanogenesis were amplified. Biohydrogen using migrated ammonia as nitrogen source, and biogas upgrading with hydrogen collected at biocathode in an integrated bioelectrochemical system (BES) were investigated, during the anaerobic digestion of Taihu blue algae. Under an applied voltage of 0.4 V, biohydrogen (202.87 mL) reached 2.34 and 2.90 times than groups with applied voltage of 0 V and 0.8 V, respectively. Moreover, biohydrogen of the group with 1000 mg/L initial ammonia addition (524.16 mL) reached 1.53 times than that the of the control. With 0.25 bar of H 2 injected at the beginning (R1), highest methane production (286.62) mL and content (75.73%) were obtained. Comparing to other groups, not only microbial genus responsible for both aceticlastic and hydrogenotrophic methanogens of the group R1 were apparently enriched, but key enzymes related to methane production also acquired better abundances. Therefore, it's promising to conduct the ammonia alleviating, hydrogen producing and biogas upgrading simultaneously using BES. [ABSTRACT FROM AUTHOR]